Preview

Physics Lab Report

Better Essays
Open Document
Open Document
2831 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Physics Lab Report
CROATICA CHEMICA ACTA
CCACAA 78 (1) 99¿103 (2005)
ISSN-0011-1643
CCA-2984
Original Scientific Paper

Acid Value Determination in Vegetable Oils by Indirect Titration in Aqueous-alcohol Media
Elena Kardash* and Yakov I. Tur’yan
National Physical Laboratory of Israel (INPL), Givat Ram, Jerusalem 91904, Israel
RECEIVED JANUARY 16, 2004; REVISED JULY 21, 2004; ACCEPTED OCTOBER 28, 2004

Keywords acid value vegetable oils indirect titration

A new method of acid value determination in vegetable oils has been developed. The method is based on (a) simple, rapid and complete extraction of acids from an oil test portion into reagent
(0.05 mol dm–3 triethanolamine (B) in the mixture of 50 % H2O + 50 % 2-PrOH) and (b) indirect titration of acids in BH+ form against aqueous alkali in the presence of a phenolphthalein indicator. Suitable metrological parameters of acid value determination have been obtained.
The advantages of the method are (i) absence of a toxic solvent, (ii) extraction and titration of acids at room temperature, and (iii) no need for preliminary neutralization of acid admixtures in a solvent.

INTRODUCTION
Acid value (AV) is an important indicator of vegetable oil quality. AV is expressed as the amount of KOH (in milligrams) necessary to neutralize free fatty acids contained in 1 g of oil.1,2
The majority of national and international standards for AV determination in vegetable oils are based on the acid-base titration techniques in non-aqueous solvents.1,2
These techniques have a number of drawbacks:
(i) Currently used non-aqueous solvents are toxic,
e.g., ethanol or isopropanol heated up to 60 °C or higher
(exact temperature is not indicated),1 or diethyl ether– ethanol solvent (1:1 vol. ratio).2
(ii) Incomplete solubility of a test oil portion in alcohol (even under heating)1 caused by the formation of a dispersed system.3
(iii) Conditions for accurate acid-base titration in hot amphoteric solvents might deteriorate



References: 1. D. Firestone (Ed.), Official Methods and Recommended Practices of the American Oil Chemists Society, 4th ed., American Oil Chemists Society, Champaign, 1996, Method Ca 5a–40 3. W. Horwitz, J. Assoc. Off. Anal. Chem. 59 (1976) 658–661. 4. R. A. Robinson and R. H. Stockes, Electrolyte Solutions, Buterworthy Scientific Publications, London, 1959. 5. Ya. I. Tur’yan, O. Yu. Berezin, I. Kuselman, and A. Shenhar, J. Am. Oil Chem. Soc. 73 (1996) 295–301. Kuselman, Croat. Chem. Acta 76 (2003) 329–334. 8. H. S. Harned and B. B. Owen, The Physical Chemistry of Electrolytic Solutions, 3rd ed., Reinhold Publishing Corporation, New York, 1958, p 9. H. A. Laitinen, Chemical Analysis, Khimiya, Moscow, 1966, p Croat. Chem. Acta 78 (1) 99–103 (2005)

You May Also Find These Documents Helpful

  • Good Essays

    In this experiment we also used a chemical method known as extraction. This process of separation is used when only one component of the mixture is soluble in a specific solvent. In our case we had to use hydrochloric acid (HCl).Extractions, is a way to separate a desired substance when it is mixed with others. The mixture is brought into contact with a solvent in which the substance of interest is soluble, but the other substances present are insoluble. And below is a…

    • 854 Words
    • 4 Pages
    Good Essays
  • Better Essays

    Introduction: The major component of anise oil has the chemical formula C10H12O. This compound is said to be hydrogen deficient, meaning that it contains less hydrogen atoms than would be needed for each of the carbon atoms to have the maximum amount of hydrogen atoms attached. The IHD, or index of hydrogen deficiency for this molecule is 10. This indicates that there must be five rings or double bonds in the structure. Each of these would compensate for two of the missing hydrogen atoms. Since a saturated compound of the chemical formula C10H20O is formed upon catalytic hydrogenation of anise oil, it can be determined that the original structure contains four pi bonds, as eight hydrogen atoms were added. Through heating with hydriodic acid, anisene forms the phenol C9H9OH. This indicates that the major constituent of anise oil is an aryl methyl ether, with the chemical formula C9H9OCH3. With the formula rewritten, it can be seen that anisene has a disubstituted benzene ring with a methoxyl group (-CH3O). This means that the remaining constituent is –C3H5. In this experiment, anisene can then react with a methoxybenzoic acid to yield one of three products. The identity of the product, which can be decided by a melting point and IR spectrum analysis, can then infer the position of…

    • 1268 Words
    • 6 Pages
    Better Essays
  • Satisfactory Essays

    Lab Report Physics

    • 1021 Words
    • 5 Pages

    (Be sure to look over all your notes and be sure to know the following things)…

    • 1021 Words
    • 5 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab Report Physics

    • 466 Words
    • 2 Pages

    After labs have been completed, facilitate a class discussion where students summarize and compare findings and relate how their findings support (or refute) Newton's Laws of Motion…

