Preview

A Cis to Trans Conversion

Better Essays
Open Document
Open Document
1464 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
A Cis to Trans Conversion
INTRODUCTION
Maleic acid and Fumaric acid are both compounds belonging to the carboxylic acids class. In this experiment, we formed the two isomers of 1,2-ethylenedicarboxylic acid and tested the solubility and melting points of both of these products. Both of these compounds involve a carbon-carbon double bond that is composed of one σ bond and one π bond. The overlap of sp2 hybrid orbitals forms the σ bond, and one empty p orbital forms the π bond. This process is illustrated in the figure below:
Sp2 hybrid orbitals: Unhybridized p orbital:
(3 σ bonds) (1 π bond)
_1 _1 _1 _1 Molecules with double bonds are alkenes, and they have restricted rotation around the double bond so they tend to form the cis and trans geometric isomers. While both of these isomers have the same molecular formula, they usually vary in many physical features. Cis isomers have two identical groups located on the same side of the double bond, while trans isomers have the two groups on opposing sides of the molecule. Trans isomers are usually more stable than cis isomers because there is no steric interaction, or repulsion, between the carboxyl groups of the molecule. The more negative heat of formation value of trans alkenes also show that these compounds are more stable than cis alkenes. In the first part of this experiment, we formed maleic acid from maleic anhydride by adding the maleic anhydride to boiling water and then filtering the product using a Buchner funnel. We then mixed the filtrate with HCl and boiled it to form fumaric acid in the second part of the experiment.
RESULTS
A clear and oily substance appeared while boiling the maleic anhydride in water and a precipitate started to form during cooling. After filtering with the Buchner funnel, a solid white crystal-like product remained and the filtrate was a clear liquid. The following Table 1 describes observations made during the first part of the experiment, and the theoretical yield of the product formed.

You May Also Find These Documents Helpful

  • Good Essays

    Also added was 0.45mL water and 0.165mL acetic anhydride and a magnetic spin vane. An air condenser was attached to the vial and it was heated on an aluminum block, with a temperature maintained at 120C. After the solution dissolved, it was heated an extra 20 minutes to allow the reaction to go to completion then cooled back to room temperature. An ice bath was used to encourage crystal growth. The crystals were removed and centrifuged, then placed on a pre-weighed watch glass to dry and weigh. Percent recovery was found. A small sample was set aside for melting…

    • 860 Words
    • 4 Pages
    Good Essays
  • Good Essays

    In the lab, Bromide was combined with trans-cinnamic acid in order to see if the resulting product at the end of the experiment would yield either an erythro- or threo-dibromide. Based on how well this experiment was done there is a possible product that would have a melting point around 95°C, threo-, 205°C, erythro-, or somewhere in the middle which would be a combination of the two. The process of refluxing was used to purify the mixture followed by crystallization. In the end, the product that was yielded had a melting range of 188.4°C-190.1°C, which shows that the product was mainly comprised of erythro-dibromide.…

    • 751 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Diels-Alder Reaction Lab

    • 486 Words
    • 2 Pages

    Xylene is an excellent solvent for both anthracene and maleic anhydride, as evidenced by their complete solubility in the early part of the synthesis. Due to this fact, any unreacted starting materials would remain soluble throughout the recrystallization process. Additionally, the Diels-Alder product is soluble in boiling xylene, but insoluble in cool xylene. This makes for an ideal recrystallization solvent. The purified crystals that were collected from the recrystallization were a faint off-white color,…

    • 486 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    DIals Alder

    • 733 Words
    • 3 Pages

    Abstract: The objective of this experiment was to successfully prepare an endo,cis-diacid from the synthesis of the bicyclic anhydride (cis-Norbonene-5,6-endo-dicarboxylic anhydride). The percent yield of the product was calculated and found to be 39.01%. The infrared spectroscopy confirmed the presence of a O-H group with a stretch at 2948.03 1/cm and the presence of C=O with a stretch at 1698.93 1/cm. Melting point determination found the melting point range of the products to be 149.2-164.1 for the bicyclic anhydride and 169.4-179.5 for the endo-cis,diacid.…

    • 733 Words
    • 3 Pages
    Better Essays
  • Satisfactory Essays

    3.55 There are four cis-trans isomers of menthol, including the one shown. Draw the other three. Answer:…

    • 2612 Words
    • 11 Pages
    Satisfactory Essays
  • Good Essays

    5.Isomers are compounds made up of the same number of atoms and the same type of elements but configured differently, giving them different functions. There are 3 types of isomers, 1. Structural isomers differ in the arrangement of their bonds. 2. Geometric isomers have different arrangement around a double bond due to the double bond’s inflexibility for atoms to rotate around it. 3. Enantiomers isomers are mirror images of each other due to the arrangement of atoms around an asymmetric carbon atom.…

