Calculation on the molar enthalpy change of a neutralization reaction Principle H2SO4(aq)+2NaOH(aq)=Na2SO4(aq)+2H2O(l) The reaction is a exothermic reaction‚ when the heat released by it is absorbed by water‚ the temperature of the water increases. The heat produced by the reaction can be calculated if it is assumed that all the heat is absorbed by the water. Heat change of reaction=-heat change of water =-mH2O×cH2O×△TH2O As the water has gained the heat produced by the reaction‚ the heat change
Free Thermodynamics Temperature Sodium hydroxide
Thermochemistry: An Ice Calorimeter Determination of Reaction Enthalpy Shannon Wedepohl 9/17/13 Abstract: During this experiment‚ an ice calorimeter was used to measure the change in volume in milliliters of magnesium metal and 1.00 M of sulfuric acid. We found the experimental molar enthalpy of the reaction to be ∆H = -370 ± 1 kJ/mol at 0˚C. This compares with an expected value of -466.9 kJ/mol at 25 ˚C‚ a 20.75% difference. Introduction: Many chemical reactions truly only
Premium Enthalpy Energy Thermodynamics
Catalytic Decomposition of Hydrogen Peroxide by Potassium Iodide Brief Description: Two solutions are mixed resulting in an eruption of foam resembling a huge stream of toothpaste. This is the classic “Elephant Toothpaste” reaction. Purpose/Goal: Procedure presents an example of a catalyzed reaction. Explanation of Experiment: The rapid evolution of oxygen gas is produced by the following reaction: 2 H2O2 (aq) = 2 H2O (l) + O2 (g) + heat The decomposition of hydrogen peroxide
Premium Oxygen Water Hydrogen peroxide
Introduction The reaction between zinc and copper (II) sulphate is endothermic. If an excess of zinc powder is added to a measured amount of aqueous copper (II) sulphate in a calorimeter and the temperature change is recorded over a period of time‚ the enthalpy change of the reaction can be experimentally determined. Assumption 1. Mass of H2O in 100cm3 of CuSO4 solution is 100g 2. Specific heat of solution is 4.18 kJ kg-1 K-1 which is the same as the specific heat of water 3. Heat evolved in
Premium
Chemistry SL Internal Assessment: Enthalpy Change Design Lab Experiment: Reaction of distilled water and solid sodium hydroxide RESEARCH QUESTION How does the heat released during the reaction between distilled water and Group 1 elements (lithium‚ sodium and potassium) vary as one goes down the group? OBJECTIVE The objective of the experiment is to measure the heat change during the reactions with minimal heat loss to the surroundings. MATERIALS The materials to be used in this experiment
Premium Sodium Potassium Lithium
However‚ the decomposition rate of rotary kiln is not high enough‚ we should impove the decomposition rate of rotary kiln. Do you know how? Decomposition rate of kiln showed that the extent of the carbonate in the raw material is broken‚ with preheating decomposition system equipment design is reasonable‚ whether appropriate process parameters.Kiln decomposition rate is the main indicators of decomposition furnace running normally‚ the decomposition rate is high‚ the decomposition furnace at full
Premium Coal Furnace Combustion
Time Series Analysis: The Multiplicative Decomposition Method Table of Contents Page Abstract………………………………………………………………………………………………………………………………………….3 Introduction………………………………………………………………………………………………………………………...…4-5 Methodology: Multiplicative Decomposition……………………………………………….…5-7 Advantages/Disadvantages of Multiplicative Method………………………………7-8 Conclusion…………………………………………………………………………………………………………………………………..8 Abstract One of the most essential pieces
Premium Time series
Thermochemistry: An Ice Calorimeter Determination of Reaction Enthalpy Curtis M. Franklin Thursday‚ February 14‚ 2013 ABSTRACT An ice calorimetric measurement was used to determine that a reaction involving solid magnesium metal and 1.00M sulfuric acid produces an experimental a value of ∆H = -226 ± 28 kJ/mol at 0°C. This is about 48.4% lower than the expected value reported at 25°C. Introduction Many chemical reactions exhibit themselves by exchanging heat energy‚ either be absorbing
Premium Enthalpy Water Energy
• Redox‚ Group 2 and Group 7 Unit 1 Exam – January 2013 – 1 hour – 90 UMS – 30% of total Unit 2 – Spring Term 2013 • Basic Concepts in Organic Chemistry • Alkanes and Alkenes • Haloalkanes and Alcohols • Enthalpy Changes • Rates and Equilibrium • Modern Analytical Techniques • Chemistry of the Air • Sustainability Unit 2 Exam – May 2013 – 1 hr 45 mins – 150 UMS – 50% of total Unit 3 – Autumn Term 2012 and Spring Term
Premium Mole Avogadro constant Amount of substance
Title : Expt.1 Determination of the enthalpy (heat) of reaction of a monobasic acid with sodium hydroxide Experiment no : 1 Experiment title : Determination of the enthalpy (heat) of reaction of a monobasic acid with sodium hydroxide Objectives: 1) To understand the enthalpy chemistry. 2) To determine the calorimeter constant. 3) To determine the enthalpy reaction of acid-base reactions. 4) To study the exothermic reaction. Apparatus and Materials : * Dewar flask
Premium Enthalpy Thermodynamics Energy