Preview

Ventilation of Cars

Powerful Essays
Open Document
Open Document
3975 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Ventilation of Cars
Embedded Technology For Vehicle Cabin Safety
Monitoring And Alerting System

ABSTRACT
Motor vehicles are the prime source of transportation where vehicles with A/C play a major part. This paper designs an embedded system for a vehicle cabin, which senses the gases like carbon-monoxide and oxygen and displayed at each and every second. If the level of the CO increases than the normal level (30ppm) or the level of the oxygen decreases than the normal level (19%) then an alarm is generated automatically and also ventilation is provided immediately. A warning message is sent to the authorized user via GSM. The advantage of this system is proper detection and faster response time leading to faster diffusion of the situation, compared with the manual methods.

Key words: Atmel microcontroller, ,Embedded System,Gas detecting sensors,GSM Modem,Vehicle safety.

1. INTRODUCTION
Motor vehicles are they not only the prime source of transportation, but also the prime source of pollution. These motor vehicles contribute to over 30% of the hazardous gases that are released into the atmosphere.As the vehicle cabin is small area, any suspended particulate such as dust, fumes, smokes entering in to it through either ventilation or through windows can cause serious health problems to the person inside.The health effects range from minor irritation of eyes and the upper respiratory system to chronic respiratory disease, heart disease,lung cancer and even death .Even if the vehicle is equipped with the air cabin filters that are present inside the cabin so ashe person inside Hence to overcome these types of problems there is a need to monitor several gases such as carbon monoxide (CO) and the oxygen level is required to ensure complete vehicle occupant comfort and safety. This paper designs an embedded system for toxic gas CO and oxygen level detection inside the vehicle cabin and to develop a sensing system using a sensor array and microcontroller. If the toxic gas reaches



References: [1] F.-S. Bai, Y.-L. Liu, “Design of Fault Monitoring Alarm System for Networks Based on GSM SMS”. [2] K. Galatsis, W. Wlodarsla, K. Kalantar-Zadeh and A. Trinchi, “Investigation of gas sensors for vehicle cabin air quality monitoring. [3] Goran Jurkovic, Mario Iagar, “GSM wireless Solutions in distributed embedded systems designed for automatic control”. [4] N. Kularatna and B. H. Sudantha, “An environmental air pollution monitoring system”. [5] Al-Ali, member, IEEE, Imran Zualkerman, and Fadi Aloul, “A Mobile GPRS-Sensors Array for Air Pollution Monitoring”. [6] Da-Jeng Yao,“A gas sensing system for indoor air quality control and polluted environment monitoring”. [7] W. Chung and C. H.Yang, “Remote monitoring system with wireless sensors module for room Environment”. [8] F. Tsow, E Forzani, A. Rai, R. Wang, R. Tsui, S. Mastroianni, C. Knobbe, A. J. Gandolfi, and N. J.Tao, “A wearable and wireless sensor system for real-time monitoring of toxic environmental volatile organic compounds,” IEEE Sensors J., vol. 9, pp. 1734–1740, Dec. 2009. [9] Chen Peijiang, Jiang Xuehua, “Design and implementation of Remote monitoring system based on GSM”, vol. 42, pp. 167-175, 2008.

You May Also Find These Documents Helpful

  • Good Essays

    Purpose: To analyze a few physical and chemical properties of gases as well as using those properties to identify the gases.…

    • 480 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    11. Hazardous air pollutants are chemical emissions that pose a health risk of serious illness such as cancer or…

    • 7124 Words
    • 47 Pages
    Powerful Essays
  • Good Essays

    Secondly, reduce carbon dioxide by eliminating the use of gasoline power vehicles. Eliminate the use of aerosol spray cans for the use of hair care products, paint cans, car products, cleaning products, and aerosol can air fresheners. The consumers should have the capabilities of purchasing economical products for their living environment. For example, Provide people with more safety measures in use of carbon monoxide detector in homes and confined spaces where natural gas is used. Carbon monoxide detector detects harmful gases that are harmful to humans and animals. It is often referred to as the silent killer, and people are not aware they are being poisoned because carbon dioxide depending on the amount of exposure and it is virtually undetected. The symptoms include dizziness, weakness, and loss of conscious, headaches, and even lead to most death. Smaller concentrations are harmful over a period of time while the exposure is increased and could be dangerous.…

