Preview

Experiment C Identification And Separation Of Dyes By TLC 1

Good Essays
Open Document
Open Document
641 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Experiment C Identification And Separation Of Dyes By TLC 1
Experiment C: Identification and Separation of Dyes by TLC

Pre-lab Properties:
Ethyl acetate, ethanol, silica, azobenzene, azulene, 4-(p-nitrophenylazo) resorcinol, methyl red, bromocresol green (solubilities in water and ethanol)

Purpose: To identify compounds from an unknown mixture using TLC

Up to 100% of missed points can be recovered from this lab
Watch the video: http://www.youtube.com/watch?v=e99nsCAsJrw (MIT)
TLC plates are near the main hood
DO NOT BREAK CAPILLARY TUBES
Keep spots small and concentrated (video)
Stop TLC before solvent runs over the top (video)
While waiting for plate development, update procedure and spot next plate
Dispose of all solvents in waste containers
Report your own TLC plate distances in procedure along with showing full-scale drawings
Make sure bottom of TLC plate wets evenly
TA will provide unknown, RECORD UNKNOWN NUMBER!
Make sure capillaries are clearly “square at end”

Post-lab Reminders:
Check Policies and Procedures
Report unknown number
Optimum eluent for TLC
Complete table (below) for optimum eluent conditions
Structures of unknowns
Considering the structures of the dyes, explain the trend in Rf values

Dye Name
Solvent (cm)
Spot (cm)
Rf
Color
Azobenzene

Azulene

4-(p-nitrophenylazo)resorcinol

Methyl red

Bromocresol green

Unknown Spot 1

Unknown Spot 2

Unknown Spot 3

Rf = (spot distance) / (solvent front)

Directions

Key terms (define): Stationary phase, mobile phase, elutropic series, adsorbent, eluent, spotting, development solvent, paper wick, solvent front, Rf value

WATCH THE VIDEO ON THE NOTES PAGE!

Introduction: You will try to identify the components of an unknown mixture of colored compounds. The mixture will have three compounds from the following: azobenzene, azulene, 4-(p-nitrophenylazo)resorcinol, methyl red, bromocresol green. You can identify the components by separating them using thin layer chromatography (TLC) and comparing their Rf values with those of the
Continue Reading
View Writing Issues

You May Also Find These Documents Helpful

  • Good Essays

    Dye Lab for Chem 205
    • 2366 Words
    • 10 Pages

    Dye Lab for Chem 205

    The last means by which light could be generated is through chemiluminescence. In such a case a chemical reaction occurs, causing an excitation of the product. As this product decays into its standard state, light is emitted. This form of luminescent is different from the previous two in the sense that no absorption of light is required to induce the glow. The glow results from the product of the chemical reaction having to be in an exited state or of higher…

    • 2366 Words
    • 10 Pages
    Good Essays
    Read More
  • Good Essays

    Lab Paq-Lab Two Chromatography of Food Dyes
    • 1211 Words
    • 5 Pages

    Lab Paq-Lab Two Chromatography of Food Dyes

    The second lab deals with the chromatography of food dyes which means you figure out what kind of compounds are used in a product like food color etc. by comparing the result to FD&C Food Dyes. You use six different food dyes, four food colors out of the store, two different Kool Aid powder and four different colors of candy like M&Ms you use for the chromatograph. At the end you try to find which food dyes are in the other products.…

    • 1211 Words
    • 5 Pages
    Good Essays
    Read More
  • Powerful Essays

    Tlc (Fluorene, 9-Fluorenol, 9-Fluorenone )
    • 1400 Words
    • 6 Pages

    Tlc (Fluorene, 9-Fluorenol, 9-Fluorenone )

    1. In table format, provide the Rf values you recorded for each of the 3 compounds in Part I. List compound on one axis of your table and solvent system on the other. If multiple spots were present for a compound, give Rf value for each component and state if the component was major or minor.…

    • 1400 Words
    • 6 Pages
    Powerful Essays
    Read More
  • Good Essays

    Chemical Changes Lab Report

    • 792 Words
    • 4 Pages

    Chemical Changes Lab Report

    B. You know what color phenolphthalein and bromothymol blue turn when testing an acid or a base. Use the empty pipet in the Auxiliary Supplies Bag to test several (at least 3) household items including household cleaning products with bromothymol blue. Rinse the pipet well before using it on to the next household chemical. When finished with this experiment rinse the pipet well and return it to the Auxiliary Bag for use in future experiments. Name the items tested and record their results. What do these results mean?…

    • 792 Words
    • 4 Pages
    Good Essays
    Read More
  • Satisfactory Essays

    Dye Analysis Lab Report
    • 978 Words
    • 4 Pages

    Dye Analysis Lab Report

    2) Based on maximum absorbance of the dye tested, select the appropriate wavelength on spectrometer.…

    • 978 Words
    • 4 Pages
    Satisfactory Essays
    Read More
  • Satisfactory Essays

    Adulterated Herb Lab
    • 516 Words
    • 3 Pages

    Adulterated Herb Lab

    My group had the unknown samples numbered 521, 522, 523, and 524. We prepared each sample with the hexane extract, so that when we spotted each sample on the TLC plate it would give us accurate results. We then compared the Rf of these plates to previous Rf’s as well as the odors from the chemical to identify every compound. Since our sample 521, reacted both DNPH when tested we concluded that it would be an aldehyde which narrowed our choices. We then compared the Rf values of each sample and concluded that our samples with respective to their number were the following: caraway, cloves, and coriander. We noticed that both sample 521 and 524 reacted with DNPH and had similar Rf values, meaning that within sample 524, there must be some caraway. Unfortunately, like I stated before we weren’t able to finish the lab and we never got to do plate number…

