Preview

Unknown Metal Reaction

Good Essays
Open Document
Open Document
225 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Unknown Metal Reaction
In this experiment, we examine the reaction between the unknown metal (which is Magnesium, Aluminum, Tin, or Zinc) and hydrochloric acid. When heats strongly, the metal reacts readily with hydrochloric acid and oxygen in the air. After it forms new compound (residue) and cools down, we measure the mass of the compound (MgCl2, AlCl2, SnCl2, ZnCl2) that is formed. This will allow you to calculate the mass of chlorine that reacted as well as the mass ratio between the metal and chlorine.
In this experiment, we use the unknown metal (which is Magnesium, Aluminum, Tin, or Zinc) to react with hydrochloric acid. Base on the mass of the unknown metal and the mass of residue to figure out what element is the unknown metal. By using stoichiometry, the

You May Also Find These Documents Helpful

  • Better Essays

    Get Charged Up Lab Report

    • 1848 Words
    • 6 Pages

    To accomplish this, three different methods were used. Titration was used to react NaOH with HCl to determine the amount of H+ left over after the reaction is complete. Crystallization was used to determine the amount of MgCl₂ made after the reaction is done. Both of these methods allowed us to calculate the amount of H+ reacting with the amount of Mg. The gas law method and the Ideal Gas Law was also used to determine the mole ratio of magnesium metal to hydrochloric acid by measuring the amount of hydrogen gas based on the pressure and temperature changes during the reaction. With the results from each procedure, graphs were constructed and the most accurate and precise method was discernible.…

    • 1848 Words
    • 6 Pages
    Better Essays
  • Powerful Essays

    In reference to the collision theory, molecules act as small spheres that collide and bounce off each other, transferring energy among themselves when the collide. In order for a reaction to occur, there must be collisions between molecules. Through experimentation, factors are discovered that influence the reaction rates of chemical reactions include the concentration of reactants, temperature, surface area, the physical state of reactants, and a catalyst. This experiment regarding the factors that affect reaction rate tests the effects of increased concentration and temperature of the hydrochloric acid solution (HCl) and also the effect of increased surface area of magnesium metal (Mg). When glow sticks are immersed in a hot water bath, it is proven that they glow with greater intensity. This proves that an increased temperature has an effect on the reaction itself, allowing molecules that make up the liquid inside the glow stick to move with greater speed, resulting in more collisions. The balanced equation for this reaction would be: Mg (s) + 2 HCl (aq) = MgCl2 (aq) + H2 (g)…

    • 2334 Words
    • 8 Pages
    Powerful Essays
  • Satisfactory Essays

    H2 Unit 3 Lab Report

    • 293 Words
    • 2 Pages

    4. Calculate the # of atoms of Magnesium that were involved in the reaction – use Avagadro’s number – remember units!…

    • 293 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Ilab Chemistry Lab

    • 451 Words
    • 2 Pages

    The purpose of this lab was to determine the atomic weight of magnesium by measuring the amount of hydrogen gas evolved when hydrochloric acid reacted with magnesium. In order to measure the atomic weight I needed to measure the amount of the hydrogen gas that was evolved in reaction to the acid of the magnesium. The reaction used was: Mg + 2HCl --> H2 + Mg2+ (aq) + 2Cl- (aq). The major findings of this experiment were that there was a chemical reaction between hydrochloric acid and magnesium, and the reaction produced the hydrogen gas. The results also indicated how many moles of hydrogen gas were equal to the amount of moles of magnesium consumed.…

    • 451 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    5.04 Honors lab Chemistry

    • 428 Words
    • 5 Pages

    4. If magnesium was the limiting reactant in this lab, calculate the theoretical yield of the…

    • 428 Words
    • 5 Pages
    Satisfactory Essays
  • Satisfactory Essays

    The purpose of this lab experiment is to determine the atomic weight of magnesium by measuring the amount of hydrogen gas evolved when hydrochloric acid reacts with magnesium.…

    • 286 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    10 Unknowns Chem II

    • 888 Words
    • 4 Pages

    The purpose of this experiment was to be able to apply our knowledge of chemistry to identify 10 unknown elements that were presented to us. We were allowed to use Bunsen burners, hydrochloric acid, use PH paper to test if the unknown solution is an acid or a base, and precipitate each unknown solution with each other.…

    • 888 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Chemical Reactions Lab

