Preview

Organic Chem 1 Post Lab Report

Better Essays
Open Document
Open Document
842 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Organic Chem 1 Post Lab Report
Post Lab Report
Experiment 3 - Chromatography – Analyzing Analgesics by TLC and Isolation of β–Carotene by Column Chromatography
Chemicals
1. Acetaminophen (C8H9NO2)

2. Aspirin (C9H8O4)

3. Caffeine (C8H10N4O2)

4. Ibuprofen (C13hH18O2)

Introduction
In this experiment, several analgesics were analyzed by Thin Layer Chromatography (TLC) and the composition of an unknown tablet was identified. We define chromatography as the separation of two or more compounds or ions by their molecular interactions by either a moving or a stationary phase.1 There are different types of chromatography: Thin Layer Chromatography (TLC), Gas Liquid Chromatography (GC), and Column Chromatography (CC). All of which there two phases: mobile and stationary. Phases can be a solid and a liquid, a liquid and a liquid, a gas and a solid, or a gas and a liquid. The stationary phase is also known as the absorbent. Greater affinity, or attraction, for the mobile phases will move faster and conversely for stationary phases.2 Running a solvent past the absorbent complex in order to remove analytes from the absorbent is known as elution. This process aids in determining affinity.3 The most polar compound is always the absorbent; however, the polarity of the compounds in the mixture in addition to the solvents found in the mixture differs in polarities. We use chromatography, or more specifically TLC, to determine the relative amounts of components in a mixture. Additionally TLC is utilized to determine the identity of two substances. When utilizing TLC, the ratio of distance traveled by the compound to the solvent is defined as Rf. 1 Column Chromatography, is used in this experiment to separate β-carotene from a mixture. Column Chromatography is utilized for purification of both solids and liquids. Primarily, CC is used to separate and isolate compounds. The similarities between TLC and CC include the utilization of a chamber and UV light to identify the affinity of



References: 1) Weldegirma, S. Experimental Organic Chemistry Laboratory Manual: CHM 2210l and CHM 2211L Fall 2011/ Spring 2012; Mason OH, 2010; pp 4-8. 2) Wikipedia.com Affinity. http://en.wikipedia.org/wiki/Affinity (accessed September 19,2011) 3) Wikipedia.com Elution. http://en.wikipedia.org/wiki/Elution (accessed September 19, 2011)

You May Also Find These Documents Helpful

  • Powerful Essays

    The purpose of this experiment was to perform the separation of aspirin, sucrose and an unknown analgesic, which are constituents of Panacetin using the methods of filtration, extraction, and purification…

    • 1744 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Aspirin, Caffeine and Salicylamide were extracted from an over-the-counter pain reliever (BC Powder). These components were separated by manipulating their solubilities by adjusting the acidity and basicity of the solution. By doing this, the three components were forced into conjugate acid (or base) forms, causing selective solubility in either an aqueous or organic solvent. These layers were then separated by use of a separation funnel. Once separated, the components extracted were characterized by measuring the melting point and performing a TLC analysis. Also, the recovered aspirin from the first part of the experiment was recrystallized and compared to that of the isolated aspirin.…

    • 1653 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Panacetin Lab Report

    • 1439 Words
    • 6 Pages

    The second experiment of the semester focuses on separating and identifying the components of Panacetin, which is a common medication that relieves pain. The label reveals that Panacetin is composed of sucrose (10%), aspirin (40%), and Tylenol (50%). Although this information is reported, the true composition of Panacetin is questionable. While sucrose and aspirin are present in Panacetin, Tylenol may be replaced by an unknown component (acetanilide or phenacetin). Separation of the components of a sample of Panacetin may prove valuable in identification of the unknown component, as well as the true percent composition of each component of Panacetin.…

