Preview

Specific Gravity of Aggregates in Different Quarrying Sites in Second District of Camarines Norte

Powerful Essays
Open Document
Open Document
7615 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Specific Gravity of Aggregates in Different Quarrying Sites in Second District of Camarines Norte
SPECIFIC GRAVITY OF AGGREGATES ON DIFFERENT QUARRYING SITES IN SECOND DISTRICT OF CAMARINES NORTE

An Undergraduate Thesis
Presented to
The Faculty of College of Engineering and Industrial Technology

In Partial Fulfillment of the Requirements for the Degree of
Bachelor of Science in Civil Engineering

By

ABARCA, EDMAR T.
JARIEL, MICHAEL N.
LALLO, KILVEN V.

2013
SPECIFIC GRAVITY OF AGGREGATES ON DIFFERENT QUARRYING
SITES IN SECOND DISTRICT OF CAMARINES NORTE

ABARCA, EDMAR T.
JARIEL, MICHAEL N.
LALLO, KILVEN V.

ABSTRACT

This research determined the specific gravity of aggregates in different quarrying sites in second district of Camarines Norte. This study also presented and identified the research instruments, materials and statistical tool considered in this research. The experimental method of research was used in this study. Library visit and internet surfing were also conducted. The result of this study revealed that all samples from Basud, Dagotdotan and Dogongan would pass the sieve analysis test requirements base on ASTM C-33 standard specification of concrete aggregates except the fine aggregates from Alawihao quarrying site. Bulk specific gravity SSD and OD of coarse and fine aggregates of all sites considered would not satisfy the ACI Standard. With the four sites considered, only apparent specific gravity would meet the range of specific gravity based on ACI Standard. Specific gravity is used in calculating the volume that can be used in design mix. Specific gravity is not a measure of aggregates quality. To determine the aggregates strength for concrete mixture, further study was recommended.
TABLE OF CONTENTS

Title Page
TITLE PAGE i
CERTIFICATION OF ADVISER ii
RECOMMENDATION FOR ORAL EXAMINATION iii
CERTIFICATION OF THE SECRETARY iv
CERTIFICATION OF THE EDITOR v
RESULTS OF ORAL

You May Also Find These Documents Helpful

  • Good Essays

    Hydrated Chloride

    • 692 Words
    • 3 Pages

    Gravimetric procedures are analytical methods in which the results are determined from the masses of starting materials and products. These methods differ from volumetric procedures in which the calculations are based on the volumes of standardized solutions used in the procedure.…

    • 692 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    I-35W Highway Collapse

    • 2826 Words
    • 12 Pages

    construction aggregates (sand and gravel for making concrete) were delivered and positioned in the two…

    • 2826 Words
    • 12 Pages
    Powerful Essays
  • Good Essays

    Purpose: The purpose of this experiment was to calculate the mass of composition of each component in a mixture containing sand, salt and iron filings. Introduction: Many substances that we use on a daily basis are in fact part of a mixture.…

    • 636 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    In the sand aggregate concrete quality change and the process of aggregate, crusher is indispensable processing equipment, it can make the massive, hard basalt break into aggregate, particle, then after processing applied to building materials production. Henan party big mining equipment factory is the largest and most powerful professional manufacturer specialized research and development, more than 10 years has been committed to the crusher of research and technology to improve the performance of crusher equipment, its development and manufacture of the crusher, sand mining equipment machine etc advanced technology, the function is all ready, crushing efficiency high, high yield, and the production of finished products sand grain shape perfect and good quality, and the processing of basalt is special equipment, at the same time in the granite and limestone, HeLuanShi, iron ore, etc. Various kinds of rocks and ores in the crushing,…

    • 462 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Sample Lab Aggregates

    • 1935 Words
    • 8 Pages

    aggregate is fine with a u niform gradation that would not be ideal to use as the sole aggregate for a concrete…

    • 1935 Words
    • 8 Pages
    Good Essays
  • Good Essays

    To discuss the properties for which concrete is designed, it is necessary to stress that the materials used to make a concrete mix can vary distinctly from region to region, and the methods by which concrete is poured may be significantly different than the typical codes seen in the United States. These variances lead to differences in the quality of mix which can be produced. To analyze the impact of concrete mix design during earthquake reconnaissance, it would be beneficial to become familiar with the typical ingredients of concrete structures in the area in order to assess the general quality of concrete. The type of aggregate used affects bond strength and therefore affects the overall strength and quality of the concrete. One should also note the general practices used for pouring concrete such as the use of vibrators, knowledge of ideal pouring time and conditions, and…

    • 661 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Sieve Analysis Report

    • 1237 Words
    • 5 Pages

    * To determine the particle size distribution and fineness modulus of fine and coarse aggregates.…

    • 1237 Words
    • 5 Pages
    Powerful Essays
  • Powerful Essays

    Concrete is one of the most commonly used structural materials. It is made by simply mixing cement, aggregate, sand and water in the “right” proportion. The strength of concrete varies even with the slightest variation in the ratio or quality of its ingredients. Concrete properties are highly influenced by the water type used and its proportion in the concrete mix, but actually there is little knowledge of the effects of different, alternative water sources used in concrete mix design. Therefore, the identification of the level and nature of contamination in available water sources and their subsequent influence on concrete properties is becoming increasingly important.…