    • 1383 Words
    • 6 Pages

    Add a small piece of zinc to a test tube containing 30 drops of 6 M HCl and record what happens. 9. Add a 1 inch piece of copper wire to a test tube containing 30 drops of 6 M HCl and record what happens. (Is copper an active metal or inactive metal with HCl? Look up an activity series of metals online to check). 10. IN THE HOOD, take a 2 inch piece of magnesium ribbon and hold it with a pair of crucible tongs. Light the magnesium metal with a Bunsen burner and record your observations. DO NOT LOOK DIRECTLY AT THE BURNING MAGNESIUM. LABORATORY REPORT Students will write an individual or group laboratory report at the discretion of the professor. Include the following information in your laboratory report, due at the beginning of the laboratory period next week. 1. Title. Title of the experiment, your name, your partner 's name and the date the laboratory was performed. 2. Introduction. This will be your opportunity to practice writing introductions. The introduction to the lab should be about chemical reactions in general (why they are important, examples of specific types of chemical reactions such as combustion, precipitation, redox, etc.), not about how to write and balance an equation. For complete guidelines, go to “Laboratory Reports” on the Chem 1061 website. 3. Experimental Details. A description of the procedure you followed to produce the experimental data and results. Alternatively, you may reference the procedure by citing the URL’s…

    • 1383 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Farhampton Inn

    • 498 Words
    • 2 Pages

    one can calculate the mass of the oxygen that reacted with the magnesium. To obtain good results…

    • 498 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Magnesium Lab

    • 797 Words
    • 4 Pages

    Magnesium is an alkaline earth metal that has the symbol Mg. Magnesium is a fairly strong, silvery-white, light-weight metal (one third lighter than aluminum). In a powder, it heats and ignites when exposed to moisture and burns with a white flame that is harmful to the eyes. It is difficult to ignite in bulk, but once ignited, it is difficult to extinguish. Magnesium Ribbon is a long strip of magnesium metal about 3 millimeters wide and 10 meters long with a thickness of about 0.03mm, and weight of about 25 grams. Hydrochloric acid is a solution of hydrogen chloride in water, that is a highly corrosive, strong mineral acid with many industrial uses. It is found naturally in gastric acid. Hydrochloric…

    • 797 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Experiment 4a

    • 440 Words
    • 2 Pages

    The purpose of this lab is to create an experiment where zinc reacts with hydrochloric acid in order to find out the number of moles and atoms of zinc reacted. This can be accomplished by weighing the sample before and after the reaction with hydrochloric acid.…

    • 440 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Mass Lab

    • 853 Words
    • 4 Pages

    Previous to the reaction, the magnesium appeared to be a solid, white, black, and grey substance with many small dark particles within the substance. The hydrochloric acid was a clear liquid that looked like water It weighed 42.2 grams in total. During the reaction, the two substances produced bubbles, creating smoke and became warm with a smell that is irritating to the human nose. After the reaction, it appeared to be a clear, bubbly liquid with white spots. It weighed 42.2 grams in total after the reaction. The creation of bubbles, the different smell, and the increase in temperature told me that a chemical reaction occurred within the substance.…

    • 853 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    After mixing water, sodium hydroxide and a drop of phenolphthalein, the water changed its color from transparent to a pink. As more phenolphthalein was add the more dark the pink got. Since the change in color is one way of detecting chemical reaction, the conclusion was that in this specific experience chemical reaction happened.…

    • 54 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Chemical Reaction Lab

    • 663 Words
    • 3 Pages

    2 mL of an unknown nitrate solution, metal A, and 0.1 g of a solid unknown metal A were obtained as were 2 mL of an unknown metal B nitrate solution and 0.1 g of an unknown solid metal B. A series of reactions was designed to deduce which unknown metal, A or B, was the more active metal.…

    • 663 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The objective of this experiment was to observe evidence of a reaction and to determine the chemical equation, if there is a reaction. In order for a reaction to occur, a metal strip must have evidence of black or grey deposits on the surface of the metal once dipped into the solution. The reactivity of an element is related to its tendency to lose or gain electrons. Three metal strips that were used are copper, lead and zinc as well as the solutions of silver nitrate, copper(II) nitrate, lead(II) nitrate, magnesium sulfate and dilute(3M) sulfuric acid. The copper metal strip was placed in the silver nitrate and dilute(3M) sulfuric acid, the lead metal strip was placed in the copper(II) nitrate and the zinc metal strip was placed in the lead(II) nitrate, magnesium sulfate and dilute(3M) sulfuric acid. Overall, putting these different strips of metal into different solutions will help determine the reactivity of copper, lead, zinc, magnesium, silver and hydrogen.…

    • 542 Words
    • 3 Pages
    Good Essays