    • 534 Words
    • 3 Pages
    Good Essays
  • Good Essays

    To begin, the first step of the experiment was to crack down dicyclopentadiene into the form of cyclopentadiene, which was done using the process of fractional distillation. Five milliliters of dicyclopentadiene was utilized in the distillation at the temperature of 40˚C for approximately 20 minutes. Next 0.20g of maleic anhydride was dissolve in 2mL of ethyl acetate. Then it was…

    • 765 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Butanol Lab

    • 466 Words
    • 2 Pages

    Purpose: To test our theories of how the molecular structure of an organic molecule affects its properties by comparing the chemical properties of three isomers of butanol.…

    • 466 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Physical Properties- the physical properties were not the main source for determining the identity of the alkyl halide and starting alcohol because of the usual inaccuracy, however the results for boiling point and density proved close to 2-bromobutane and 2-Butanol. The boiling range from the week one experiment was 76-118 ◦C, which was too large of a range and the alkyl halide had not been completely purified. However, the boiling point for 2-butanol alcohol was about 83 ◦C, which lies within the range of the starting boiling range.…

    • 1325 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Competing Nucleophiles Lab

    • 2607 Words
    • 11 Pages

    40 g of ice and approximately 30 ml of sulfuric acid is cautiously added to a 100 mL beaker respectively. Weigh 7.6 g of ammonium chloride and 14.0 g of ammonium bromide and place it in another beaker, crushing the lumps until a powdery mixture remains. The powdery mixture is then transferred to a 125 mL Erlenmeyer flask. Add the ammonium salts into the sulfuric acid mixture. Heat is applied to dissolve the salt. Once the solution has fully dissolved, allow it to cool until the warm substance is touchable. A prolonged waiting period can cause the solution to recrystallize and this process would have to be repeated again. Place 6.0 mL of water in a 15 mL centrifuge tube marking the tube at the 6.0 mL level and replace the water with the solvent-nucleophile mixture. The tube is set aside for the t-butyl experiment. The remaining mixture is placed in a 25 mL round bottom flask.…

    • 2607 Words
    • 11 Pages
    Good Essays
  • Satisfactory Essays

    Chem 211

    • 368 Words
    • 2 Pages

    Material covered Structure Determines Properties Alkanes & Cycloalkanes: Introduction to Hydrocarbons Alkanes & Cycloalkanes: Conformations and cistrans Stereoisomers Stereochemistry Alcohols & Alkyl Halides. Nucleophilic Substitution Structure & Preparation of Alkenes: Elimination Reactions Reactions of Alkenes: Addition reactions Alkynes Conjugation in Alkadienes & Allylic Systems Arenes and Aromaticity Reactions of Arenes: Electrophilic & Nucleophilic Aromatic Substitutions…

    • 368 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Vsepr Lab

    • 271 Words
    • 2 Pages

    Fill in the table below for the corresponding compounds. Reference the tables provided in the introductory comments for Lab #16 VSEPR Theory.…

    • 271 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Liquid Chromatography

    • 2588 Words
    • 11 Pages

    To create octahedral structures, two d orbitals must be hybridized along with the s and all three p orbitals.…

    • 2588 Words
    • 11 Pages
    Good Essays
  • Good Essays

    Aspirin Lab

    • 648 Words
    • 3 Pages

    for the procedure I prepared a boiling bath using a hot plate, and filled a 400ml beaker with tap water. Then I got a 125ml Erlenmeyer flask and put in 2.00 grams of Salicylic acid using a scale. For the third step I added 5ml of Acetic Anhydride using a graduated cylinder. Then I added 5 drops of concentrated Sulfuric acid to the Acetic Anhydride and Salicylic acid in the Erlenmeyer flask using a dropper. I then heated the flask in the boiling bath for exactly 10 minutes. I then removed the flask and allowed it to cool on the counter for 4.5 minutes while adding 2 ml of cold distilled water dropwise. I then stirred to mix the contents. I Then added 40ml of distilled water in the solution and stirred until crystals began to form. My crystals formed in a matter of seconds. I then put the flask in a 400ml beaker of ice water to cool it down from room temperature for exactly 10 minutes to complete the crystallization process. I then collected the product in a filtration process by using filter paper and washing out the flask with distilled…

    • 648 Words
    • 3 Pages
    Good Essays
  • Good Essays

    hmmm

    • 395 Words
    • 2 Pages

    7. Give the stereochemical relationships (same compound, structural isomers, distereomers, or enantiomers) between each pair of isomers.…

    • 395 Words
    • 2 Pages
    Good Essays