Preview

Soda Water Titration

Good Essays
Open Document
Open Document
598 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Soda Water Titration
The titration experiments between the three different brands and under the five different conditions showed varied results. As shown in Graph 1, the condition which tested most effervescent was when the soda water was under cold temperatures and the least effervescent temperature was when the soda water was warm. When left standing without the lid, the soda water proved to be least effervescent. As seen in the above graph, under cold temperatures, ‘Schweppes’ demonstrated that it was the most effervescent, but under warm and room temperatures ‘Woolworths’ brand was most effervescent. When the soda water was stirred, ‘Regal’ was recorded with the highest concentration of hydrogen ions, and tied with ‘Woolworths’ when left standing with the lid removed. These results were observed because when refrigerated the gas molecules in the soda water slow down and the bond between hydrogen ions becomes strong, enabling carbon dioxide to be released (Frederick, n.d.). Whereas when the soda water was warm or room temperature, the gas molecules inside it where active and broke the bonds of the H2O chain, which in turn released more carbon dioxide, making the soda water less effervescent. Like when the soda water was left standing for 48 hours, the gas molecules would have been most active as they had no added pressure, leaving the …show more content…
Before drinking ‘Schweppes’ soda water it is best for consumers to refrigerate it. If the consumer were to buy any of the brands of soda water tested, they should keep them refrigerated before drinking them. The next best way of storing any of the brands of soda water would be to keep the lid on at room temperature. Overall, the consumer should purchase the ‘Schweppes’ soda water if they have a refrigerator, and if they do not own a refrigerator, the ‘Woolworths’ brand should be purchased, in order to get the most effervescent

You May Also Find These Documents Helpful

  • Good Essays

    6.03 Titration Lab

    • 573 Words
    • 3 Pages

    3.) Place 5mL of vinegar in a 125 mL Erlenmeyer flask. Dilute the vinegar with 25 mL of water and add two drops of phenolphthalein.…

    • 573 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Titration Analysis

    • 505 Words
    • 3 Pages

    Prediction: We predict that the amount concentration of acetic acid in a sample of vinegar is 0.83 mol/L.…

    • 505 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Joseph Priestley invented soda water accidentally because of his new house. He moved his house where was placed next to the brewery, and he saw the bubbles in the beer. He was really curious about bubbles in beer. He thought that dissolve the bubbles in the water. He put a bowl of water over the beer vat, and then collected fermenting beer. When the beer is fermented, it gave off carbon dioxide which was called fixed air at that time. This gas was infused into the water, and it tasted so fresh like Seltzer mineral water. He invented soda water accidentally in 1767. Artificial soda water was cheaper than natural soda water in mineral water. Soda water was well known to relieve stomach ache, and help to digest well, but it was not really helping that much. Also, he did not sell his ideas into the companies or he did not make his soda water into item for selling.…

    • 1316 Words
    • 6 Pages
    Good Essays
  • Better Essays

    Titration Lab

    • 2835 Words
    • 12 Pages

    4. "Titration." An Introduction to Chemistry - Bishop. N.p., n.d. Web. 28 May 2010. <http://chiralpublishing.com/Bishop_Titration.htm>.…

    • 2835 Words
    • 12 Pages
    Better Essays
  • Powerful Essays

    Goose Egg

    • 1491 Words
    • 10 Pages

    The main focus of this lab was to acquire a basic understanding of how to properly use measuring devices in order to determine properties of a liquid. These properties are volume, mass, and density. The following measurements were obtained in the lab: density of water, both density and concentration of aqueous sugar solutions, and density of various soft drinks with respect to sugar. Additional experience was obtained by using specific formulas to accurately calculate percent error and percentage of sugar in different sodas. Lastly, familiarity with graphing aspects of Microsoft Excel was attained.…

    • 1491 Words
    • 10 Pages
    Powerful Essays
  • Better Essays

    The hardness of softened water was only measured by EDTA titration. Starbucks water’s hardness changed from 10 ppm to 8 ppm. Starbucks water was already really soft, so it did not get much softer. HUB water’s hardness changed from 82.27 ppm to 19 ppm. This sample showed a significant difference. It got 4 times softer than before. Pollock water’s hardness changed from 460 ppm to 370 ppm. The hardness got softer, but it did not change much. Water softening agents help reducing Ca2+ and Mg2+ concentration in the water. As the water’s hardness got softer in the experiment, water softening agent is also effective and useful in lives.…

    • 2778 Words
    • 12 Pages
    Better Essays
  • Good Essays

    Titration of Cola

    • 1177 Words
    • 5 Pages

    LEARNING OBJECTIVES The objective of this laboratory experiment is to determine the molar concentration of phosphoric acid in a cola product. BACKGROUND Titration is an analytical technique used to find the concentration of a known volume of unknown substance by adding a known concentration of a known substance. As the unknown and known substance react, we look for a "telltale" indication that the reaction is complete, which allows us to determine the concentration of the unknown. The most common type of titration is known as an acid-base titration. In an acid-base titration, we start with a known amount (usually a volume) of an unknown concentration of acid and add to it known amounts of a known concentration of base (or vice versa). For our purposes, the equivalence point is the most crucial point in the titration. It is the point during the titration where the moles of base added will equal the moles of acid in the unknown solution (or vice versa). Since the volume of base added can be read from the buret at this point and the concentration of the base and the volume of the acid are also known, the concentration of the unknown acid solution can be determined. There are a number of ways to determine the equivalence point, two of which can be used in this experiment. The first is by measuring the pH of the solution as you add base to the acid. There is a dramatic increase in the pH of the solution at the equivalence point(s) as shown in Figure 1 on the following page. A second way to detect the equivalence point is by using a thermometric method. Because acid-base reactions are exothermic, the solution being titrated warms as base is added. At the equivalence point, there is no further acid-base neutralization reaction and solution warming decreases or ceases abruptly. If you have a precise enough temperature measuring device, this abrupt change in the…

    • 1177 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Imagine the cool, crisp feeling after taking a sip from a favorite soda beverage. This is a satisfying feeling for many individuals, however ingesting soda is not very beneficial to an individual’s health because of the diseases that are linked to the consumption of soda pop as well as oral health.…

    • 497 Words
    • 2 Pages
    Good Essays
  • Better Essays

    From 1985 to 1997, school districts decreased the amount of milk they bought by nearly thirty percent and increased purchases of soda by one-thousand and one-hundred percent. (Roberts) About fifty-six to eighty-five percent of school age children consume at least one soft drink daily. (Roberts) Children these days are not getting enough calcium, mainly because of the large consumption of soft drinks. Instead of grabbing a glass of milk, most kids, teens and adults would rather drink soda. The effects of the preservatives and artificial sweeteners can break down the enamel on your teeth, making them prone to rotting. The reason that most people who drink to much soda have or are more prone to rotting teeth, cavities, etc., is because sugary drinks coat you teeth, gums and tongue for hours after you drink them, and most people don’t rinse or brush their teeth right after drinking soda. (Anne) When tooth decay starts to reach the nerve, the root, and the area at the base of the tooth, the tooth may die and, if let untreated, an abscess can develop. (Term Life Insurance) Drinking soda through a straw can help prevent corroding your teeth because the beverage goes straight into the back of your throat. (Anne) