Preview

Experiment on Photocromism and Piezochromism

Better Essays
Open Document
Open Document
1362 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Experiment on Photocromism and Piezochromism
Experiment B10- Photocromism and Piezochromism

Reece Harms 4320288

Introduction

This experiment investigates an oxidative coupling reaction in an to synthesise triphenylimidazole dimer from 2,4,5-triphenyl-1H-imidazole. The resulting compound was investigated for both photochromic and piezochromic properties by way of formation of a stable radical, utilizing visual observations and UV-Vis as a means of distinction. Both the oxidative coupling reaction and the dimers interaction with light are depicted in the reactions in figure 1.

Figure 1: Oxidative Coupling reaction of 2,4,5-triphenyl-1H-imidazol

Experimental

Ethanol (100ml), potassium hydroxide (8.065g, 2.568mmol) and water (5ml) were added in order to 2,4,5-triphenyl-1H-imidazol (0.9402g, 3.17mmol). The mixture was stirred until clear before it was cooled to 5 ºC. A solution of potassium ferricyanide (3.0021 g, 9.085mmol), water (250ml) and ethanol (100ml) was prepared and added dropwise into the mixture ensuring the temperature did not rise above 10 ºC. A grey precipitate was isolated from the yellow mixture through vacuum filtration and washed with water (50ml x 5) and 50% aqueous ethanol. The mixture was dried under vaccuum suction and the melting point was determined. Yield: 0.85g, 90.8% m.p-199.8-200.3ºC. A portion of the dimer (0.0305 g, 0.0514mmol) was quantitatively dissolved in 25ml of toluene. The solution was left for 60min until colorless. The UV-Vis spectra was recorded for the colorless sample. The solution was irradiated using a lamp resulting in a purple solution and the UV-Vis spectrum was retaken. UV (): 524.92nm ε colourless (45.2M-1cm-1) coloured (760M-1cm-1) 1H NMR (300MHz, CDCl3) δ 7.26 (30H, m) 13C NMR DEPT (75MHz, CDCl3) δ 166.5, 149.0, 138.11, 137.9, 134.4, 134.4, 132.7, 132.01-126.13, 112.38.

Results and Discussion
The triphenylimidazole dimer that was synthesized displayed a melting range of 199.8-200.3 ºC which is higher than the literature value of



References: [1] White, D. M., Sonnenberg, J., J.Amer. Chem. Soc., 1966, 88, 3825 [2] McCray, J. A., & Trentham, D. R. (1989). Properties and uses of photoreactive caged compounds. Annual review of biophysics and biophysical chemistry,18(1), 239-270. [3] Song, K., Kuzmany, H., Wallraff, G. M., Miller, R. D., & Rabolt, J. F. (1990). Spectroscopic characterization of piezochromism in poly (alkylsilanes): poly (di-n-hexylsilane). Macromolecules, 23(16), 3870-3872.

You May Also Find These Documents Helpful

  • Powerful Essays

    The degrees of unsaturation formula, Eq. 1, was applied, and the molecule was found to have 4 degrees of unsaturation. : [(2 + 2(9) – 12)/2] = 4. It was noted that this is highly suggestive of a benzene ring, so the IR spectroscopy was analyzed for the presence of a benzene ring functional group. Aromatic benzene rings typically show IR peaks in the 1400-1500 and 3000-3100 cm-1 range. The signals seen on the IR of the unknown at 1454 and 3028 cm-1 range confirm the presence of an aromatic ring. Further analysis of the IR shows the presence of an OH functional group at 3339; OH functional groups typically appear at 3200-3500 cm-1 on IR. Notably absent on the IR are signals that would suggest double or triple bonds, see Table…

    • 2096 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Grignard Reaction Lab

    • 1231 Words
    • 5 Pages

    In this laboratory, triphenylmethanol was synthesised from reacting benzophenone and bromobenzene using Grignard reaction. As the reaction was to set up to produce a Grignard reagent and then recrystallize it to obtain pure sample. The percentage yield obtained was 55% and its melting point was 161 co which is within the literature value 160-163 co. In addition to that the IR spectroscopy confirmed the molecule structure to be triphenylmethanol.…

