Preview

Colloid and Test Tube

Satisfactory Essays
Open Document
Open Document
363 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Colloid and Test Tube
Title of Experiment: Colloids and their Properties Experiment Number 2 Date: Dec. 6, 2010

Objective: To determine the properties of colloids and how they function in physiological systems

Materials:

O.1 M CuSO4 * 10% skim milk mixture 3 M HAc 0.2 M K2Cr2O7 0.04 M AgNO3 0.02 M K2Cr2O7 * 1% Gelatin 0.01 M AgNO3 5 Test tubes Dialysis bag

Observations:

Part I.

|Test Tube Number |CuSO4 Solution |Skim Milk |3 M HAc |
|1 |4 mL | | |
|2 | |4 mL | |
|3 | |4 mL |1 mL |

Question: In which tube/s is/are there evidence of curd-formation?

Answer: In test tube 1 and 2, there was no evidence of curd-formation but in test tube 3 there was an evidence of curd-formation

Part II.

Question: Which particles are large enough to be retained by the filter paper?

Observation: The curd-formation in test tube 3 is large enough to be retained by the filter paper.

Part III.

Observation: The CuSO4 from test tube 1 did not migrate through the dialysis bag. When light was held against it, the light passed through it. Test tube 2, the passage of skim milk was indicated by the turbidity outside of the dialysis bag and when light was held against it, the colloidal particles scattered the light.

PART V.

Observation: In test tube 1, the substance becomes heterogeneous mixture. In test tube 2, it has single phase because it remain as a colloid due to the addition of gelatin.

PART VI.

You May Also Find These Documents Helpful

  • Satisfactory Essays

    5. There is a possibility that there was some of the copper (II) chloride left in the beaker due…

    • 440 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Colleus Lab Report

    • 522 Words
    • 2 Pages

    1. A cutting can form an entire new plant if cutting being used has a meristem. If the cutting has no meristem, mitosis will not occur and you will end up with a dead piece of plant material. In order to successfully grow a new plant through a cutting, your plant must have adventitious root growth which in order to deliver water and nutrients to the plant. Adventitious roots are created through cell potency where cells differentiate. The hormone auxin is applied to where the cut was made, and promotes adventitious root growth. If your cutting has adventitious root growth and a meristem it shall form into an entire new plant.…

    • 522 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Erlenmeyer Synthesis

    • 998 Words
    • 4 Pages

    In the third separation of this experiment, the hood in the lab was used. The curds were placed in a 100 mL beaker and extracted using 30 mL of ethyl acetate. The curds were crushed with a stirring rod. This extraction was then gravity filtered through a funnel fitted with the filter paper. A rubber policeman was used to scrape the beaker to get as much casein as possible. This casein was then put aside in the hood safely. Boiling chips were put into an Erlenmeyer flask along with the filtrate collected. This flask was then put inside of the large beaker that was put to heat in the first separation of this experiment…

    • 998 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    What does the test of the jar water indicate? That the starch molecules in the dialysis tubing are larger than the in the tubing therefore they cannot be transferred through the process of osmosis or diffusion.…

    • 354 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Tube 2 Lab Report

    • 603 Words
    • 3 Pages

    Figure 1 shows the average amount of absorbance for each tube, containing different levels of pH. Tube 2 had an acidic pH level, Tube 3 had a neutral pH level, and Tube 4 had a basic pH level. It is indicated that the absorbance rates were the highest for the neutral pH level, with a final absorbance rate of 0.166. This was followed by a basic pH (0.106). The acidic pH level had the least amount of absorbance with a final absorbance rate of 0.069. This reinforces the idea that the ALP enzyme worked best under conditions with a neutral pH and worked the least in an acidic pH environment.…

    • 603 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    4. Which materials diffused from the left beaker to the right beaker Urea, NaCl and glucose diffused…

    • 2843 Words
    • 12 Pages
    Powerful Essays
  • Good Essays

    Physioex9.0 Ex8

    • 643 Words
    • 3 Pages

    2. Describe the result in tube 3. How well did the results compare with your prediction? _ Amylase cannot digest cellulose, so tube #3 is not positive for Benedict’s test.__…

    • 643 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    In the unknown sample T it was determined that Pb, Ba, and Cu were present. Adding NaCl resulted in a white precipitate and based on our data from week one it meant that Pb was present. We centrifuged and separated the mixture from the Pb precipitate. Then by adding H2SO4, another white precipitate was formed. It was found to be Ba due to Pb already been taken out of the solution from before. After once again centrifuging and separating, adding NH3 resulted in a half blue and clear solution. Based on data from week one, Cu had to be present, we then tested the clear solution with Na2C3O4 which resulted in no reaction. Through process of elimination and which reagents resulted in a precipitate being formed it was determined that Pb, Ba, and…

    • 437 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab on Silver Nitrate

    • 282 Words
    • 2 Pages

    In Test tube A you saw the precipitate forming right away. Test tube B the precipitate did not form right away and the solution looked like milk. Test tube C did not mix well with the silver nitrate. The Iodine stayed at the bottom while the silver nitrate collected at the top. Test tube D did absolutely nothing, but get a little cloudy…

    • 282 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Respiration Lab Report

    • 643 Words
    • 3 Pages

    In the first lab, seven test tubes were attained and six of them were filled with the solutions that were listed (Na Pyruvate, MgSO4, NaF, Glucose, Water, and yeast suspension). The last test tube was filled with water. After they were filled with the solutions they were incubated at 37 degrees Celsius for about forty minutes. After the forty minutes passed take the test tubes and measure the height of the bubbles that formed in millimeters.…

    • 643 Words
    • 3 Pages
    Good Essays
  • Good Essays

    diffusion lab reportt

    • 536 Words
    • 3 Pages

    Abstract dialysis tubing is, made of cellulose because it’s a selectively permeable membrane. In this experiment, we are testing to see if the solution in the beaker moves into the dialysis bag. Which because of that,…

    • 536 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chemical Reactions Lab

    • 651 Words
    • 3 Pages

    the filter paper or in the decanting of the liquid. The majority of the copper…

    • 651 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Which materials diffused from the left beaker to the right beaker? NaCl, Urea, and Glucose at MWCO 200…

    • 760 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    Lab Questions

    • 1384 Words
    • 6 Pages

    The milk has changed from a liquid to a more solid consistency; clear, amber fluid is present in the upper portion of the tube above the solid material; a white ring of litmus has formed at the bottom of the tube, and litmus has formed a pink band at the surface of the clear liquid as well.…

    • 1384 Words
    • 6 Pages
    Good Essays
  • Powerful Essays

    Prior to the experiment, a 600 mL capacity glass beaker was obtained from the front of the laboratory. The beaker was weighed on a digital scale and its mass was determined to be 213.7 grams. A galvanized iron nail and a lump of steel wool was then collected from the front of the laboratory and the zinc coating on the iron nail was rubbed off using the steel wool. The iron nail was then weighed on a digital scale and its mass was determined to be of 6.5 grams. Two tablespoons of copper(II) chloride (CuCl2) crystals were then added to the beaker. The copper(II) chloride crystals were blue in colour, shown in Figure 1 below.…

    • 1905 Words
    • 9 Pages
    Powerful Essays

Related Topics