Preview

Experiments

Better Essays
Open Document
Open Document
956 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Experiments
Abstract
Separation of the compound ethanol from alcoholic beverages, such as vodka, involves the process of distillation. Distillation is the separation of volatile substances mixed with nonvolatile substances by boiling the mixture to alter the phase of the volatile substance. The researchers used the simple distillation set up to conduct the experiment. 25 ml of The Bar Vodka was used and 7 ml of distillate was collected before a temperature of 95 degrees Celsius was reached. Collected distillate was then subjected to a flammability test to confirm ethanol content. The percent ethanol was computed to be 24%.

Introduction Distillation is a method of separation for homogenous mixtures, which are composed of both volatile and nonvolatile substances [1]. It involves the volatile substance to undergo a phase change from a liquid to a gas, and then back to a liquid. The process required for the mixture to be heated at a certain temperature in order for the volatile substance to evaporate and the nonvolatile substance to remain a liquid. As the volatile substance evaporates, it will pass through a condenser, which transforms it back to a liquid and therefore separates the substance from the original mixture. The principle behind this process is the difference in the boiling points of each of the components of the mixture. Boiling point is the temperature at which a liquid becomes a gas. The nonvolatile substance remained as a liquid because of its high boiling point, allowing the volatile substance, which had a low boiling point, to evaporate.

Vodka was the mixture to be distilled in the experiment. Vodka is an alcoholic beverage that contains the compound ethanol (C2H5OH) mixed with water. Ethanol is a compound that belongs to the functional group called alcohols. The distinguishing characteristic of these compounds is the presence of the -OH group that is connected to a hydrocarbon segment [2]. The goal of the experiment is to separate the alcohol content



References: 1. Henold, K.L., & Walmsley, F. (1984). Chemical principles, properties, and reactions. Reading, Mass.: Addison Wesley, pp. 24-26. 2. McMurry, J, (2012). Organic chemistry. Belmont, CA: Brooks/Cole, Cengage Learning, p.631 3. Bauer, R., Birk, J., & Marks, P. (2009). Introduction to chemistry:A conceptual approach. NY: McGraw-Hill, pp. 22 & 645

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Orgo Lab 5

    • 539 Words
    • 3 Pages

    This experiment was carried out as described in Class Pak. The heat source power was set to 3 for fractional distillation and to 2 for simple distillation. For both processes, aluminum foil was wrapped around the heat source and flask to trap the heat and speed up the process.…

    • 539 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    The purpose of this experiment was to carry out the dehydration of 2-methylcyclohexanol or 4-methylcyclohexanol by heating the alcohol in the presence of phosphoric acid. The alcohol was a mixture of cis and trans isomers, so it might have exhibited an Evelyn effect. It was also looked at if the products showed the Zaitsev’s rule, where in an elimination reaction, the most stable alkene was favored, which was usually the most substituted one and also the major product, which was the product with more % composition that was found out in the analysis. The % composition of the yield was found out by using the % composition of the products and a gas chromatography by measuring the peak areas for each gas chromatogram. The operations used in this lab in their order of usage were: Simple distillation, mixing, washing liquids, drying liquids, gas chromatography.…

    • 698 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Masterson, W, Hurley, C. Chemistry: Principles and Reactions. 6th ed. Belmont, CA: Brooks/Cole Cengage Learning; 2009.…

    • 1743 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    Introduction: Simple distillation is a commonly used method to separate and purify the mixtures of organic liquids into their original components. Mixtures of two miscible liquids with two different boiling points were separated. Therefore, it can be said that the two organic compounds are separated by exploiting the different boiling temperatures of the liquids. Both vaporization and condensation were used in this experiment. The two organic compounds used in this experiment were ethyl benzene and cyclohexane, which have the boiling point of 136°C and 80.74°C, respectively. This experiment resulted…

    • 1803 Words
    • 8 Pages
    Good Essays
  • Powerful Essays

    Vodka, one of the world’s most popular distilled beverages, is a clear liquid that is distilled from a fermented substance such as potatoes, grain, or sugar beet molasses. Although vodka is traditionally drunk in the Eastern European and Nordic countries of the “Vodka Belt”, its popularity elsewhere owes much to its usefulness in cocktails and other mixed drinks, such as the Bloody Mary, the Screwdriver, the vodka tonic, and the vodka martini.…

    • 5922 Words
    • 24 Pages
    Powerful Essays
  • Good Essays

    Orgo Experiement 1

    • 790 Words
    • 4 Pages

    There are two types of distillations used in this experiment. The first method is simple distillation. This process is the simplest method and sometimes does not provide acceptable results. Simple distillation is most valued when only one of the compounds in the binary mixture is volatile, thus the volatile compounds distills out leaving the nonvolatile compound behind. Simple distillation requires a large discrepancy between boiling points of the compounds (≥40-50oC) to be separated to gain meaningful purity of the distillate.…

