Preview

Sweet Tooth Lab Report

Satisfactory Essays
Open Document
Open Document
253 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Sweet Tooth Lab Report
Sweet Tooth Conclusion

The purpose of this lab was to determine whether the type of solvent will change if sugar can dissolve in it. For this experiment, 50 mL of water, rubbing alcohol, and vegetable oil were poured into different beakers with 1 gram of sugar and stirred for a minute to see if the sugar has the ability to dissolve within the solvent. It was hypothesized that if the solvent was changed, then there would be different amounts of sugar that can dissolve in it. During the experiment, it was discovered that water was the only solvent to dissolve the sugar while in the other two, the sugar sank to the bottom and did not dissolve. The hypothesis was only partially correct. That is because the sugar dissolved in the water while it

You May Also Find These Documents Helpful

  • Good Essays

    For solution A, the 1% sugar solution, 5 grams of sugar were added to a 250ml graduated cylinder and then tap water was added up to the 250ml mark. A small piece of plastic wrap was placed over the top of the graduated cylinder and the solution was mixed. Next, the contents were poured into a small saucepan over the stove. The graduated cylinder was then filled with 250 more milliliters of water, and then poured into the saucepan as well. The mixture was then heated on the stove and stirred until the sugar was dissolved. Once this happened, the solution was removed from the saucepan, poured into a container, and labeled as 1% sugar solution.…

    • 977 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    1 M Sucrose Lab

    • 561 Words
    • 3 Pages

    We then went to see if the sucrose entered the bag unfortunately the benedict's solution showed negative results. The second test ( Bag: 5% ovalbumin Beaker: 1 M sucrose) we put biuret in a test tube with the beaker solution and the indicator showed negative results. Then for the next test (Bag: 1 M Glucose Beaker: distilled H2O) they put Benedict's solution in a test tube with the beaker liquid. The benedicts showed positive results. The next test (Bag 1 M Sucrose Beaker: 1 M NaCl) they put Benedict's solution in a test tube with the beaker liquid. The indicator showed negative results. For the next test(Bag: 1 M NaCl Beaker: distilled H2O) they put silver nitrate in a test tube with the beaker liquid. The silver nitrate showed positive results. The next test (Bag 1 M sucrose Beaker: 5% ovalbumin) they used mass change to determine if the solute could pass through the bag. They weighed the bag before and after. The mass of the bag decreased showing that the H2O passed through the bag. The next test (Bag: 1 M NaCl Beaker: 1 M glucose) they put silver nitrate in a test tube with the eaker liquid. The indicator tested positive. The next test( Bag 1 M Glucose Beaker 1 M sucrose) they put iodine in a test tube with the beaker liquid. The indicator showed positive results. The next and final test (Bag: 1 M glucose Beaker: 5% ovalbumin)…

    • 561 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Gummy Bear Lab Report

    • 635 Words
    • 3 Pages

    When combining one gummy bear, which is composed mostly of sucrose with molten potassium chloride, a violent reaction occurs. A surprising amount of energy us released by the reactant, and in process, the atom and molecule rapidly rearrange to form 3 products(CO2/H2O and KCl). This reaction is said to be products favor. A favoured product reaction is where almost all of the reactants, react to form products. In this case its sucrose and potassium chlorate react completely to form carbon dioxide, water and potassium chloride. This reaction is exothermic, releasing energy in the form of heat and light (we can see flame a bright light during the experiment). The energy released is also equal to the calorific content of the Gummy- Bear. This reaction…

    • 635 Words
    • 3 Pages
    Good Essays
  • Good Essays

    In this Lab there were four different stations to experiment with, my partner and I started with grabbing our goggles, and then we started with station 4, solubility, we had add a small amount of 4 different liquids (Hexane, Ethanol, Water, or Vegetable oil) to a well, then we had add a solid (Salt,Sugar, or Lard) to each of the 4…

    • 768 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Lifesaver Lab

    • 836 Words
    • 4 Pages

    The purpose of this laboratory is to demonstrate in which solution the LifeSaver dissolves faster within five minutes.…