    • 466 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Cited: Manion, J. 2004. University of Central Arkansas. Separating Acids and Neutral Compounds by Solvent Extraction. In: Signature Lab Series Chemistry Labs. (M. Stranz, editor) Cengage Learning. Mason, Ohio. 2008. Pp.45-63.…

    • 1456 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Procedure: Refer to Pavia, et. al., Introduction to Organic Laboratory Techniques; 4th ed., Thomson Learning, pp. 82-86…

    • 616 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Liquid Chromatography Lab

    • 2834 Words
    • 12 Pages

    In this experiment, liquid chromatography is used to separate the substances that are present in…

    • 2834 Words
    • 12 Pages
    Powerful Essays
  • Powerful Essays

    In this experiment, a situ method steam distillation was performed and essential oils were isolated from cloves. Once the oils were obtained, extraction techniques were used to extract a crude, eugenol, and acetyleugenol product sample. These samples were submitted for GC analysis and the normalization area percents were calculated to confirm their purity; for the crude sample it was 93.95% eugenol and 6.05% acetyleugenol, for the eugenol sample it was 100% eugenol and 0% acetyleugenol, and for the acetyleugenol sample it was 24.84% eugenol and 75.16% acetyleugenol. The IR spectrum was also found for the eugenol and acetyleguenol products, which confirmed their identities; the eugenol sample showed the presence of the alcohol functional group O-H at 3425.19 cm-1 and both alkene C=C at 1604.43 cm-1 and aromatic C=C at 1509.35 cm-1. The acetyleugenol sample showed the presence of ester C=O at 1760.27 cm-1, both alkene C=C at 1506.83 cm-1 and aromatic C=C at 1417.46 cm-1.…

    • 2653 Words
    • 11 Pages
    Powerful Essays
  • Better Essays

    References: Fifield, F. W. and Kealey, D. 1995. Principles and Practice of Analytical chemistry. (4th ed) Glasgow, Blackie Academic and professional.…

    • 1192 Words
    • 5 Pages
    Better Essays
  • Good Essays

    For both of the organic acid and organic base extraction, the addition of the respective inorganic acid or inorganic base (HCl or NaOH) to the three-component mixture caused an immiscible appearance of the solution in the separatory funnel. By briskly shaking the separatory funnel with the mixed components created a build up of pressure which was released through the stopcock forming small disappearing bubbles within the tip of the separatory funnel. Once the funnel was placed back into the iron ring and the stopper was removed, the distinct upper ether layer had an oily appearance and a visible barrier separating it from the lower water-organic base or organic acid layer. After pouring out the ether layer into a beaker and adding anhydrous sodium sulfate, all that remained in the funnel was the neutral extract.…

    • 435 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Determining the Unknown Concentration of NaHCO3 (aq) Through Titration Introduction Titration is the accurate addition of a titrant- solution in a burette- into a measured volume of a sample (Kessel, 2003). There are many different types of titration, such as acid-base reaction, redox reactions, precipitation reaction and more (Dohrman). In this lab an acid base titration will be explored. In an acid-base titration, the concentration of an acid or base is unknown and is determined by the adding (from a burette) a solution of known concentration (titrant). Titration is used in many different fields such as medicine to determine different concentrations of chemicals in the blood.…

    • 1657 Words
    • 7 Pages
    Good Essays
  • Good Essays

    5. If we repeated the experiment in Mexico City at an elevation of 7700 ft about sea level. It would take much more boiling ethanol to dissolve the same amount. The temperature of boiling ethanol would decrease at a higher elevation. So what would be 100°C at sea level might only be 80°C at 7700 ft above sea level. Therefore it would need more ethanol to be soluble.…

    • 1644 Words
    • 7 Pages
    Good Essays
  • Powerful Essays

    Buffers Essay

    • 2060 Words
    • 9 Pages

    Five different buffer solutions were made twice to make ten buffer solutions; one set was be used to observe the changes in pH caused by adding a strong acid (HCl) and the other set was used to observe the changes in pH caused by adding a…

    • 2060 Words
    • 9 Pages
    Powerful Essays
  • Powerful Essays

    Diels Alder Experiment

    • 1208 Words
    • 5 Pages

    References: 1 Mohrig, Jerry R. Techniques in organic chemistry. 3rd ed. New York: Freeman, 2003. Print.…

    • 1208 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Acid Base Titration Lab

    • 626 Words
    • 3 Pages

    In this lab we will use basic titrating skills and techniques in order to titrate HCl. We will also be practicing how to prepare the solution. Using the titration data, we can practice our stoichiometric skills and also become more familiar with using lab equipment. Titration is the process of measuring the exact volume of a solution of known concentration that is required to react completely with a measured volume of a solution of unknown concentration or a known mass of unknown solid. A solution of accurately known concentration is called a standard solution. To be considered standard, the concentration of the solute in the solution must be known to four significant figures. When an acid or base solution is prepared from stock acid or base, the concentration is approximately known. However, due to relative purity and limitations on the accuracy and precision of measuring quantities for solution preparation, the solution’s exact concentration is not known. For this reason, the process of standardization is used. Standardization is a laboratory process in which the exact concentration of a solution is obtained by comparing the concentration of the solution to a primary standard, a dry substance of known purity.…

    • 626 Words
    • 3 Pages
    Good Essays