Preview

Comparing Fermentation Rate of the S. Cerevisiae Yeast in the Presence of Mgso4, Naf and Sodium Pyruvate

Better Essays
Open Document
Open Document
1006 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Comparing Fermentation Rate of the S. Cerevisiae Yeast in the Presence of Mgso4, Naf and Sodium Pyruvate
Syl Rogers
Bio 210

Comparing Fermentation Rate of the S. cerevisiae Yeast in the presence of MgSO4, NaF and Sodium Pyruvate

Hypothesis
In the fermentation of rate of yeast, S. Cerevisiae, there will be a higher/ faster rate of ethanol production, However, using catalytic enzymes would make the rate more faster, and MgSo4 will have a higher rate of CO2 than that of NaF and Sodium pyruvate as it act as a more better catalytic enzyme than the others.

Methods
Preparation of Tubes
A solution of yeast and glucose was prepared with different concentration of enzymes. In All the tubes water, 0.3M glucose and yeast was placed; with the exception of some tubes in which 0.2M MgSo4 and 2.5mL and 1.4ML 0.2 NaF was placed respectively. In another tube was placed both MgSO4 and NaF. The different solutions were prepared and placed in separate tubes for the experiment. A 45oC water bath was setup to be used for the fermentation process.
Data acquiring
The tubes were placed in the water bath. A stop watch was used which aids in determining the reaction time. After Every 15 min, data was collected from all tubes by measuring the amount of CO2 being produced. This process continued for a total of 75min allowing enough time for Fermentation to occur in all tubes.

Result
For the first 15min, In the tube containing 8.5mL water and 2.5mL yeast only, the rate of the reaction was 0mm/min whiles the tube with the glucose has a rate of 233.864mm/min. This is followed by the tube containing 2.5mL of MgSo4 which has a rate of 165.8573mm/min. The tube containing the MgSo4 and NaF has a rate of 69.85mm/min which is followed by the 1.24mL NaF tube that has a rate of 40.63mm/min followed by 2.5mL NaF tube which has a rate of 31.08mm/min which was the lowest.
After 30minutes, the tube containing only water and yeast has a rate of 0mm/min whiles the tube with the glucose has a rate of 208.97mm/min. This is followed by the tube containing the MgSo4 which has a rate of 174.1137mm/min. The

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Tiny Bubbles Lab

    • 362 Words
    • 2 Pages

    For this experiment our dependent variable was the paper with yeast on it, and our independent variable was the concentration of Hydrogen Peroxide we put in each solution. We tested the amount of time it took for the peroxide to break down yeast at 3%, 2.25%, 1.5%, .75% and 0% concentration. The fastest reaction time was 1.7 at 3% concentration. We…

    • 362 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Cell Membranes lab report

    • 617 Words
    • 7 Pages

    At intervals of 20, 40, and 60 minutes, the tubes are removed. Record the volume of gas produced in each fermentation tube. Each tube is graduated in tenths of a milliliter. (HINT: Look at the amount of gas, not the level of the liquid.)…

    • 617 Words
    • 7 Pages
    Satisfactory Essays
  • Satisfactory Essays

    You may not get accurate results. Although sugar is the primary nutrient used, when a microbe runs out of it, protein or other nutrients will be attacked This causes changes in the color of the medium because of the pH indicator added to detect acid production. When proteins are used, alkaline by-products are produced and the medium can changes colors. If you let these sugar tests go for more than a day, you risk the possibility that the color will have changed and you may misread the test result.…

    • 412 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Aipotu II Lab Report

    • 640 Words
    • 3 Pages

    To conduct this experiment, we used 5 grams of sugar and 2 grams of yeast, but only used half of each for both experiments, so 2.5 grams of sugar and 1 gram of yeast for testing the effect of temperature and 2.5 grams of sugar and 1 gram of yeast for testing the effect of a disinfectant. We then mixed each beaker with 50 mL of water and stirred to fully dissolve the sugar and yeast. Then we used a 10 cc syringe and filled it up and put it in the fermentation tube and then added an additional 5 cc’s of the sugar/yeast solution to the tube. We then sealed the tube with a piece of parafilm and placed it into a water temperature of 10 degrees Celsius and recorded the time that we put them in. We then repeated that procedure but each time putting the tubes into 20, 30, 40, 50 and 60 degrees Celsius water. After 5-minute intervals, up to 20 minutes, we measured the amount of carbon dioxide formed in the fermentation tubes by using a ruler and measuring the amount of millimeters of carbon dioxide was produced. To test the variable of how a disinfectant affected the amount of fermentation, we repeated that procedure except instead of putting each fermentation tube into a certain temperature of water, we used the same temperature of water but each tube had a different amount of bleach in it. We put 0 drops of bleach in the first one and increased by 2 drops of bleach every tube, ending up with 10 drops in the sixth fermentation tube. We monitored the amount of…

    • 640 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    the conditions that were used to achieve this rate. 8mm glucose with 900 glucose carrier proteins.…

    • 581 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Respiration Lab Report

    • 643 Words
    • 3 Pages

    In the first lab, seven test tubes were attained and six of them were filled with the solutions that were listed (Na Pyruvate, MgSO4, NaF, Glucose, Water, and yeast suspension). The last test tube was filled with water. After they were filled with the solutions they were incubated at 37 degrees Celsius for about forty minutes. After the forty minutes passed take the test tubes and measure the height of the bubbles that formed in millimeters.…

