Preview

Separation and Qualitative Determination of Cations and Anions

Good Essays
Open Document
Open Document
2524 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Separation and Qualitative Determination of Cations and Anions
Separation and Qualitative Determination of Cations and Anions
Instructor’s Guide

Master Materials List (complete for 24 students working in pairs)
Silver nitrate, AgNO3, 0.2 M, 100 mL*
Silver nitrate, AgNO3, 0.1 M, 100 mL*
Cupric nitrate, Cu(No3)2, .02 M, 100 mL*
Zinc nitrate, Zn(NO3)2, 0.2 M, 100 mL*
Ferric nitrate, Zn(NO3)2, 0.2 M, 100 mL*
Hydrochloric acid, HCl, 6 M, 125 mL*
Nitric acid, HNO3, 6 M, 125 mL*
Ammonia, NH3, 6 M, 125 mL*
Sulfuric acid, H2SO4, 6 M, 125 mL*
Acetic acid, CH3COOH, 6 M, 125 mL*
Sodium chloride, NaCl, 0.2 M, 100 mL*
Sodium carbonate, Na2CO3, 0.2 M, 100 mL*
Sodium hydroxide, 6 M, 100 mL*
Sodium sulfate, Na2SO4, 0.2 M, 100 mL*
Sodium nitrate, NaNO3, 0.2 M, 100 mL*
Barium chloride, BaCl2, 0.1 M, 100 mL*
Barium hydroxide, Ba(OH)2, 5 g*
Potassium thiocynate, KSCN, 0.1 M, 100 mL*
Potassium ferrocyanide, K4Fe(CN)6, 0.1 M, 140 mL*
Aluminum granules, Al, 50 g*
Beral-type pipets, 120* *Materials included in kit

Additional Materials Needed
Beakers, 400-mL, 12
Beakers, 250-mL, 5-14
Centrifuges, 3
Dropper bottles, 15-30 mL, 96
Hot plates, 3-12
Litmus paper or pH paper
Microscope slides or watch glasses, 12
Spatulas, 12
Stirring rods, 12
Stoppers to fit test tubes, 72
Storage bottle, with cap, 125 mL
Test tubes, 13 X 100 mm, 72
Wire test tube holders, 12

Preparation of Solutions (for 12 student groups)
Note: 0.2 M solutions are provided so unknown solutions can be easily made. The 0.2 M solutions are also easier to ship and take up less room. Dilution the 0.2 M solutions to 0.05 M solutions does not have to quantitative. Use the markings on the beaker for measurements.

Solution of Four Cations
Prepare 100 mL of a 0.05 M solution of all the cations to be tested by adding 25 mL of each of the following solutions to a clean 250-mL beaker. 0.2 M silver nitrate, AgNO3 0.2 M cupric nitrate, Cu(NO)3 0.2 M zinc nitrate, Zn(NO3)2 0.2 M ferric nitrate, Fe(NO3)3

Mix the

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Halide Ions Lab

    • 618 Words
    • 3 Pages

    1. Place the 4 solutions in separate test tubes with about 2.5 mL in each. (NaF, NaCl, KBr, KI) Use a dropper or you can use a pipette. Add 1 Ml ( 20 drops) of 0.5 M Ca ( NO3h) to each test tubes. Observe…

    • 618 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Experiment 3 prelab

    • 345 Words
    • 2 Pages

    After all of the solutions are prepared, obtain a cuvette from your professor (special sample cell).…

    • 345 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    3. Add 10-20 drops of each known solution to respective test tubes, do not mix pipets!…

    • 372 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    5. Pour the solution out, rinse the cup and thermometer, and repeat steps 1-4 using a different ratio of the two substances, always keeping the volume at 50.0mL.…

    • 1033 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Chem Lab Project 2

    • 2646 Words
    • 6 Pages

    by adding 10 drops of each known cation in metal solution; the tubes were labeled accordingly. The…

    • 2646 Words
    • 6 Pages
    Good Essays
  • Good Essays

    3. Measure 10mL of distilled water in the beaker. Then, transfer it to the graduated cylinder to make it easier to pour into the test tube.…

    • 565 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Corn and Milk Lab

    • 290 Words
    • 2 Pages

    5)Pour a little amount of each of the substances into their test tube, add 30 drops of water with a pipet.…

    • 290 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    2. Perform the following steps on each of the substances to be tested. Complete all tests of one…

    • 976 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Halide Test Lab Report

    • 1363 Words
    • 6 Pages

    17.To the halides in column 4, add 5 drops of starch solution and 1 drop of 5% bleach solution. Record your observations. Save the results of testing the four halide solutions for comparison with tests of the unknown solutions.…

    • 1363 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    The purpose of this lab was for the student to get involved with his or hers new lab kit as well as being able to know, identify and use each other tools provided in the kit. Another key learning aspect of this lab is to teach the student how to measure properly the many units in the SI system. I will be using laboratory dilutions, measurements, and weights to then calculate using algebraic formula.…

    • 1005 Words
    • 5 Pages
    Good Essays
  • Good Essays

    pH and Living Systems Lab

    • 472 Words
    • 2 Pages

    1) First use the wide range pH paper to test the pH of the liquids given.…

    • 472 Words
    • 2 Pages
    Good Essays
  • Good Essays

    This experiment seeks to explore different chemical reactions conducted in the lab. A cation is defined as positively charged ions, which are K+ and Pb2+ in this experiment, and an anion is termed as negatively charged ions, which are CrO4 2- and NO3 2-. The major objective of this lab experiment was to examine the reaction between cations and anions, as well as observing, and documenting the chemical reactions. We will be demonstrating the reaction between a solution of Lead Nitrate with a chemical formula of PbNO3 2, and a Potassium Chromate solution with a chemical formula of K2CrO4. The end result from mixing the two solutions should have a combined set of either the Pb2+ or K+ cation and likewise with the NO3 2- or CrO4 2- anion in its chemical formula. This experiment will demonstrate the chemical reaction between the cations and anions with an expected end result of a solid substance, which validates that a chemical reaction occurred.…

    • 878 Words
    • 4 Pages
    Good Essays
  • Better Essays

    Anions Lab

    • 1345 Words
    • 6 Pages

    Purpose: The purpose of this lab is to identify the presence of cations and anions in four unknown solutions by identifying whether they are copper, silver, iron, or chloride ions which is done by adding sodium hydroxide, solid copper, silver nitrate, and potassium thiocyanate to the solutions and analyzing the chemical reactions.…

    • 1345 Words
    • 6 Pages
    Better Essays
  • Good Essays

    Acetinalide Report

    • 419 Words
    • 2 Pages

    Acetanilide is used as a precursor in penicillin synthesisand other pharmaceuticals including painkillers and intermediates. In medicine, it is a prodrug with analgesic and antipyretic, or fever-reducingproperties which is in the same class of drugs as…

    • 419 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Simple qualitative analysis involves the identification of the constituents of an inorganic substance or a mixture of substances. The inorganic substances are split-up into two types of charged particles one of which is positively charged and the other is negatively charged. The charged particles are called ions or radicals. The positively charged ions are called cation or basic radical. The negatively charged ion is called anion or acid radical.…

    • 887 Words
    • 4 Pages
    Good Essays