    • 790 Words
    • 4 Pages
    Good Essays
  • Good Essays

    In this experiment we aim to demonstrate that we can separate two volatile compounds from a mixture due to the different chemical properties of each compound. We will accomplish this by a separation procedure known as distillation, which relies on each compound having a distinct and separate boiling point. Our pure products will be analyzed with gas chromatography to determine the success of the distillation.…

    • 692 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    chem paper

    • 259 Words
    • 1 Page

    The purpose of this experiment was to find the boiling point of an unknown solution in order to find its identity from the chart of substances. Also the unknown substance was compared to distilled water on viscosity and on surface tension. The unknown solution letter was D and 25 ml were obtained in a 50 ml graduated cylinder. We also obtained 25 ml of distilled water in a 50 ml graduated cylinder. The unknown solution’s viscosity and surface tension were compared to those of the distilled water, and the unknown solution scored lower in both categories compared to distilled water. The initial temperature of the unknown solution was 22.2 degrees Celsius. The boiling point of the unknown solution in the first trial was 82.3 C; second trial was 80.3 C and third was 84 C. These boiling points could not be exact measurements because the measurements were not completely accurate to one another, and the solution is not 100% pure. Isopropyl alcohol is the unknown according to the results. The percentage yield of the experiment was 102.34% and the percent error was .06. Boiling point is the temperature in which the vapor pressure of a liquid becomes equal to atmospheric pressure; this is the reaction that Isopropyl alcohol had in this experiment. The most volatile solution is pentane because it has a higher vapor pressure of 525.0 mmHg and the lowest volatile solution is Isopropyl alcohol because it has the lowest vapor pressure. Acetone has the lowest boiling point. Isopropyl alcohol started splashing before the water started boiling and this is the reason to conclude Isopropyl was the unknown…

    • 259 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Gas Chromatography Lab

    • 940 Words
    • 4 Pages

    The purpose of this experiment was to learn how to use distillation and gas chromatography to separate and identify different compounds from a given mixture. There are several kinds of distillation methods. However, the method that we used in this experiment was fractional distillation. This method is used when trying to separate two different volatile compounds whose boiling points differ by 40-50°C or more. If the boiling points are too close, this method will not work because the two compounds will begin evaporating at close temperatures and will condense down to the receiving flasks at relatively the same times. This will not create an ideal separation. The apparatus used for this type of distillation…

    • 940 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Chemistry Lab

    • 660 Words
    • 3 Pages

    Method: Distillation is based on the fact that the matter can exist in three phases - - solid, liquid and gas. As the temperature of a pure substance is increased, it passes through these phases, making a transition at a specific temperature from solid to liquid (melting point--mp) and then at a higher temperature from liquid to gas (boiling point--bp). Distillation involves evaporating a liquid into a gas phase, then condensing the gas back into a liquid and collecting the liquid in a clean receiver. Substances that have a higher boiling point than the desired material will not distill at the working temperature, and remain behind in the flask. Applied to the preparation of alcoholic beverages, alcohol has a lower boiling point than water (and sugar) and thus distillation can separate the alcohol from the wine.…

    • 660 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Distillation is a commonly used method for purifying liquids and separating mixtures of liquids into…

    • 420 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    The purpose of this project is to identify an unknown organic acid (X) by conducting various experiments to determine the acid’s unique properties. By determining selected constant properties of the unknown and then comparing these properties to the constant properties of known substances, it is possible to identify an unknown substance. The properties used to identify the unknown must be intensive, or independent of amount. Both chemical properties and physical properties are intensive properties used in determining the identity of an unknown (Maserton, p. 15).…

    • 1577 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Distillation Lab

    • 758 Words
    • 4 Pages

    Distillation is a process in which compounds that are in the same solution become separated by their boiling points. For this to occur, a heterogeneous mixture has to be placed into a distiller, in this experiment a solution of 1:1 water and methanol was distilled. When distilling substances there are various methods of distillation that can be used. In this lab, simple and fractional distillation was used.…

    • 758 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Experimental Research

    • 382 Words
    • 2 Pages

    Randomization is the separating of experiment participants by random selection. This way test results to be more conclusive because results are not altered by factors of age, education, culture, or gender. In this experiment teachers will be divided into two separate groups randomly. Some participants will use anti-bacterial gels and other participants will not use anti-bacterial gels. Separate statistics will be collected for each group to determine outcome of experiment.…

    • 382 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    When the sulfuric acid was combined with the isopentyl alcohol and acetic acid, the mixture turned red (due to residue of another chemical remaining on glassware). During the wash of the organic layer, two distinct layers appeared, a yellow and a clear. The drying process took around 20 minutes through gravity filtration. The distillation process took around 15 to 20 minutes to begin boiling at 137˚ C and stay at 140˚ C for the remainder of distillation. After reaching optimum temperature distillation was complete within ten minutes. After the experiment was completed the final product was 97% ester, 3% alcohol.…

    • 627 Words
    • 3 Pages
    Good Essays