    • 836 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Chem Lab

    • 721 Words
    • 3 Pages

    The purpose of this experiment is to use two common laboratory methods to see how mixtures can be separated based on physical properties. Paper chromatography will be used to separate the dye colors from M&M candy to see which colors contain yellow #5. Gravimetric separation will be used to separate salt and sand from a mixture.…

    • 721 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chem Test 1

    • 1214 Words
    • 5 Pages

    3) A student performs an experiment to determine the density of a sugar solution. She obtains the…

    • 1214 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Paw Baked Milk Lab

    • 600 Words
    • 3 Pages

    Each substance was observed inside their containers and the hypotheses were based on these observations. The volumes of each substance was then measured inside their containers. Each substance was then weighed and density calculated. After, each substance was observed under magnifying glass, smelled and touched to determine texture. Lastly, each substance was tested for solubility.…

    • 600 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    3. What was your prediction about the results of each factor tested in your two lab procedures? Explain your predictions based on your knowledge of the dissolving process, collision theory, and reaction rates. My predictions of the results on this lab were right. I figured that if the Alka-Seltzer were crushed up it would make it more easier to dissolve since they were in little pieces instead of one big tablet.…

    • 423 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    PURPOSE: To see which solutions are soluble and which are not. We were able to see this by mixing certain solutions together and observing changes that occurred.…

    • 978 Words
    • 4 Pages
    Powerful Essays
  • Satisfactory Essays

    The purpose of the lab is to find how much sugar is in a potato. I have found that my hypothesis “If I change the amount of sucrose in the solution, then percent change will be a negative percent and show me how much sugar is in a potato which is about 0.5g of sugar because increasing sucrose solutions outside the cell creates a hypertonic solution or hypotonic cell and the water inside the potato will go to the sugar outside the potato.” was proven wrong from the graph of my data which showed with a line that falls on zero that that is where it is isotonic and that is how much sugar is in the potato.…

    • 118 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    In order to start this experiment we first needed to get two bowls and two spoons in order to have a control bowl and an experimental bowl. We then put the one cup of flour in the control bowl followed by all the other dry ingredients; three quarters of a tablespoon of sugar, one quarter of a tablespoon of salt, one and one quarter tablespoon of dehydrated milk, and one tablespoon of yeast. We then mixed that together and added one half tablespoon of margarine we mixed that while gradually mixing the one half cup of warm tap water. As we did before we then put one cup of flour in the experimental bowl followed by all the other dry ingredients; three quarters of a tablespoon of sugar, one quarter of a tablespoon of salt, and one tablespoon of yeast. We mixed that together and added one half tablespoon of margarine we mixed that while slowly mixing in the one half cup of warm tap water. In order to expedite the process of rising we took out a hot plate…

    • 827 Words
    • 4 Pages
    Good Essays
  • Good Essays

    In both of these experiments the product was dipped into the liquid and then the remaining of the liquid was measured to see how much was left and whichever one had the least amount left came out on top.…

    • 1074 Words
    • 5 Pages
    Good Essays
  • Powerful Essays

    Viscosity

    • 2122 Words
    • 9 Pages

    In this experiment the concentration of the Glucose solution is being varied in order to evaluate its effect on the viscosity. These solutions with different concentrations will be made by dissolving varying amounts of provided C6H12O6 in H2O. The solutions and their concentrations are as follows:…

    • 2122 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    The saturation point of the sugar depends on bonding between sugar and water molecules. As we adding the sugar into water and stirred it, the sugar dissolved quickly. It is because the water molecules can interact with the sugar molecule easily by intramolecular hydrogen bond. When keep adding the sugar, they dissolved slowly and some of them are undissolved. It can be explained that the water molecules are not enough to form intermolecular H-bond with sugar molecules. That’s why we need to stir the solution. It can help the water molecules to form intramolecular H-bond with sugar molecules easily. The sugar can dissolve finally and there no more sugar can be dissolved when saturation point is reached.…

    • 939 Words
    • 4 Pages
    Good Essays