    • 643 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Ap Biology Enzyme

    • 425 Words
    • 2 Pages

    1) The purpose of this lab was to determine the rate of enzyme activity under variety of different conditions, such as, different amount of drops of enzymes and different temperature of water. The class measured the pressure in the test tube during the reaction of the substance with, 1.5 ml of H2O2, 1.5ml of H2O and different amounts of enzyme drops, to determine how much oxygen gas is produced during the reaction since the pressure of the test tube will get higher as more oxygen gas is accumulated during the reaction.…

    • 425 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Spf 50 Research Paper

    • 840 Words
    • 4 Pages

    The first plate was labeled with our initials, lab section, one half was called the exposed and the other half was called foiled protected. The second had four sections labeled- Coconut oil, SPF 50, Sunglass and Control. Next, 0.15 ml of yeast was pipetted onto the two separate agars. Then the disposable L-rod spreader was used to spread the liquid so that the agar surfaces are evenly covered. Then the plates were placed in a dark place for 20 minutes. After the 20 minutes the first plate with the exposed half and foiled half, the the foiled half of plate was covered with dark aluminum foil. The second plate had coconut oil, SPF 50, and sunglass lens applied to its designated area on top on the led of the plate, not directly on the yeast. One section was free of any condition on the second plate as an control to compare the other conditions with. Then, both plates were exposed to the UVB source for 1 minute and 50 seconds. Then they were removed and placed upside down in 30 degrees Celsius incubator for 2 days then refrigerated. After this period the colonies should were counted. the survival rate for the first plate with the exposed half and foiled half was calculated. Also find survival rate of each condition( SPF 50, sunglass, and coconut oil) using the control section as the comparing factor was…

    • 840 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Catalase Lab

    • 1797 Words
    • 8 Pages

    This group loaded the reaction chamber with 4 extract soaked disks. They used 3% H2O2 with a pH of 3 and then ran experiment they recorded their data in Table 3.…

    • 1797 Words
    • 8 Pages
    Powerful Essays
  • Powerful Essays

    5 test tubes were filled with glucose standard. The first tube received 1 drop of the glucose standard, the second, 2 drops and so on. Each tube, receiving one drop more than the last. Deionized water was added to tubes one through four, with tube one receiving 4 drops, tube two: three…

    • 1200 Words
    • 5 Pages
    Powerful Essays
  • Better Essays

    First, carbohydrate fermentation was tested in various sugar solutions (glucose, sucrose, arabinose, mannitol, lactose, and galactose) for the unknown. Cells were taken from culture and inoculated into vials filled with a phenol red sugar solution and a filled Durham tube which was turned upside down. The cells were left to grow overnight and observed the next day for color changes and bubble production which gave positive results for carbohydrate fermentation. The next test was a Methyl Red-Vogues Proskauer (MR-VP broth) test for which a sample of the unknown was inoculated into two separate tubes (one for the MR and one for the VP tube) and allowed to grow for at least 24 hours. Next the MR tube was given a methyl red reagent and mixed to observe a color change to bright red.…

    • 3110 Words
    • 13 Pages
    Better Essays
  • Good Essays

    Cellular Respiration Lab

    • 452 Words
    • 2 Pages

    The two types of fermentation that are well known are alcoholic fermentation as well as lactic acid fermentation. Fermentation is vital for many organisms, such as yeast and bacteria, because it allows them to obtain energy required to carry on life processes. Alcoholic fermentation is especially important for human beings, as it is used to produce alcoholic beverages, bread, and many other everyday items that are consumed (Alba-Lois, 2010). On the other hand, lactic acid is a waste product of certain bacteria (Lactobacillales), which is utilized to create many dairy products such as yogurt and cheese. In addition, humans can resort to lactic acid fermentation when oxygen is limited, so it is used as an extra source to obtain oxygen. In our experiment we will be using yeast, a single-celled organism that utilizes sugar as a food source, and it produces energy substances through the breakdown of sugar molecules. Specifically, the type of sugar as a source of food, impacts the speed of fermentation in yeast. In this lab, we will calculate the rate of fermentation in yeast with different solutions of sugar, such as sucrose, fructose, and lactose with glucose being the control. It is important to humans that the yeast uses the best sugar source during fermentation, as it creates important everyday items we consume like bread, alcohol, and…

    • 452 Words
    • 2 Pages
    Good Essays
  • Good Essays

    decrease the amount of substrate reaction will speed up. (The slope of the line will…

    • 1002 Words
    • 6 Pages
    Good Essays
  • Powerful Essays

    In this experiment yeast ferment sugars anaerobically. When yeast ferments the sugars anaerobically, however, CO2 production will cause a change in the weight of the sugar/yeast-solution. This raises a further question: What is the effect of different kinds of sugars on the fermentation process of yeast? The fermentation process was followed at a constant temperature and four different types of sugars were used. By measuring the release of carbon dioxide, we could see what type of sugar had the biggest effect on the fermentation process of yeast, which resulted in Sacharose.…

    • 1136 Words
    • 5 Pages
    Powerful Essays
  • Powerful Essays

    We started setting up our experiment by measuring different molar solutions (0M, 0.25M, 0.5M, 0.75M and 1M) of sugar and putting them into separate bottles, along with one bag (12g) of yeast and 300ml of water. We then attached a tube going from the top of each bottle to separate test tubes which were entirely full of water and were placed upside down in a tub of water, stopping the tube from emptying and…

    • 1723 Words
    • 7 Pages
    Powerful Essays