    • 893 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    ENVIRONMENTAL GUIDELINES FOR SETTING UP STONE CRUSHING PLANT Stone Crushing Industry is an important industrial sector in the State engaged in producing crushed stone which is raw material for various construction activities like construction of Roads, Highways, Bridges, Buildings, Canals, etc. Transportation of stone over long distances adds to cost of the crushed stone products, crushers need to be necessarily located nearer to the demand centers such as Cities, Bridges, Highways, Canals, etc. Stone Crushers also need electricity supply and man power for operation. It also needs access roads for the movement of mined stone as well as crushed stone products. These stone crushers though socio-economically an important sector, give rise to substantial quantity of fugitive fine dust emissions resulting in to health hazards to the workers as well as surrounding population. The dust also adversely affects visibility, reduces growth of vegetation and hampers aesthetics view of the area. In order to prevent/control these emissions and complains thereof, GPCB decided to come up with the guidelines to be considered for setting up of Stone Crushing Plant in the State, which is as under: 1) The siting criteria :…

    • 797 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    As the leader of mining machinery industry, DSMAC has the ability to provide 40000tpd aggregate production line. Until the end of 2012, the enterprise has succussed in several sandstone crushing lines for Tianrui Cement, Changjiu Quarry, etc. and also constructed 8 large aggregate lines under construction, playing an crucial role in cement industry chain transformation. DSMAC Sand and Aggregate Project Department can offer the service as follow:…

    • 439 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    To achieve rapid economic development, many countries resort to various activities to use and take advantage of natural resources. One of such activities is mining. Thus, mining became an important activity which has potential for the contribution of development of areas enriched with resources.…

    • 2992 Words
    • 12 Pages
    Powerful Essays
  • Powerful Essays

    In this course we have done ratio analysis of cement industries named as Lucky cement, Cherat cement and pioneer cement…

    • 5380 Words
    • 22 Pages
    Powerful Essays
  • Best Essays

    Department of Civil Engineering, National Pingtung University of Science and Technology, 1 Hsuefu Road, Neipu, Pingtung 91201, Taiwan Correspondence should be addressed to Hung-Yu Wang; hywang@mail.npust.edu.tw Received 9 November 2012; Revised 27 February 2013; Accepted 4 March 2013 Academic Editor: Alex Li Copyright © 2013 C.-F. Liang and H.-Y. Wang. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This research intends to study the cementing potential of pulverized oyster shell, rich in calcium, when mixed with fly ash and soil. Cylindrical compacted soil and cubic lime specimens with different proportions of the shells and fly ash are made to study the strength variance. Soil, which is classified as CL in the USCS system, commercialized pulverized oyster shell, F-type fly ash, and lime are mixed in different weight percentages. Five sample groups are made to study the compressive strength of soil and lime specimens, respectively. The lime cubes are made with 0.45 W/B ratio and the cylindrical soils are compacted under the standard Procter compaction process with 20% moisture content. The results show that increment of shell quantity result to lower strength on both the soil and lime specimens. In a 56-day curing, the compressive strength of the lime cubes containing fly ash increases evidently while those carrying the shell get little progress in strength. The soil specimens containing fly ash gradually gain strength as curing proceeds. It suggests that mixtures of the shell and fly ash do not process any Pozzolanic reaction nor…

    • 4161 Words
    • 17 Pages
    Best Essays
  • Better Essays

    Lab Report

    • 1405 Words
    • 6 Pages

    This test (ASTM C136-06) determines the grading of materials being used as aggregates using two parameters (coefficient of uniformity and gradation) from particle-size distribution curve. Sieve analysis consists of shaking the sample through a set of sieves that have progressively smaller openings. To conduct a sieve analysis, samples are oven dried for at least 24 hours. The soil is placed and shaken through a stack of sieves with openings of decreasing size from top to bottom. The mass of particles retained in each sieve is determined. Results showed that the particle–size distribution curve of coarse aggregate is characterized by a steep curve. This means the coarse aggregate is poorly or uniformly graded with small variation in size. Particle-size distribution curve of fine aggregate is characterized by an S-curve. It is well graded and has a gradation of particle size that spans evenly the size from coarsest to finest. Conclusions drawn from the interpretation of the particle-size distribution curve is supported by computed coefficients of uniformity and gradation which is 6.79 and 1.03 for (well graded) fine aggregates, and 1.57 and 1.05 for (poorly graded) coarse aggregate.…

    • 1405 Words
    • 6 Pages
    Better Essays
  • Good Essays

    We need to determine the fineness of cement by dry sieving as per IS: 4031 (Part 1) – 1996.The principle of this is that we determine the proportion of cement whose grain size is larger than specified mesh size.…

    • 1070 Words
    • 5 Pages
    Good Essays