Preview

The Effect of an Enzyme on the Rate of a Reaction

Powerful Essays
Open Document
Open Document
1607 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
The Effect of an Enzyme on the Rate of a Reaction
Core Practical: Enzyme concentrations and enzyme activity.
Introduction
In this experiment I shall investigate how the enzyme concentration can affect the initial rate of reaction. I will measure the effect of the enzyme in 5 different concentrations against the controlled variable of the reactant. The enzyme which will be used is different concentrations of potato and the reactant used will be Hydrogen Peroxide. Hydrogen Peroxide which will be the buffer solution is a PH of 7.2. My hypothesis for the experiment is that as the concentration of the enzyme is increased the rate of reaction will be increased, producing oxygen at a faster rate. The results in my opinion will show positive correlation. The amount of buffer solution (hydrogen peroxide) will be kept the same throughout the experiment in the interest of reliability and the amount of enzyme (potato) will be decreased as the experiment is carried out and a measurement will be taken as to how fast the enzyme is produced.
Variables
The independent variable for this investigation will be the amount of enzyme which will be reacting with the Hydrogen Peroxide solution. I will be using potato as the enzyme in the reaction and the amount of potato will begin at 5ml and decrease by 1ml increments until it reaches 1ml which will be the final measurement.
The dependent variable in this investigation will be the rate of the reaction between the enzyme and the buffer solution. According to my hypothesis the rate of reaction will decrease as the amount of enzyme is decreased and the reaction will take longer to produce a particular amount of oxygen as the amount of enzyme is decreased.
The controlled variables in my experiment are the amount of hydrogen peroxide which acts as the buffer solution, this is necessary in order to ensure accurate results. The boiling tube in which the reaction takes place will also be kept the same and will be cleaned out with water after each reaction. This is necessary to avoid

You May Also Find These Documents Helpful

  • Powerful Essays

    The objective of this laboratory experiment is to observe and record the effect of reactant concentration, reactant surface area and reactant temperature on the overall rate of reaction.…

    • 2334 Words
    • 8 Pages
    Powerful Essays
  • Powerful Essays

    Catalase Lab

    • 1381 Words
    • 6 Pages

    Problem: Measuring the effects of Catalase enzymes on hydrogen peroxide decomposition. Measuring the rate of the reaction when hydrogen peroxide and Catalase are mixed at the same ratio for different time (10, 20 30 60 120 180 360 seconds).…

    • 1381 Words
    • 6 Pages
    Powerful Essays
  • Powerful Essays

    Enzyme Lab

    • 1094 Words
    • 5 Pages

    This investigation examined what would happen to the rate of an enzyme-catalyzed reaction if the concentration of substrate changed. We hypothesized that if the concentration increased, then the reaction rate would also increase. To test our question, we varied a combination of substrate and buffer, totaling 6mL, with a constant amount of 2 drops of catalyst. The enzyme catalyst, peroxidase, increased the rate of the reaction. The results of our experiment can be found by comparing the reaction rates for each trial. These rates are actually the slopes of the lines that were graphed during each reaction. The trend of data…

    • 1094 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    I have chosen to investigate how the concentration of the enzyme affects the rate of reaction. I expect that the more concentrated the enzyme the faster the reaction time will be. Changing the concentration of the enzyme will affect the rate of the reaction.…

    • 666 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Enzyme Lab Report

    • 594 Words
    • 3 Pages

    The aim of this experiment is to examine how the concentration of a substrate (hydrogen peroxide) affects the rate of reaction of an enzyme catalyse (found in liver cells)…

    • 594 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    3. Concentration of reactant and concentration of product- When the concentration of enzyme increased, the rate of reaction proportionally increases aswell. When the concentration of substrate is increased so does the rate of reaction until no further reaction takes place between the substrate and enzyme.…

    • 953 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    Potato Catalase Lab Report

    • 1324 Words
    • 6 Pages

    Description of Experiment: Three plastic beakers were used for this experiment. In one, a 20 mL of 1% hydrogen peroxide solution was made. In order to get this, the stock solution, which was 3%, was diluted using 10 mL of hydrogen peroxide and 20 mL of water. In the second beaker, a ¼ dilution of potato extract was made using 2 mL of potato extract and 6 mL of water. The third plastic beaker contained 8 mL of water. Using the first and second beaker the experimental assay was performed. Using forceps a small paper disk was dipped into the second beaker containing the potato catalase for exactly 5 seconds. It was next dried on a paper towel for 5 seconds, and finally placed at the bottom of the first beaker, which contained hydrogen peroxide solution. The timer was then started. The timer stopped when the paper disk floated up to the top of the beaker. This was performed 3 times. After this, two negative controls were tested. The first negative control used a denatured catalase instead of the potato extract. The…

