"Gas turbine" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 7 of 50 - About 500 Essays
  • Satisfactory Essays

    THE FUTURE OF GAS TURBINE TECHNOLOGY 6TH INTERNATIONAL GAS TURBINE CONFERENCE 17-18 October 2012 • Brussels‚ Belgium www.etn-gasturbine.eu OUR SPONSORS GOLD SPONSOR SILVER SPONSORS SPECIAL THANKS TO CONFERENCE EXHIBITORS MEDIA PARTNERS GAS TURBINE TECHNOLOGY COOPERATING SOCIETIES AND PROJECTS WELCOME of gas turbine technology will face‚ as well as promising gas turbine developments. The key topics to be addressed are: THE FUTURE OF GAS TURBINE TECHNOLOGY Dear IGTC-12

    Premium Gas turbine

    • 5058 Words
    • 21 Pages
    Satisfactory Essays
  • Satisfactory Essays

    reheat-regenerative Rankine cycle. At the inlet of the high pressure turbine‚ the steam pressure and temperature are 10 MPa and 550oC respectively. The steam leaves the high pressure turbine at 0.8 MPa. Some of the steam leaving the high pressure turbine is extracted and supplied to an open feedwater heater‚ while the rest is reheated to 500oC. The reheated steam is expanded in the low-pressure turbine. The steam leaves the low-pressure turbine at 10 kPa. Sketch the cycle on a T-s diagram and determine (a)

    Premium Diesel engine Gas turbine Heat engine

    • 349 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Research Paper

    • 254 Words
    • 2 Pages

    30.00 | Navotas Gas Turbine 1-3 | Hopewell Holdings Ltd. (Hongkong) | BOT | 40.00 | Toledo Cebu Coal Thermal Plant | Atlas Cons. Mining & Devt. Corp. | ECA | 35.00 | Pinamucan‚ Batangas Diesel Power Plant | PRISMA Energy Phils. Corp. | BOT | 120.00 |   Power Sector | Project Name | Proponent | Scheme | Estimated Project Cost in US$ Million | Benguet Province Mini Hydro | Hydro Electric Devt. Corp (Phils.) | RA 7156 | 22.00 | Limay Bataan Combined Cycle Gas Turbine Power Plant Block

    Premium Gas turbine Luzon Philippines

    • 254 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Gas Analyzer

    • 5081 Words
    • 21 Pages

    Gas analysis techniques Terms for gas analysis techniques  Concentration The term concentration describes the amount of a substance‚ expressed as mass‚ volume‚ or number of particles in a unit volume of a solid‚ liquid‚ or gaseous substance e.g. alcohol in beer or oxygen in air. Different units are in use to describe concentration in gases: Mass concentration Concentration expressed in terms of mass of substance per unit volume [g substance/m3 gas volume] ¢ Volume concentration Concentration

    Premium Pressure Air pollution Gas

    • 5081 Words
    • 21 Pages
    Powerful Essays
  • Powerful Essays

    Gas Laws

    • 17279 Words
    • 70 Pages

    Review the behavior of the gas phase vs. the liquid phase. Solution: a) The volume of the liquid remains constant‚ but the volume of the gas increases to the volume of the larger container. b) The volume of the container holding the gas sample increases when heated‚ but the volume of the container holding the liquid sample remains essentially constant when heated. c) The volume of the liquid remains essentially constant‚ but the volume of the gas is reduced. The particles in a gas are further apart than

    Free Pressure Ideal gas law Gas

    • 17279 Words
    • 70 Pages
    Powerful Essays
  • Good Essays

    Gas Chromatography Lab

    • 940 Words
    • 4 Pages

    Data and Conclusions: The purpose of this experiment was to learn how to use distillation and gas chromatography to separate and identify different compounds from a given mixture. There are several kinds of distillation methods. However‚ the method that we used in this experiment was fractional distillation. This method is used when trying to separate two different volatile compounds whose boiling points differ by 40-50°C or more. If the boiling points are too close‚ this method

    Premium Distillation Evaporation Water

    • 940 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Introduction Hand lay-up combined with autoclave curing is a composite manufacturing technique which is still widely used in the aerospace industry. The main reasons are the confidence in this well established process and the high fibre volume fractions and low void contents which can be achieved due to the high pressures used in autoclaving. However‚ autoclaving mainly depends on the manual mould lay-up of prepreg material. Manual lay-up of high-curvature products is complicated and most of all

    Premium Composite material

    • 598 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    oil and gas

    • 33368 Words
    • 134 Pages

    United States Gulf of Mexico Oil and Natural Gas Industry Economic Impact Analysis The Economic Impacts of GOM Oil and Natural Gas Development on the U.S. Economy Prepared by: Quest Offshore Resources‚ Inc. Prepared for: 1600 Highway 6‚ Suite 300 American Petroleum Institute (API) Sugar Land‚ TX 77478 National Ocean Industries Association (NOIA) June 2011 Key Findings This report has documented the decline in generate tax revenues at all levels of capital operational

    Premium Natural gas

    • 33368 Words
    • 134 Pages
    Powerful Essays
  • Better Essays

    Gas Laws

    • 1333 Words
    • 6 Pages

    Gas Laws Name Institution The 3 Gas Laws Introduction The three gas laws include: Gay-Lussac’s law‚ Boyle’s law and Charles’ law. When combined with Avogadro’s law the three laws can be generalized by the ideal gas law. Gases possess observable properties which include‚ mass‚ pressure (P)‚ thermodynamic temperature (T) and volume (V). These properties are related to each other and the state of a gas is determined by their values. The three laws are derived from these properties. Discussion

    Premium Temperature Ideal gas law Pressure

    • 1333 Words
    • 6 Pages
    Better Essays
  • Powerful Essays

    Industrial Training Report

    • 12029 Words
    • 49 Pages

    STUDY OF STG-TRANSFORMERS IN VEMAGIRI POWER GENERATION LIMITED DISSERTATION SUBMITTED TO FACILITATE FULFILMENT OF THE INDUSTRIAL TRAINING SPECIFIED IN THE ACADEMIC CIRRICULUM OF ELECTRICAL AND ELECTRONICS ENGINEERING OF UNDER THE ESTEEMED GUIDANCE OF MR. P. BHOLA SHANKER EXECUTIVE ENGINEER (MECHANICAL) GMR-VPGL‚ VEMAGIRI RAJAHMUNDRY‚ ANDHRA

    Premium Gas turbine Transformer

    • 12029 Words
    • 49 Pages
    Powerful Essays
Page 1 4 5 6 7 8 9 10 11 50