    • 589 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Oxygen Sensor

    • 637 Words
    • 3 Pages

    Automotive oxygen sensors, colloquially known as O2 sensors, make modern electronic fuel injection and emission control possible. They help determine, in real time, if the air fuel ratio of a combustion engine is rich or lean. Since oxygen sensors are located in the exhaust stream, they do not directly measure the air or the fuel entering the engine. But when information from oxygen sensors are coupled with information from other sources, they can be used to indirectly determine the air-to-fuel ratio.…

    • 637 Words
    • 3 Pages
    Good Essays
  • Good Essays

    gprs

    • 670 Words
    • 3 Pages

    GRPS-Based Distributed Home-Monitoring Using Internet-Based Geographical Information System A. R. Al-Ali, Imran A. Zualkernan, Assia Lasfer, Alaa Chreide, and Hadel Abu Ouda Abstract — Recent developments in publically available webbased Geographical Information Systems (GIS) and the availability of low-cost integrated General Packet Radio Service (GPRS)/Global Positioning Systems (GPS) modem have enabled the development of embedded stand-alone home monitoring systems. This paper presents the design, implementation and testing of a home-monitoring system that utilizes online Map from a GIS in conjunction with the readily available public satellite-based GPS, and GPRS mobile networks. In addition to detecting intruders, the system allows a home owner to remotely monitor various critical home sensors status including those tied to fire, flooding, and gas leaks.…

    • 670 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The report firstly introduced Auto Oxygen Sensor basic information included Auto Oxygen Sensor definition classification application industry chain structure industry overview; international market analysis, China domestic market analysis, Macroeconomic environment and economic situation analysis and influence, Auto Oxygen Sensor industry policy and plan, Auto Oxygen Sensor product specification, manufacturing process, product cost structure etc.…

    • 849 Words
    • 4 Pages
    Satisfactory Essays
  • Better Essays

    Matlab

    • 1699 Words
    • 7 Pages

    Actually there are many measures to prevent accidents caused by gas leaks and/or gas generations.…

    • 1699 Words
    • 7 Pages
    Better Essays
  • Better Essays

    Acid Rain Research

    • 1542 Words
    • 7 Pages

    The information gained from this experiment may be used to as a warning to stop air pollution.…

    • 1542 Words
    • 7 Pages
    Better Essays
  • Powerful Essays

    Gps & gsm based Tracking

    • 17226 Words
    • 69 Pages

    In this project P89V51RD2 microcontroller is used for interfacing to various hardware peripherals. The current design is an embedded application, which will continuously monitor a moving Vehicle and report the status of the Vehicle on demand. For doing so an P89V51RD2 microcontroller is interfaced serially to a GSM Modem and GPS Receiver. A GSM modem is used to send the position (Latitude and Longitude) of the vehicle from a remote place. The GPS modem will continuously give the data i.e. the latitude and longitude indicating the position of the vehicle. The GPS modem gives many parameters as the output, but only the NMEA data coming out is read and displayed on to the LCD. The same data is sent to the mobile at the other end from where the position of the vehicle is demanded. An EEPROM is used to store the mobile number.…

    • 17226 Words
    • 69 Pages
    Powerful Essays
  • Satisfactory Essays

    The main function of the system is to control any electrical devices through mobile phone. The goal of the project is to develop a system,which uses Mobile technology that keeps control of various units of the automobiles,which executes with respect to signal sent by mobile.…