    • 1231 Words
    • 5 Pages
    Good Essays
  • Better Essays

    The purpose of this experiment was to synthesize the Grignard reagent, phenyl magnesium bromide, and then use the manufactured Grignard reagent to synthesize the alcohol, triphenylmethanol, by reacting with benzophenone and protonation by H3O+. The triphenylmethanol was purified by recrystallization. The melting point, Infrared Spectroscopy, 13C NMR, and 1H NMR were used to characterize and confirm the recrystallized substance was triphenylmethanol.…

    • 5143 Words
    • 21 Pages
    Better Essays
  • Satisfactory Essays

    What Is Compound 50?

    • 253 Words
    • 2 Pages

    Unlike all others representative compounds studied here, hydrazone 51 has its stereochemistry controlled by intramolecular interactions instead of steric factors. Despite isatin’s lack of steric requirements around its carbonyl functionality, its hydrazone derivatives exist only as Z-isomers because of the formation of an intramolecular hydrogen bond between de (–NH–) group of the acyclic chain and the oxygen of the isatin’s (–NHCO–)…

    • 253 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Light Reaction Lab

    • 477 Words
    • 2 Pages

    This lab explores the effect of light intensity and light wavelength on photosynthesis. The quantity of energy [ATP] produced will change depending upon on these parameters.…

    • 477 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Grignard Reaction Lab Report

    • 2774 Words
    • 12 Pages

    Through the use of the Grignard reaction, a carbon-carbon bond was formed, thereby resulting in the formation of triphenylmethanol from phenyl magnesium bromide and benzophenone. A recrystallization was performed to purify the Grignard product by dissolving the product in methanol. From here, a melting point range of 147.0 °C to 150.8 °C was obtained. The purified product yielded an IR spectrum with major peaks of 3471.82 cm-1, 3060.90 cm-1, 1597.38 cm-1, and 1489.64 cm-1, which helped to testify whether the identity of the product matched the expected triphenylmethanol. The identity of the product being correct was further confirmed by way of both proton and carbon-13 NMR spectra. This is due to the fact that both spectra yielded peaks that contained the main structural residues, alcohol and aromatic groups, of triphenylmethanol. The final yield of pure triphenylmethanol was 8.04 grams, resulting in a percentage recovery of 67.7%.…

    • 2774 Words
    • 12 Pages
    Powerful Essays
  • Good Essays

    In this experiment Benzpinacolone was synthesized in a process that contained two steps. First the photoreduction of benzophenone in 2-propanol, which was done by placing the flask under sunlightfor the absorption of the UV rays to carry out the reaction. Then the second part was the dehydration of benzpinacol to benzpinacolone, where the benzpinacol product was converted to a ketone by the acid catalyzed rearrangement of the benzpinacol to the benzpinacolone; this was done by adding iodine and acetic acid to benzpinacol. The reaction was then refluxed, cooled in an ice bath, filtered and washed with ethanol. After allowing the benzpinacolone to dry, we found that our percent yield was 71% .Even though the yield was good, considering that the photoreduction period took a couple extra days due to lack of sunlight, loss of product can be attributed to this since we only could get 2.11g/3.0g of benzpinacol from the start of the lab. And since benzpinacol was the limiting reagent, before starting part 2 of the lab this already set us up for some loss in % yield. Also when we transferred our product from the filtration funnel to the watch glass there was product loss because many of the crystals were stuck in the flask and could not be removed to get an accurate weight. The observed melting point of the product was 164-165°C which is a little lower than the theoretical mp value; this can be attributed to impurities in our product. An IR spectrum was given and analyzed for benzophenone. 1H NMR, 13C NMR, and IR spectrums were also given for benzpinacol and benzpinacolone and the peaks were analyzed for the purpose of recognizing functional groups and noting any similarities and differences between the compounds that were made.…

    • 2059 Words
    • 9 Pages
    Good Essays
  • Powerful Essays

    (5) "IR Spectroscopy Tutorial." Organic Chemistry at CU Boulder. N.p., n.d. Web. 3 May 2013. <http://orgchem.colorado.edu/Spectroscopy/irtutor/tutorial.html>.…

