Preview

What Is The Separation Of Oil Of Clove And Eugenol

Good Essays
Open Document
Open Document
506 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
What Is The Separation Of Oil Of Clove And Eugenol
M. S. Ntamila and A. Hassanali University of Dares Salaam P.O. BOX 35061 Tanzania

kolation of Oil of Clove and Separation of Eugenol and Acetyl Eugenol .
An instructive experiment for beginning chemistry undergraduates chloride, and hydroxamic ester tests, and the preparation of the henzovl derivative of eupenol. Finally, ir spectra of the two components are examined, and the information ohtained comoared with that from chemical tests. Practical Detalls
Crush about 30-35 g of cloves with pestle and mortar and place in the distillation flask (500 ml) containing about 100 ml water; steam-distil for 1% hr heating both the boiler and the distillation flask. The receiver contains oil of clove, some separated and some dispersed in water. Extract the mixture with 3 portions of 25 ml chloroform. Examine the chloroform extract using the tlc plates (Silica Gel coated plates and running with chloroformlligroin: Y4). Develop the plate by exposing to iodine vapor or preferably spraying with concentrated sulfuric acid in ethanol and then heating a t 120°C. Retain a small sample (0.5 ml) of the chloroform solution. For the separation of the two major components, extract the chloroform solution with 3 portions of 25 ml 5% sodium hydroxide solution. The chloroform layer which now contains mainly acetyl eugenol is dried over anhydrous sodium sulfate,
…show more content…
few exerri~es i&ol\.ing t h e isoI&i~n,separ&ion, purificarim, and physical and chemical study of natural products suitahle for l~erinnine " " students have been worked out.' The present experiment which we have developed a t Dar es Salaam,2 has the advantages that i t is simple to perform, requires only small quantities of readily available material, and may he completed within a normal practical period. Cloves are the dried unopened buds of the clove tree, Eupenia carvoohvllata (also known as Eupenia aromati" . "

You May Also Find These Documents Helpful

  • Better Essays

    15.0 mL of 1M aqueous sodium hydroxide was added to the clove oil in the separatory funnel. The bottom layer of the separatory funnel was removed and the top layer added to a 250 mL beaker. The aqueous bottom layer was then added back to the separatory funnel. 15.0 mL of 1M aqueous sodium hydroxide was added to the separatory funnel. The bottom layer was again removed and the top layer added to the previous 250 mL beaker. 10 mL of hydrochloric acid was added to the clove oil mixture which turned cloudy. A sample of the mixture was placed on the blue litmus paper which turned pink. The acidic solution was then added to the separatory funnel and 15.0 mL of DCM was added. The bottom layer of the separatory funnel was added to a 250 mL beaker. 15.0 mL of DCM was added again to the separatory funnel. The bottom layer was again added to the 250 mL beaker. A 100 mL round bottom flask and cork base were weighed at 104.356 g. Magnesium sulfate was added to the beaker until the powder stopped clumping together. The supernatant was decanted off into the pre-weighed 100 mL round bottom flask. The DCM was removed from the solution using a rotovap machine. The clove oil, round bottom flask, and cork base were weighed at 105.426 g. The clove oil was added to the IR spectroscopy machine and run. The results were obtained (Figure 1) and analyzed to find the major constituent. The weight of clove oil obtained…

    • 1121 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    exp 12

    • 1505 Words
    • 7 Pages

    distilled using a Hickman still and characterized using infrared spectroscopy. The percent yield of isopentyl…

    • 1505 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Chem 103 Project Lab

    • 1372 Words
    • 6 Pages

    The purpose of this lab is to use a variety of analytical skills and methods to determine the empirical formula of an unknown compound.…

    • 1372 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    Returning back to clove oil, which is used in this experiment, this oil is extracted from a small evergreen tree called Syzygium aromaticum that is found in Indonesia, Madagascar, and Zanzibar. Clove oil consists of an essential oil which is a volatile mixture of water-insoluble components that releases an odor and other characteristic of the plant. In this experiment we abstracted the major component of clove oil by codistillation with water through steam distillation and dichloromethane extractions. Also, IR spectrometry was used to identify the unknown constituent. An IR spectrum shows the characteristic…

    • 938 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Adulterated Herb Lab

    • 516 Words
    • 3 Pages

    The purpose of this lab is to analyze the volatile oils of some herbs through TLC testing and then identify the adulterant in a sample.…

    • 516 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Experimental: Sodium metal was patted dry to remove any oil and was cat into small pieces. A dry 100cm3 round bottom flask was placed on a cork ring, on a balance and tarred sodium metal (0.6g) was placed into the flask. The flask was then attached to the dry reflux condenser and industrial methylated spirits (IMS, 15cm3) was added. Once all of the sodium has dissolved the solution was cooled to room temperature and the para-acetamidophenol (3.5g) was added. Ethyl iodine (3.0cm3) was slowly introduced to the mixture through the top of the condenser and the resulting in the mixture was boiled at reflux temperature for 20 minutes and was placed in a rotary evaporator to remove any excess solvent. Distilled water (40cm3) was added to the mixture and the flask was placed in ice until crystals were formed. The crude product was filtered using vacuum filtration the filtrates were washed with very little cold water and were left dry as much as possible.…

    • 652 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Isolation of Clove Oil

