Preview

Chromatographic Seperation of Fluorene and Fluorenone

Good Essays
Open Document
Open Document
721 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Chromatographic Seperation of Fluorene and Fluorenone
Chromatographic Separation of Fluorene and Fluorenone
Abstract: A mixture of Fluorene (1) and Fluorenone (2) was separated by column chromatography.
Chemical Equation: Fluorene (1) Fluorenone (2) Mp 114C mp 83C MW 166.22 MW 180.21

Introduction:
Column chromatography was invented by Tswett in 1906 so that his study of the chemistry of chlorophyll could be facilitated. Tswett made significant advances in the method and demonstrated its applicability to the separation of many different kinds of mixtures. Column chromatography rapidly found application in all areas of chemistry and is used extensively today because it is a simple but powerful tool for the separation of pure compounds from a complex mixture. It cannot affect the same degree of separation as TLC, but its advantage over TLC is the fact that large amounts of mixtures (over 5 g) can easily be treated by this method. There are, however, a number of important similarities between TLC and column chromatography which, when the two methods are used in complementary fashion, allow preparative separations to be accomplished easily and quickly. The same comments that were made concerning adsorbents and solvents for TLC apply also to column chromatography. In particular, by using TLC initially to determine a solvent system for separation of a mixture, one can quickly find the solvent system that will effect separation of the same mixture on a column of the same adsorbent. (In other words, if a particular solvent system effects separation on, say, alumina with TLC, a very similar solvent system will effect separation of a column, provided that alumina of the same type is used as adsorbent.
Results and Discussion: Of the initial 100mg of Fluorene (1), 8.2mg was recovered. Of the initial 100mg of Fluorenone (2), 52.8mg was recovered. These calculated into a percent recover of:
8.2mg/100mg = 8.2% for the Fluorene (1) and 52.8mg/100mg = 52.8% for the Fluorenone (2). These numbers were



References: “Techniques in Organic Chemistry”, J. R. Mohrig, C. N. Hammond, P. F. Schatz, W. H. Freeman and Co., NY, 2006, p 116. “Chromatographic Separation of Fluorene (1) and Fluorenone (2)”, E. Kho, UHH, HI, 2009. “http://www.chemistry.adelaide.edu.au/cdrom/PracCDROM/2nd_Year/ChemIIE/Semester1/ChemIIE_Expt01.pdf”

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Organic Lab 2583-4

    • 503 Words
    • 3 Pages

    Percent Recovery: Indicates how much of the active ingredient was able to recover after the purification method.…

    • 503 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Pharmacology Intro Q&a

    • 573 Words
    • 3 Pages

    4. A heart failure patient shows digoxin toxicity. She received 125 mcg as standard dose. Serum levels were reported to be 2ng/mL (2 mcg/L). Target therapeutic level is 0.8ng/mL. What dose should she receive?…

    • 573 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    ¬¬The goal of the first part of this experiment was to achieve a 50-50 conversion of fluorene to Fluorenone. In order to achieve the goal of the experiment fluorene was oxidized to Fluorenone. The hydroxide ions from the sodium hydroxide in the presence of Stark’s catalyst would be able to de-protonate the acidic fluorene protons. This would result in the formation of a carbanion which attacks the oxygen from the air resulting in the formation of a hydroperoxide and eventually a ketone (after removal of water). Since the goal was to have a mixture of 50% fluorene conversion, Thin Layer Chromatography (TLC) was carried out several times to assess the rate of the reaction. In order to separate the aqueous composites from the solution…

    • 1464 Words
    • 6 Pages
    Powerful Essays
  • Better Essays

    Panacetin Essay

    • 943 Words
    • 4 Pages

    Theory: The percent composition is calculated for accuracy and to conclude the “label is accurate”. The formula for the percent composition is adding the sums of all the extracts, then dividing the total sum by each of the three (3) individual extract; Sucrose, Aspirin, Unknown. By separating…

    • 943 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    Hydrate Lab

    • 445 Words
    • 2 Pages

    The percent of any compound or element can be found by using a certain formula. This formula is: % of element = Mass of element or compound/Total mass of compound x100. In order to use this formula the mass of the water and the total mass of the hydrate had to be found. The lab workers…

    • 445 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    80 percent would be the percentage of Guanine because Cytosine is 20 percent and 80 plus 20 equals 100.…

    • 401 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Final weight of product vial A = 40.664-40.867=0.203g; vial B = 38.784-38.869 = 0.085g 0.203+0.085g = 0.288g…

    • 350 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Purification of the product was then obtained by extraction. The principle of extraction as a purification method was based on the difference in solubility between impurities and product.…