    • 1324 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Write an explanation of how any two factors affect the rate of an enzyme-controlled reaction. How do these factors affect the chemical structure…

    • 733 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Procedure: While controlling the amount of starch and the amount of buffer we use with a pH of 5.8, we want to investigate how changes in enzyme concentration affect reaction rates. First we put 500 ml of amylase from 0.2% solution (provided by Michael Bunch) into an experimental tube. We then put 3 drops of Iodine into a test plate (the color is brown). While ready to time our reaction, we added 250 ml of starch solution into the mixture of buffer and amylase. The reaction had started instantly. We first timed the reaction at 20 seconds. At 20 seconds, we removed a 25 ml sample of the mixture and dropped it into one of the test sights of iodine. The color of the brown iodine turned immediately purple. Traces of purple in the iodine and amylase mixture indicate that the amylase did not have enough time to break down the starch completely. We tried this pattern of every 20 seconds for up to three minutes. The amylase was not breaking down the starch. Because no reaction after too much time, we increased the amylase solution to 0.5% and started our experiment over.…

    • 1165 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Certain concentrations of enzyme will be put into test tubes containing a piece of egg white and a control of egg white with no enzyme will be put in a test tube. The control is to compare the rest of the test tubes with, if the enzymes have an effect they will take a different time than the control to breakdown the egg white. The test tubes will be put into a water bath to maintain a constant temperature (37°C the same as internal body temperature) and timed to see how long it takes the contents of each individual test tube to go clear. When the solutions go clear it means that all the protein in the solutions has been broken down. The results of the experiment will be kept valid and accurate by applying the same conditions to each test tube except the concentration of enzyme put into the solutions. By doing this the results will be able to show whether enzyme concentration really does have an effect on the rate of reaction because nothing except the concentration of enzyme has been changed for each individual test tube. Thus, differences between the times it takes for the contents of each individual test tube to go clear is down to the differences in the concentrations of enzyme. The measurements made will be made as precise as possible by trying to keep the conditions applied to the contents in the test tubes as constant as possible. This includes by measuring solutions and solids as correctly and near as possible and timing, how long the reactions take as…

    • 1342 Words
    • 6 Pages
    Good Essays
  • Good Essays

    In the first part of the enzyme lab, we mixed a substrate and an indicator with an enzyme. There was also a neutral buffer in each of the chemical mixtures. The neutral buffer regulated the pH to around 7. We got a color palette and once we mixed each together, we observed and saw a change in the color of the substance. The darker and more brown the substance got, the more oxygen produced by the reaction. Our results showed that amount of oxygen produced increased about 10% a minute until it sort of equilibrated at 4 minutes and didn’t change to the fifth minute mark. If we were to change anything we did in the experiment, we would make our comparisons to the chart more precise. Overall we thought it was successful.…

    • 1927 Words
    • 8 Pages
    Good Essays
  • Powerful Essays

    We followed the baseline procedure and made proper modifications for our independent variable of temperature. We prepared the tubing/stopcock apparatus before measuring out the catalase and hydrogen peroxide. After assembling the apparatus, we filled a syringe with 1 mL of catalase and placed it on ice. We then filled an Erlenmeyer flask with 10 mL of hydrogen peroxide and sat that in a 45°C water bath. We allowed the flask to sit in the water for three minutes before adding the catalase, so that the hydrogen peroxide could equilibrate. After three minutes we attached the stopper assembly to the flask and dispensed the catalase, making sure to close the stopcock after the catalase was dispensed in the flask. We then continued to collect data on a laptop. We used LoggerPro to collect and analyze the data.…

    • 1229 Words
    • 7 Pages
    Powerful Essays
  • Better Essays

    Bio 155 Lab Report

    • 1344 Words
    • 9 Pages

    enzyme concentration and substrate concentration on the overall rate of the reaction. To determine the…

    • 1344 Words
    • 9 Pages
    Better Essays
  • Better Essays

    Enzyme Lab Report

    • 1656 Words
    • 5 Pages

    This study investigates the effect of substrate concentration on the initial rate of reaction when its concentration is much greater than the enzyme concentration. It is hypothesized that the initial rate of a chemical reaction increases as the substrate concentration becomes more abundant. A possible explanation to this phenomenon could be due to the increased…

    • 1656 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    2. No food or drink is allowed in the lab at any time. We will be…

    • 1793 Words
    • 8 Pages
    Powerful Essays