    • 1439 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    The purpose of this experiment is to investigate the composition of a simulated pharmaceutical preparation Panacetin, a proposed type of pain-killer. Panacetin is typically made up of sucrose, aspirin, and acetaminophen, but the third component in this experiment is unknown. The unknown component is suspected to be a chemical relative of acetaminophen, either acetanilide or phenacetin. Using techniques such as extraction, evaporation, and filtration, the three components will be isolated based on their solubilities and acid-base properties. The percent composition of Panacetin will also be deduced based on the masses of the three dried components; this is done to verify the composition attained is consistent with those listed on the preparations label. As a result of this investigation, my teammates and I allowed the Panacetin to undergo gravity filtration and separation techniques in order to identify whether there are any discrepancies in the components of the Panacetin. Furthermore, recrystallization and purification methods were used to determine if the unknown substance were similar in properties to either of the suspected unknown substances by comparing factors such as melting points to the chemical properties of phenactin and acetanilide. The results were as expected, based on the molecular weights and ratios of each separated chemicals, as well as the boiling point of the unknown it was determined that these ranges were close enough to indicate that the label is reasonably accurate in its composition. To add on however the identity of the unknown component differed from what the label indicated. In the end, the percentage composition attained based on our observations and yield confirmed that indeed the chemical composition of Panacetin were as indicated on the preparations label. The identity of the unknown component however suggested that the preparation did not contain acetaminophen as indicated, but instead was consistent with the chemical properties…

    • 305 Words
    • 2 Pages
    Good Essays
  • Better Essays

    Tlc Chem 121

    • 3016 Words
    • 13 Pages

    In order to experiment with distinct components of a mixture, they must be first separated so they can be observed individually. This is accomplished in this lab by the technique called thin layer chromatography (TLC). TLC involves a stationary phase, which the TLC plates as well as a mobile phase, which could be one of two solvents used: ethanol-acetone for TLC. Dyes in a sample separate consequently because of their unique polarities. As a result, nonpolar substances travel further than polar substances in this process. The separation of a mixture into its components by TLC transpires because the distinctive components of a mixture interact to different extents with the stationary and mobile phases.…

    • 3016 Words
    • 13 Pages
    Better Essays
  • Good Essays

    Sick Cat Lab

    • 555 Words
    • 3 Pages

    The cat Jasper is a male cat that was given an over-the-counter analgesic which had caused him to keep getting sicker. He is one years old and weighs seven pounds, five ounces. His symptoms included vomiting and having diarrhea for several days. His lab tests showed a metabolic acidosis meaning there was too much acid in his body fluid. This meant Jasper could have been given acetaminophen, aspirin, or ibuprofen. To identify what analgesic Jasper was given we took samples of the different analgesics and crushed them. We used a melting point apparatus to find out what the melting point was and matched it with acetaminophen, aspirin, or ibuprofen. Then we used the Infrared Spectroscopy to determine the function group of the molecules to help us identify which analgesic was used. Between the symptoms, melting point, and results of the infrared spectroscopy we were able to identify what analgesic Jasper ingested.…

    • 555 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    This separation technique is based on the principal that under the same conditions, the time between the injection of a component into the column and the elution of that component is constant. This characteristic is used to perform qualitative or quantitative analysis. Thin-layer chromatography (TLC) is a chromatography technique used to separate non-volatile mixtures. Thin-layer chromatography is performed on a sheet of glass, plastic, or aluminium foil, which is coated with a thin layer of adsorbent material, usually silica gel, aluminium oxide, or cellulose. A small amount of the mixture to be analyzed is spotted near the bottom of this plate.…

    • 1965 Words
    • 8 Pages
    Powerful Essays
  • Better Essays

    High performance (or high pressure) liquid chromatography (HPLC) – is an effective type of column chromatography which is widely used in pharmaceuticals. It is very useful to determine the assay and related substances in drug substances. In general HPLC is used to separate the components of a mixed drug substance. In HPLC chromatography, column plays a significant role in separation of different compounds because it contains stationary phase. Stationary phase is a bad of polar or nonpolar particles according to the type of column. Polar and nonpolar columns are used according to the nature of the sample to be analyzed (http://www.pharmaguideline.com/2013/07/principle-of-hplc-liquid-chromatography.html).…

    • 1408 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Liquid Chromatography Lab

    • 1733 Words
    • 7 Pages

    Introduction: We are using liquid chromatography to separate the colored substances in grape-flavored drinks. We separate the component dyes, and then we separate the flavorings and citric acids.…

    • 1733 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Thin-layer Chromatography(TLC) was the method used to figure out and identify the drug. TLC is done on a plate that is coated with a layer of absorbent material.after the solutions have been spotted onto the plate, a solvent is then drawn up the plate with capillary action. Capillary action has to do with the intermolecular forces with the liquid and the surroundings solid surface Different substances ascend the plates with different rates. After the TLC was completed the retention factors of each spot was then calculated. The retention factor(Rf) is calculated by the distance traveled by the sample then divided by the solvent. The retention factors of the 5 components were then compared of the unknown retention factors.…