    • 2267 Words
    • 10 Pages
    Better Essays
  • Powerful Essays

    Paper Chromatography

    • 1569 Words
    • 7 Pages

    Chromatography is divided into several types. Column Chromatography uses a powder adsorbent placed in a vertical glass column as its stationary phase and its solvent as the mobile phase. The mixture is distributed as the solvent moves down the column. Thin Layer Chromatography, or TLC, also uses a powder absorbent which is fixed to a metal, plastic or glass plate as its stationary phase. The mixture to be analyzed is placed near the bottom of the plate and it is then submerged to a specific amount of solvent which is the mobile phase. Gas Chromatography requires a long metal or glass column containing a high boiling liquid which would serve as the stationary phase and an inert gas to flow on the column as the mobile phase. Lastly, Paper Chromatography uses a cellulose chromatogram paper as its stationary phase and the solvent as the mobile phase.…

    • 1569 Words
    • 7 Pages
    Powerful Essays
  • Satisfactory Essays

    Organic Chemistry

    • 325 Words
    • 2 Pages

    Crow, Robert T; Herman Carolyn; Silverman Brian. A Three-Component Extraction Using Biological Molecules: An Undergraduate…

    • 325 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Hplc System Stability

    • 1909 Words
    • 8 Pages

    36. Wren, S. A. C., and Tchelitcheff, P. (2006) Journal of Chromatography A 1119, 140-146.…

    • 1909 Words
    • 8 Pages
    Better Essays
  • Powerful Essays

    Pharmacy Guide

    • 94095 Words
    • 377 Pages

    Acquisitions Editor: John Goucher Managing Editor: Matt Hauber Director of Nursing Production: Helen Ewan Senior Managing Editor/Production: Erika Kors Senior Production Editor: Marian Bellus Designer: Holly McLaughlin Manufacturing Coordinator: Margie Orzech Production Services/Compositor: Maryland Composition/ASI 13th Edition Copyright 2010 Wolters Kluwer Health Lippincott Williams & Wilkins. Copyright 2006, 2001, 1996, 1991, 1986 by Lippincott Williams & Wilkins. All rights reserved. This book is protected by copyright. No part of this book may be reproduced or transmitted in any form or by any means, including as photocopies or scanned-in or other electronic copies, or utilized by any information storage and retrieval system without written permission from the copyright owner, except for brief quotations embodied in critical articles and reviews. Materials appearing in this book prepared by individuals as part of their official duties as U.S. government employees are not covered by the above-mentioned copyright. To request permission, please contact Lippincott Williams & Wilkins at 530 Walnut Street, Philadelphia PA 19106, via email at permissions @ lww.com or via website at lww.com (products and services). This textbook is intended to provide the underpinnings of the methods used in pharmaceutical calculations. The drugs, drug products, formulas, equations, uses, and doses are included in this textbook for the sole purpose of providing examples in the types of calculations described. The information is not intended for use in any practice or clinical application, nor should it be considered or construed as specific for any individual patient nor as a substitute for current drug package inserts. The author, editors, and…

    • 94095 Words
    • 377 Pages
    Powerful Essays
  • Powerful Essays

    Accuracy (% recovery): The accuracy parameter conducted by using the standard addition method. The proposed method afforded a recovery of 99.49–101.54% after the additional standard drug solution…

    • 921 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    The Royal and Pontifical University of Santo Tomas The Catholic University of the Philippines College of Education, Department of Food Technology Experiment #3 Food Toxicants FT 104 B Food Chemistry II Group 2 Submitted by: Collado, Dan Mark R. Eustaquio, Shekinah A. Isuga, Aedrian Lorenzo E. Luna, Maria Nikkita H. Santos, Kim Joshua C. Sombrano, Mary Chenneth S. Torres, Vincent Joseph P. Villaceran, Danielle P. Submitted to: Asst. Prof. Eufemio Barcelon Ph.D Submitted on: September 18, 2013 I. Results…

    • 1538 Words
    • 7 Pages
    Good Essays
  • Satisfactory Essays

    Chemistry Ia

    • 386 Words
    • 2 Pages

    = ± 0.13%± % ∆ Concentration of FA3= ± % ∆ Amount of FA3 + ± % ∆ Volume of FA3 solution= ± [0.13% + (0.12/250.00 x 100%)= ± 0.18%± % ∆ Amount of FA3 in 20.0cm3 of FA3= ± [0.18% + (0.06/20.00 x 100)%]= ± 0.48%± % ∆ Amount of FA2 used= ± % ∆ Amount of FA3 in 20.0cm3 of FA3= ± 0.48%± % ∆ Concentration of FA2= ± (% ∆ Amount of FA2 used + % ∆ Average volume of FA2 used)= ± [ 0.48% + (0.10/25.43 x 100%)]= ± 0.87% % ∆…

    • 386 Words
    • 2 Pages
    Satisfactory Essays