Preview

Cellonics

Powerful Essays
Open Document
Open Document
3904 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Cellonics
|Electronics(ECE)/Electrical(EEE)/Instrumentation(EI or AE&I) Seminar Report | CELLONICS |

CELLONICS

ABSTRACT

CHAPTER-1

INTRODUCTION

1INTRODUCTION

Are you tired of slow modem connections? Cellonics Incorporated has developed new technology that may end this and other communications problems forever. The new modulation and demodulation technology is called Cellonics. In general, this technology will allow for modem speeds that are 1,000 times faster than our present modems. The development is based on the way biological cells communicate with each other and nonlinear dynamical systems (NDS). Major telcos, which are telecommunications companies, will benefit from the incredible speed, simplicity, and robustness of this new technology, as well as individual users.

In current technology, the ASCII uses a combination of ones and zeros to display a single letter of the alphabet (Cellonics, 2001). Then the data is sent over radio frequency cycle to its destination where it is then decoded. The original technology also utilizes carrier signals as a reference which uses hundreds of wave cycles before a decoder can decide on the bit value (Legard, 2001), whether the bit is a one or a zero, in order to translate that into a single character.

The Cellonics technology came about after studying biological cell behaviour. The study showed that human cells respond to stimuli and generate waveforms that consist of a continuous line of pulses separated by periods of silence. The Cellonics technology found a way to mimic these pulse signals and apply them to the communications industry (Legard, 2001). The Cellonics element accepts slow analog waveforms as input and in

You May Also Find These Documents Helpful

  • Powerful Essays

    The next evolution was Asymmetrical Digital Subscriber Line (ADSL). ADSL also utilizes the traditional POTS system, but utilizes frequencies that are not used for telephone voice. Creating an advantage over the 56k modem as the telephone can be used at the same time. Similar to its predecessor using the POTS system, but ADSL uses different modulation schemes i.e. PSK and PQSK. Most of the bandwidth is used upstream to the provider which allows the user the ability to watch low quality videos allowing the user more bandwidth faster downloads, although slower upload speeds. The disadvantages of ADSL are expenses, and ADSL was not available to everyone. The external modem and twisted pair cables were not common during ADSL’s timeframe. Providers also needed repeaters to reach homes making the product…

    • 1421 Words
    • 6 Pages
    Powerful Essays
  • Powerful Essays

    Nt1330 Unit 1 Research Paper

    • 4285 Words
    • 18 Pages

    Each character requires one byte as it is usually stored as an ASCII character. Notice that a digit such as 8 could be held as either a character, an integer or even a real. If any calculations are going to take place on the value then it should be held as either an integer or a real. If the calculation will never result in it being extremely large or gaining decimal places then an integer should be used.…

    • 4285 Words
    • 18 Pages
    Powerful Essays
  • Good Essays

    Message Encoding involves converting the information the host wishes to send into the appropriate medium for transmission. Messages sent across networks are converted down into bits by the sending host and then encoded into a pattern of sounds, light waves, or electrical impulses, depending on the network medium over which the bits are being transmitted.…

    • 538 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Mcom-C100 Quiz 1

    • 386 Words
    • 2 Pages

    a system that encodes information into a series of on-and-off pulses usually denoted as zeros and ones…

    • 386 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    ect114

    • 1514 Words
    • 7 Pages

    Encoding is used to generate a coded output (such as BCD or binary) from a singular active numeric input line.…

    • 1514 Words
    • 7 Pages
    Satisfactory Essays
  • Good Essays

    The Federal Communications Commission (FCC) in 2015 voted to change the definition of broadband internet from 4 Mbps to 25 Mbps download speed and changed the upload speed to 3 Mbps from 1Mbps (Pramuk, 2015). Existing copper telephone cable is currently used to bring the internet into the home if fiber is not available, this method of receiving the internet is outdated and unreliable in rural communities that have not had any updates to the telephone exchanges. Once this fiber is brought into these rural communities; schools, businesses, and farming changes…