    • 2653 Words
    • 11 Pages
    Powerful Essays
  • Powerful Essays

    Abstract A technique for the Diels-Alder synthesis of endo-norbornene-cis-5,6dicarboxylic anhydride and its stereoisomer, exo-norbornene-cis-5,6-dicarboxylic anhydride, is explained. To prove that each stereoisomer was made in the experiment and to distinguish between the two molecules, the characteristic long range coupling affects seen in the H1-NMR spectra of bridged six member ring molecules are used. A method for the separation of the two molecules is also explained. This technique can be used as a tool to instruct organic chemistry students in the Diels-Alder reaction and how to use NMR techniques to prove the stereochemistry of the products involved in such reactions. Introduction The Diels-Alder reaction has long been an important tool for the organic chemist in that it not only creates new carbon-carbon bonds, but it also creates six-membered rings1. This attribute of the Diels-Alder reaction is especially valuable, because there are few synthetic methods of creating six-membered ring structures. The process of a DielsAlder reaction involves a substituted alkene reacting with a conjugated diene in the cis conformation to create two new carbon-carbon σ bonds which results in the formation of a six-membered ring, as shown below: Figure 1: Example Diels-Alder reaction…

    • 2591 Words
    • 11 Pages
    Powerful Essays
  • Best Essays

    The grant dialoges

    • 1729 Words
    • 7 Pages

    Bibliography: Anonymous. “Coloration Technology; Scientists at Aristotle University Target ColorationTechnoligy.” Chemicals & Chemistry (Apr. 2011): 2852. ProQuest AP Science. Web. 7 Sept. 2011.…

    • 1729 Words
    • 7 Pages
    Best Essays
  • Better Essays

    Grignard Reaction

    • 1125 Words
    • 5 Pages

    This experiment explores the use of organometallic reagents in addition reactions. Organometallic compounds have a carbon-metal bond, such as a carbon-magnesium or carbon-lithium bond. Transition metals can also be used such as rhodium or iridium. Organometallic compounds have a wide range of uses, including being consumed as a reagent and acting as a catalyst.…

    • 1125 Words
    • 5 Pages
    Better Essays
  • Better Essays

    Synthesis of Acetaminophen

    • 1244 Words
    • 5 Pages

    5. Stathopulos, S. Department of Chemistry 2013 First Year Chemistry (CHEM 123L) Laboratory Manual; University of Waterloo: Waterloo, ON, 2013; pp. 12-15.…

    • 1244 Words
    • 5 Pages
    Better Essays
  • Satisfactory Essays

    In 1998, novel isocyanide-based MCRs were de-scribed by Blackburn,14 Bienaymé,15 and Groeb-ke16 which involve the reaction between a 2-aminoazine, an aldehyde, and an isocyanide in the presence of a catalyst such as Sc(OTf)3,14 perchlo-ric acid15 or glacial acetic acid.16 These methods led to simple construction of imidazo[1,2-a]azines but required long reaction times and the work-ups were complicated. In addition, imidazo[1,2-a]azine syntheses have been carried out under microwave irradiation in the presence of montmorillonite K10,17 Sc(OTf)3,18 nonpolar solvent,19 and ionic liquid.20 Improved conditions have also been re-ported in recent…

    • 89 Words
    • 1 Page
    Satisfactory Essays
  • Powerful Essays

    • [Slaa, J., Gnode, M., and Else, H, 2009, Journal of Organic Chemistry [pdf]. , The Netherlands: Vrije Universiteit, Amsterdam. Received October 2009. Available at http://www.pieternieuwland.nl/Menu_Items/Projecten/Symposium/symposium2009-2010/organisatie/docs/Article%20Yeast%20and%20fermentation.pdf [accessed 14:20, 11.11.2012]]…

    • 1723 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    First, three complementary techniques are performed to characterize the crystalline and amorphous form of indomethacin. These techniques include IR spectroscopy, Raman spectroscopy and differential scanning calorimetry.…

    • 872 Words
    • 4 Pages
    Good Essays