Preview

Study of Solubility Equilibrium of Potassium Hydrogen Tartrate

Powerful Essays
Open Document
Open Document
1543 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Study of Solubility Equilibrium of Potassium Hydrogen Tartrate
Study of Solubility Equilibrium of Potassium Hydrogen Tartrate
Wang Haina
1. Aim 1. To determine the solubility of potassium hydrogen tartrate (KHT) at various temperatures from 10°C to 50 °C, and determine the corresponding Ksp at these temperatures. 2. To obtain the changes in enthalpy and entropy of the dissolution of KHT from the dependence of Ksp on temperature.
2. Results and discussion
2.1 Collection of data
A portion of KHT (1 to 1.5 g) was added into about 100 mL of deionised water to prepare a saturated KHT solution. Several such solutions were prepared at various temperatures between 10°C and 50 °C, and filtrated into dry 250-mL conical flasks. For solutions made above or below the room temperature, their temperatures dropped or increased during filtrations. For each solution, two portion of 25.00±0.03 mL were pipetted into two 250-mL conical flasks and titrated with 0.07274 M of NaOH solution respectively with phenolphthalein as indicator. The temperatures of the KHT solutions and the corresponding volumes of NaOH solution used for titration are shown in Table 1. For each row, the temperature is the average of the temperatures immediately before and after the filtration, and the volume is the average of the two titrations.
Table 1 The temperatures of saturated KHT solutions and the corresponding volumes of NaOH solution used for titration. Temperature (±0.5 °C) | Vol. of NaOH soln (±0.05 mL) | 12.5 | 8.82 | 17.5 | 9.05 | 19.5 | 10.35 | 23.0 | 10.15 | 23.0 | 11.13 | 37.5 | 15.50 | 42.5 | 14.40 | 48.5 | 18.95 |
It is noted that though the general trend is that the volume of NaOH increases with increasing temperature, there are some inconsistencies in this table. For example, the two volumes of NaOH at 23°C (obtained respectively by my partner and me) are different, and the volume at 42.5°C is lower than that at 37.5°C, contrary to the general trend. These will be discussed in the later subsection of error analysis, and



References: 1. Study of solubility equilibrium. http://www.bignerds.com/papers/77914/Study-Of-Solubility-Equilibrium/ (accessed October 14, 2014). 2. Solubility And K dependence on temperature. http://www.ukessays.com/essays/biology/solubility-and-k-dependence-on-temperature-biology-essay.php (accessed October 14, 2014). Appendix Data sheet. (See attached paper.) This experiment was done with collaboration of Wang Zhuliang.

You May Also Find These Documents Helpful

  • Better Essays

    6.03 Calorimetry Lab

    • 1068 Words
    • 5 Pages

    In the experiment, standardization of NaOH with HC1 solution is carried out. Solid NaOH is hygroscopic where significant amounts of water vapor can be absorbed. Also, as NaOH is a strong base, significant amounts of atmospheric carbon dioxide can be absorbed too. It is also clear that NaOH cannot serve as a primary standard and thus it needs standardization by a primary or secondary standard. NaOH solutions can be directly titrated versus standardized HCl using phenolphthalein or methyl red indicator. In this case, methyl red is used as an indicator. The colours change from red to completely purple pink indicate the standardization is achieved. If reasonable concentrations of the acid and base are used, very sharp end points can be achieved. The…

    • 1068 Words
    • 5 Pages
    Better Essays
  • Satisfactory Essays

    7.03 Lab Ph

    • 790 Words
    • 4 Pages

    9. If you went too far past the end point, please record the results of your trial. Include all sets of data in your lab report.…

    • 790 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    ka lab report

    • 692 Words
    • 3 Pages

    We will be using the LoggerPro and LabPro in order to help us determine our data. The purpose of this experiment is to follow the changes of pH during the titration of an acid and a base in order to determine the of the weak acid, . is a constant for a given acid at a given temperature. In this experiment we determined the Ka using two different methods: 1) the measurement of the pH of a solution containing a known concentration of a weak acid, and 2) measurement of the pH at the half-neutralization point in the titration of a weak acid and a strong base.…

    • 692 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Blah

    • 1432 Words
    • 6 Pages

    Learning Objectives to understand the titration curves for the following solutions • a weak acid: acetic acid, CH3COOH. • • • • • a strong acid: hydrochloric acid, HCl. an acidic commercial cleanser. a basic commercial cleanser. to use the titration curves to calculate the percent of the active ingredients in the commercial cleansers. to determine the Ka of a weak acid. Procedure Overview • • • • after calibration of the pH electrode and determination of the flow rate for the automatic titration, a NaOH solution is standardized against HCl. a pH titration curve for acetic acid is obtained and its pKa is determined. an unknown sample of Lysol is analyzed for its HCl content using the standardized NaOH. an unknown sample of Liquid Plumr is analyzed for its NaOH and NaOCl content using HCl of known molarity.…

    • 1432 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Labquest Synthesis

    • 354 Words
    • 2 Pages

    In part A, solutions needed in the experiment were prepared, and the LabQuest was set up. By adding 100mL 6M HCl to 200mL deionized water, 300mL of 2M HCl solution was prepared. Then 150mL 2M NaOH solution was prepared by adding 100mL 3M NaOH to 50mL deionized water. Finally, the LabQuest was connected to the temperature probe, and set up to collect data every 15 seconds, the duration was set to be 180 seconds.…