    • 276 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Aqua Silencer

    • 733 Words
    • 3 Pages

    These toxic gases are harmful not only to the atmosphere, but also to the human & animal race. Objective of this project is to design & fabricate a simple system, where the toxic levels are controlled through chemical reaction to more agreeable level. This system acts itself as a silencer; there is no need to separate the silencer. The whole assembly is fitted in the exhaust pipe; it does not give rise to any complications in assembling it. This system is VERY COST EFFECTIVE AND MORE ECONOMICAL.…

    • 733 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Gas Leak Detection

    • 642 Words
    • 3 Pages

    Gas leak detection methods became a concern after the effects of harmful gases on human health were discovered. Before modern electronic sensors, early detection methods relied on less precise detectors. Through the 19th and early 20th centuries, coal miners would bring canaries down to the tunnels with them as an early detection system against life threatening gases such as carbon dioxide, carbon monoxide and methane. The canary, normally a very songful bird, would stop singing and eventually die in the presence of these gases, signaling the miners to exit the mine quickly. Before the development of electronic household carbon monoxide detectors in the 1980s and 90s, carbon monoxide presence was detected with a chemically infused paper that turned brown when exposed to the gas. Since then, many technologies and devices have been developed to detect, monitor, and alert the leakage of a wide array of gases…

    • 642 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Wireless Energy Meter

    • 3795 Words
    • 16 Pages

    In the age of ecological awareness, and the conclusion that energy should not be wasted, it is necessary to investigate the places where electrical energy is consumed. The effective energy usage of a device can often be determined by monitoring the according electrical devices over a long space of time. The measuring can easily be done by simple Energy Meters from the local do-it-yourself store. An energy meter is a device that measures the amount of electrical energy that is being consumed by a residence, business, or an electrically powered device. Electric meters are typically calibrated in billing units, the most common one being the kilowatt hour. Present energy meter reading is a tedious and an expensive affair as it requires manual collection of reading which is erroneous.Automatic Electric Meter reading is one method reading and processing data automatically with computer and communication. It not only may relieve reading person 's labor intensity, reduce the reading mistake, but also has the advantage of high speed and good real-time. The project of the wireless Electric Meter reading for wireless communication technology completes the design of automatic Electric Meter reading system. There the data can be interpreted and may be even compared to data from other wirelessly connected devices. Through researching the characteristic of main wireless communication protocol, ZigBee is chosen as lower layer communication protocol. ZigBee is a specification for a suite of high level communication protocols using small, low-power digital radios based on an IEEE 802 standard for personal area networks. The standard of ZigBeeis optimized for low data rate, low power consumption, security and reliability. Wireless energy meter using ZigBee is very useful for accurate energy billing apart from intelligent load shedding and theft detection.…

    • 3795 Words
    • 16 Pages
    Powerful Essays
  • Powerful Essays

    Automotive Electronics

    • 2903 Words
    • 12 Pages

    References: [1] Bluetooth Special Interest Group (SIG). Bluetooth Core Specification. Version 2.0 + EDR, November 2004. [2] Car2Car Communication Consortium. http://www.car-2-car.org/. [3] FlexRay Communications System - Protocol Specification. Version 2.0, June 2004. [4] IEEE 802.11, The Working Group Setting the Standards for Wireless LANs. http://www.ieee802.org/11/. [5] IEEE 802.15, Working Group for Wireless Personal Area Networks (WPANs). http://www.ieee802.org/15/. [6] NOW: Network on Wheels. http://www.network-onwheels.de/. [7] Ultrawidebandplanet.com. http://www.ultrawidebandplanet.com/. [8] ZigBee Alliance. http://www.zigbee.org/.…

    • 2903 Words
    • 12 Pages
    Powerful Essays
  • Satisfactory Essays

    Air pollution is one of the contribution factors to the increments of various disease to the country. One of the major contributor to the pollution is the uses of private cars that produce Carbon Monoxide to the environment. It has been known that high levels of pollutions observed in most of the big cities have been resulted on important damages of people’s health and human respiratory systems (throat, lungs and nose) and also can hurts the eyes and skin.…

    • 509 Words
    • 2 Pages
    Satisfactory Essays