    • 489 Words
    • 2 Pages
    Good Essays
  • Best Essays

    This study on Chromatographic Analysis of a Commercial Analgesic’s Active Component seeks to separate, identify, quantify and analyze the active component found in Biogesic®, which may be useful for public awareness despite its wide acceptance and availability in the market. Furthermore, this study applies thin layer chromatography (TLC) technique since it is the simplest, cheapest yet most effective approach in terms to the study’s objectives. The TLC method implies Rf (Rate of flow) values where it is given by the distance from origin to center of subtance spot over the distance from origin to solvent front. As a result, the TLC analysis of Biogesic® yields the following Rf values where the given distance from origin to solvent front measures 59 mm: 1.) acetaminophen has a Rf value of 0.48; 2.) aspirin has a Rf value of 0.64; 3.) caffeine has a Rf value of 0.22; 4.) Biogesic® sample has a Rf value of 0.48 ; 5.) ibuprofen has a Rf value of 0.73; and 6.) mefenamic Acid has a Rf value of 0.76. Thus, the study shows that by having equal Rf values of about 0.48, Biogesic®’s most active component is acetaminophen (paracetamol), a relatively polar compound having a molecular formula C8H9NO2(MW= 151.1626). [1]…

    • 1868 Words
    • 8 Pages
    Best Essays
  • Good Essays

    Thin Layer Chromatography is done by using a thin layer of absorbent material that is attached to a glass layer. The absorbent material is the stationary phase, which is a silica gel. Silica gel allows for particles to bind to. A small amount of the mixture that is being analyzed in applied to the bottom and placed in a pool of solvent and placed into a chamber. The solvent is the mobile phase and it slowly rises up the TLC plate. The components rise with the solvents and they differ in solubility. Some components will rise higher than others so this is how they are separated. (Williamson 164)…

    • 650 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Amino Acids Lab

    • 590 Words
    • 3 Pages

    A stationary phase is on the plate; in this lab silica was used. A small amount of the sample being analyzed is spotted onto the bottom of the plate. A small amount of solvent with the appropriate polarity is put in container. This is called the eluent. The plate is placed upright in the container, and solvent will move up the plate via capillary motion. The samples will be moved up the plate, and how far they travel on the plate depends on the polarity of the samples. Because silica is a polar substance, nonpolar substances will travel the most since they interact the least with the stationary phase. The plate can then be analyzed to determine the components of a sample. TLC can be analyzed through calculating the Rf factor, which is a ratio of a sample’s distance traveled to the solvent’s distance traveled. The Rf value can be used to identify compounds, and to determine polarity relative to other…

    • 590 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Column chromatography was invented by Tswett in 1906 so that his study of the chemistry of chlorophyll could be facilitated. Tswett made significant advances in the method and demonstrated its applicability to the separation of many different kinds of mixtures. Column chromatography rapidly found application in all areas of chemistry and is used extensively today because it is a simple but powerful tool for the separation of pure compounds from a complex mixture. It cannot affect the same degree of separation as TLC, but its advantage over TLC is the fact that large amounts of mixtures (over 5 g) can easily be treated by this method. There are, however, a number of important similarities between TLC and column chromatography which, when the two methods are used in complementary fashion, allow preparative separations to be accomplished easily and quickly. The same comments that were made concerning adsorbents and solvents for TLC apply also to column chromatography. In particular, by using TLC initially to determine a solvent system for separation of a mixture, one can quickly find the solvent system that will effect separation of the same mixture on a column of the same adsorbent. (In other words, if a particular solvent system effects separation on, say, alumina with TLC, a very similar solvent system will effect separation of a column, provided that alumina of the same type is used as adsorbent.…

    • 721 Words
    • 3 Pages
    Good Essays
  • Good Essays

    By examining the functional groups of the analgesic drug components, the relative strength of their polarities can be determined. For example, if a compound contains carboxylic acid, alcohol or amine functional groups, it should be very polar. If a compound contains ketone, aldehyde, ester, amide, or ether functional groups, it should be polar. Lastly, if a compound…

    • 522 Words
    • 3 Pages
    Good Essays