    • 354 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Labs

    • 3297 Words
    • 14 Pages

    This lab experiment covers the preparation of standard solution and the acid/base titration. The first part of the lab is to prepare a standard solution of Potassium hydrogen per. A standard solution is a solution of known concentration, in which it is prepared using exacting techniques to make sure that the molarity is to the highest accuracy. The stock solution on the other hand, which is also a base in this experiment, is a large volume of a common reagent prepared…

    • 3297 Words
    • 14 Pages
    Good Essays
  • Good Essays

    Solubility is the amount of solid that can be dissolved in a certain amount of liquid at a certain temperature. In order for solubility to be tested, two trials were run. 5 mL of deionized water was measured and poured into a beaker. The temperature of the water was recorded. 2 grams of the unknown was measured out and placed into the same beaker as the deionized water. The unknown and water was then mixed well until the unknown was fully dissolved. Once the unknown was fully dissolved, small amounts of the solid unknown was then measured and mixed into the solution until the solution was either cloudy or had small amounts of solid unknown, unable to dissolved, at the bottom of the beaker. The solubility was then put into terms of moles per liter. Enthalpy change is the amount of heat that is released or absorbed in a chemical reaction at constant pressure. For enthalpy change to be calculated, 30 mL of deionized water was measured out and put in a coffee cup calorimeter. The initial temperature of the water was record. 1 g of the unknown was measured out. Fairly quickly, the unknown was added to the water and stirred. The LabQuest pad measured the change in the temperature of the water as the unknown was dissolved. Once 90 seconds had passed the heat trend was observed from the reaction. The enthalpy was calculated by using the formula, ∆H= c∙m∙∆T. The enthalpy change…

    • 1860 Words
    • 8 Pages
    Good Essays
  • Good Essays

    post lab 6

    • 593 Words
    • 2 Pages

    1- Weigh duplicate samples of 0.50-0.60 g of previously dried standard potassium hydrogen phthalate (KHP) into 250- ml flasks. Dissolve each sample in ~100- ml boiled distilled water.…

    • 593 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Titrations are a very useful method of discovering the amount or concentration of unknown substances. The method is very well suited towards acid-base reactions. Titrations are often used in industry to analyze products to be sold. In this lab, standardizations will be done in the first two experiments and then titration analysis in the third.…

    • 716 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Papers

    • 301 Words
    • 2 Pages

    8. In order to make a saturated solution at 55 C you must have 70 g of KNO3…

    • 301 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Acid-Base Lab

    • 1339 Words
    • 6 Pages

    II.Purpose: The purpose of this experiment is to standardize a sodium hydroxide solution and use the standard solution to titrate an unknown solid acid. The equivalent mass of the solid acid will be determined from the volume of sodium hydroxide added at the equivalence point. The equilibrium constant, Ks, of the solid acid will be calculated from the titration curve obtained by plotting the pH of the solution versus the volume of sodium hydroxide added.…

    • 1339 Words
    • 6 Pages
    Powerful Essays
  • Better Essays

    The experiment began with the preparation and standardization of NaOH solution. It was calculated that 2.00 grams of NaOH pellets were needed to prepare 0.5 L of 0.1 M NaOH solution. The solution was then standardized by conducting three titration trials. It was calculated that 0.7148 grams of KHP were necessary to neutralize 35 mL of the 0.1 M NaOH. Three samples of KHP were weighed approximating this number (Table 1). Each sample was mixed with 40 mL of deionized water and 2 drops of phenolphthalein in 3 Erlenmeyer flasks. Each flask was then titrated with the NaOH to a light pink endpoint. The volumes of NaOH were recorded, averaged, and the standardized. The molarity of the NaOH was found to be 0.0981.…

    • 1680 Words
    • 7 Pages
    Better Essays
  • Good Essays

    Solubility Postlab Report

    • 831 Words
    • 6 Pages

    2) There should be a difference in the results between the solubilities of biphenyl and benzophenone in methyl alcohol.…

    • 831 Words
    • 6 Pages
    Good Essays
  • Good Essays

    This report is about how to standardize a Sodium Hydroxide (NaOH) solution by titrating it with pure sample of Potassium acid Phthalate (KHC8H4O4). This experiment has two sections. The first section is to standardize the Sodium Hydroxide by titration. Three sample of 0.7 – 0.9 g of solid KHP are place into each of the three numbered Erlenmeyer flasks. 50 ml of distilled water are added to each three of it from graduated cylinder and constantly shake it until the KHP solution are completely dissolve. 2 drops of phenolphthalein are add to each flask. Titrate each of the three flasks simultaneously with NaOH solution to the end point with the first appearance of a faint light pink that persist for 15 seconds. The colour will fade as CO2 from the air are dissolve in the solution. The second section is about standardization of diluted Sodium Hydroxide (NaOH). These sections are quite similar to section 1 but this method is titrating using a diluted Sodium Hydroxide which is diluted for 5 times. The rest of the experiment for section 2 is similar to section 1.…

    • 1535 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Titration Techniques and its Direct Effects on the Calculation of %TA of Liquid Samples 10…

    • 4142 Words
    • 17 Pages
    Good Essays