    • 1209 Words
    • 5 Pages
    Good Essays
  • Powerful Essays

    West Germany Research Paper

    • 4253 Words
    • 18 Pages

    such an arrival from the East. But as the 1980s drew to a close, few Germans on…

    • 4253 Words
    • 18 Pages
    Powerful Essays
  • Better Essays

    Telecommunications relies on the transmission of data through different mediums such as a telephone, radio, television, among others. These transmissions are done through two signal types, which are analog and digital. Analog is the first type of transmission type because it is the older and has been around for a lot longer than digital. On the other hand, even though digital transmission is a younger generation, it is currently use in more devices than analog. Each signal has its advantages and disadvantages, but in most scenarios, both need to work together to create an effective transmission. Technologies that convert analog into digital and vice-versa have been created for this purpose. Converting the signals allows for a more cohesive environment because each can be adjusted to work on devices or mediums not made for them originally. The next part of this paper covers the technologies use to convert these signals.…

    • 1056 Words
    • 5 Pages
    Better Essays
  • Better Essays

    When the conversion takes place between analog and digital it becomes the base of all communication technologies. Just about all hardware uses digital so it is very important to convert analog signals into digital to perform support for hardware applications. All hardware devices are aimed to be digital. Therefore, devices in the future will not need conversion because they will already be digital. There are many examples of analog to digital like a scan picture. The analog information provided by the light present in the picture is converted to digital signal to complete the process. The digital conversion use the means of binary coding for data transmission and output. The digital signals work only by using only two numbers known as one and zero (Analog to Digital). When users convert the signal to digital it allows plenty of data to be stored on a single device. This help save bandwidths and space. There are seven ways that signals are structured; direct conversion, ramp compare, successive approximation, delta encoded, pipeline, time stretch, and sigma delta. When the hardware uses one of those signals the destination hardware will find the best data encryption and utilization. The most common analog to digital conversion are the digital TVs, cameras, and other video captures. The newer microcontrollers’ technologies are used to convert analog to digital by reducing the size of the chip to get a better signal.…

    • 1389 Words
    • 6 Pages
    Better Essays
  • Satisfactory Essays

    New advancements look to focus on packing more information into frequencies, because virtually all frequency transmitters are being used. And this would allow more and more companies to transport all types of data.…

    • 694 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Modulation is the process in which a signal is entered into and transmitted by a signal carrier. There are several ways signals can be modulated and differ based on the equipment and technique utilized. Three common ways that signals are transmitted include a 56K modem, an asymmetrical digital subscriber line (ADSL), and Wireless Fidelity (Wi-Fi). Each of these methods are effective means of transmitting a digital signal, however, the 56K modem is all but phased out in favor of Wi-Fi which has evolved by way of ADSL.…

    • 523 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Technology is constantly changing in communications. The analog signal was used for several years and was limited in number and did not have the ability to handle the amount of data interchange used today, because of the size requirements. Analog signals are still used today, but are more complex and are in most circumstances converted to a digital signal. This paper will compare the different types of analog and digital technology we used and are currently using today.…

    • 1657 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Cell Phone Industry Analysis

    • 13608 Words
    • 55 Pages

    Kharif, Olga. (August 2006). A Quantum Leap for Cell Phones. Business Week Online. Retrieved April 20, 2008, from…

    • 13608 Words
    • 55 Pages
    Powerful Essays
  • Powerful Essays

    Telecommunication exists everywhere, -- at home, at work, at school, and even in cars - so it would be extremely difficult for anyone to be unaware of the popular trends in existing and emerging telecommunications technologies. In realizing these trends, past and present telecommunications technologies must be examined along with the measures currently being taken to improve them so that future trends can be predicted and developed.…

    • 2780 Words
    • 11 Pages
    Powerful Essays
  • Good Essays

    2) Encoding. This usually is in the form of a language (either written or verbal) that the receiver will be able to understand.…

    • 1331 Words
    • 6 Pages
    Good Essays

Related Topics