    • 685 Words
    • 3 Pages

    We first combine 15 mL of water with 1 g of crushed, ground cloves in a 25-mL round-bottom flask. Then added a spin bar to the 25-mL round-bottom flask and assembled the microscale distillation apparatus. We made certain that the ground cloves were well wetted. We maintained the temperature of the sand bath at approximately 130 °C and wrapped the bottom of the still with aluminum foil. Then periodically transfer the distillate from the Hickman head to a 15 mL screw cap centrifuge tube and continue the steam distillation until 5–8 mL of distillate have been collected. Then we started the extraction process by adding 2 mL of CH2Cl3 to the water–eugenol emulsion. Cap the tube and shake it frequently. We then allowed the layers to separate and transferred the CH2Cl2–eugenol solution to a clean, dry 5- mL conical vial. We made sure no water was transferred in this step. Then we added 1 mL of CH2Cl2 to the water–eugenol emulsion, cap and shake the tube. Allowed the layers to separate and transfer the CH2Cl2–eugenol solution to the 5-mL vial used previously and made certain that no water is transferred during this step. We then added 1 mL of CH2Cl2 to the water–eugenol emulsion and shook the tube. We allowed the layers to separate and transferred the CH2Cl2–eugenol solution to the 5-mL vial used in previous step. We made…

    • 685 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Ethanol (100ml), potassium hydroxide (8.065g, 2.568mmol) and water (5ml) were added in order to 2,4,5-triphenyl-1H-imidazol (0.9402g, 3.17mmol). The mixture was stirred until clear before it was cooled to 5 ºC. A solution of potassium ferricyanide (3.0021 g, 9.085mmol), water (250ml) and ethanol (100ml) was prepared and added dropwise into the mixture ensuring the temperature did not rise above 10 ºC. A grey precipitate was isolated from the yellow mixture through vacuum filtration and washed with water (50ml x 5) and 50% aqueous ethanol. The mixture was dried under vaccuum suction and the melting point was determined. Yield: 0.85g, 90.8% m.p-199.8-200.3ºC. A portion of the dimer (0.0305 g, 0.0514mmol) was quantitatively dissolved in 25ml of toluene. The solution was left for 60min until colorless. The UV-Vis spectra was recorded for the colorless sample. The solution was irradiated using a lamp resulting in a purple solution and the UV-Vis spectrum was retaken. UV (): 524.92nm ε colourless (45.2M-1cm-1) coloured (760M-1cm-1) 1H NMR (300MHz, CDCl3) δ 7.26 (30H, m) 13C NMR DEPT (75MHz, CDCl3) δ 166.5, 149.0, 138.11, 137.9, 134.4, 134.4, 132.7, 132.01-126.13, 112.38.…

    • 1362 Words
    • 6 Pages
    Better Essays
  • Good Essays

    The Aldehyde Enigma

    • 817 Words
    • 4 Pages

    This experiment was performed in collaboration with Paula Mendoza. Exceptions to the procedure are: no NMR or wet chemical test for both compounds. Since there was a lack of organic compound we were unable to proceed with any of the identifying tests.…

    • 817 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Its a Gas Lab

    • 388 Words
    • 2 Pages

    Purpose: The purpose of this lab is to look at some properties of three common compounds,…

    • 388 Words
    • 2 Pages
    Good Essays
  • Better Essays

    Unknown Mixture

    • 2165 Words
    • 9 Pages

    The purpose of this experiment was to separate and identify the two unknown compounds. The sample used was 105 and it contain 2-propanol and 2-heptanone. IR spectrums were taken of the contents of the second and sixth test tubes and showed the presence of an OH functional group and a small amount of ketone in test tube two and a large presence of ketone in test tube six. The average boiling points of the test tubes, 73°C and 162°C respectively, were compared to the boiling points in the tables of alcohols and ketones found in the back of the lab manual. Test tube two was comparable to methanol, ethanol, 2-propanol, and 2-methyl-2-propanol. Upon inspection of the IR spectrums, 2-propanol was a match.…

    • 2165 Words
    • 9 Pages
    Better Essays
  • Good Essays

    Dried powder of the plant material (coarse powder) placed into a distilling flask and add few pieces of porous earthenware. Add 200ml D.W to the flask and shake well. Add another 200ml of water by rinsing the neck of the flask. Connect the distilling flask with the still head of the apparatus. By the means until over flowsConnect the condenser of the apparatus with the cooling water (from the tap).Heat the distilling flask until the boiling starts. Record the time of the beginning of distillation, and continue the distillation for one hourSwitch off the heating. Allow the graduated receiver to cool. 16…

    • 582 Words
    • 3 Pages
    Good Essays
  • Better Essays

    All reagents and solvents used were purchased from commercial suppliers. All solvents and reagents used in this experiment were used as received. To obtain IR spectra, Thermo Scientific Nicolet IR100 FT-IR spectrometer was used.…

    • 828 Words
    • 4 Pages
    Better Essays
  • Good Essays

    Steam Distillation

    • 614 Words
    • 3 Pages

    The purpose of this experiment was to isolate the aromatic hydroxyl compound, eugenol from crushed cloves using steam distillation. After conducting the distillation, the expected two layers were not visible in the centrifuge tube. Subsequently, the extraction and evaporation did not produce the expected oil. This result is probably due to the collection of only water vapor during distillation.…

    • 614 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    First create a list of plant extracts being tested and choose 2 extracts per group. The plants being tested are Oregano, Tea tree, Eucalyptus and Colloidal Silver.…

    • 939 Words
    • 4 Pages
    Powerful Essays