    • 516 Words
    • 3 Pages
    Satisfactory Essays
    Read More
  • Good Essays

    Spinach Leaves
    • 626 Words
    • 3 Pages

    Spinach Leaves

    (2) The most common stationary phases or adsorbents using in TLC are silica gel, alumina, and cellulose. For each, (a) draw its chemical structure and (b) label it as polar or non-polar.…

    • 626 Words
    • 3 Pages
    Good Essays
    Read More
  • Good Essays

    Organic Chemistry Practice Exam
    • 1769 Words
    • 8 Pages

    Organic Chemistry Practice Exam

    Alkene (stretch) Aromatic (stretch) Alkyne (stretch) Aldehyde (stretch) Ketone (acyclic) Carboxylic Acid Ester Amide Anhydride Alcohols, ethers, esters carboxylic acids Alcohols, phenols Free H-bonded Carboxylic acids Primary and secondary amines Nitriles Nitro…

    • 1769 Words
    • 8 Pages
    Good Essays
    Read More
  • Satisfactory Essays

    1A
    • 432 Words
    • 3 Pages

    1A

    7. Record your observations after 20 minutes in the table below. Measure Df (in cm) for the solvent. Measure the Ds (in cm) for each color that you see on the coffee filter (there may not be three). Calculate the Rf for each color using the equation: Rf = Ds/Df…

    • 432 Words
    • 3 Pages
    Satisfactory Essays
    Read More
  • Good Essays

    Its a Gas Lab
    • 388 Words
    • 2 Pages

    Its a Gas Lab

    Purpose: The purpose of this lab is to look at some properties of three common compounds,…

    • 388 Words
    • 2 Pages
    Good Essays
    Read More
  • Powerful Essays

    Chromatography of M&M and Ink Dyes
    • 1942 Words
    • 8 Pages

    Chromatography of M&M and Ink Dyes

    Separations: Chromatography of M&M and Ink Dyes Almost all substances we come into contact with on a daily basis are impure; that is, they are mixtures. Similarly, compounds synthesized in the chemical laboratory are rarely produced pure. As a result, a major focus of research in chemistry is designing methods of separating and identifying components of mixtures. Many separation methods rely on physical differences between the components of a mixture. For example, filtration takes advantage of substances being present in different states (solid vs. liquid); centrifugation relies on differences in density; and distillation makes use of differences in boiling points of the various components. Chromatography exploits differences in solubility and adsorption. The word chromatography, which is derived from two Greek words literally meaning "color writing", was coined at the beginning of this century when the method was first used to separate colored components of plant leaves. Today, the name is a bit misleading, because most forms of chromatography do not depend on color. Several types of chromatography are commonly used, among which are paper chromatography, thin-layer chromatography or TLC, liquid-liquid chromatography, gas chromatography, and high performance liquid chromatography or HPLC. Chromatography is so useful that some form can be found in most scientific laboratories around the world. For example, in forensic chemistry crime laboratories, the FBI maintains a library of chromatograms of inks that are used commercially. In the first case in which chromatography of inks were used, a man in Miami falsified travel and expense vouchers. However, the ink pen he used had ink that wasn't available commercially until 3 years after the trips had taken place. The theory behind chromatography is to allow a mixture of different chemicals to be distributed or partitioned between a stationary phase and a mobile phase (eluent or solvent). The mobile phase may be a liquid or…

    • 1942 Words
    • 8 Pages
    Powerful Essays
    Read More
  • Good Essays

    Kine 198 Lecture Study Guide: Health And Fitness
    • 752 Words
    • 4 Pages

    Kine 198 Lecture Study Guide: Health And Fitness

    Know a brief description of each substance and whether they are man made or natural.…

    • 752 Words
    • 4 Pages
    Good Essays
    Read More
  • Good Essays

    Cosmetics Animal Testing
    • 1181 Words
    • 5 Pages

    Cosmetics Animal Testing

    This method involves three different steps of classification. One: is analyzing the ingredients in the product being tested, this step has extremely limited information on what is being used. Two: this step involves scientists having minimum knowledge and data about only the major ingredients that are in the product. Three: this class allows scientist to know and understand all the ingredients that are being used in the product and allows them an exceptional conclusion of what reactions will…

    • 1181 Words
    • 5 Pages
    Good Essays
    Read More
  • Satisfactory Essays

    Determination of unknown organic compound
    • 406 Words
    • 2 Pages

    Determination of unknown organic compound

    Water Ether 5% NaOH5% Na2CO3 5% HClConc. H2SO4 Unknown Sample + + + + + + Basic Compound…

    • 406 Words
    • 2 Pages
    Satisfactory Essays
    Read More
  • Good Essays

    Chara Dyes Analysis
    • 967 Words
    • 4 Pages

    Chara Dyes Analysis

    The results of the experiments carriedout for the degradation of fabric dyes from aqueous solution using Chara and Chara beads are discussed below.Various analytical techniques like UV-Vis, FTIR spectroscopy were used to confirm the decolorization as UV-Vis spectroscopy; FT-IR spectroscopy and toxicity bioassay were truly used [14]. Also, Fourier transform infrared spectroscopy (FT-IR) is widely used to confirm the product obtained after decolorization of dye degradation experiments [15]. It helps in determination of reaction progress step by step, as the decomposition and formation of new compounds during the reaction can be confirmed using this technique.…

    • 967 Words
    • 4 Pages
    Good Essays
    Read More

Related Topics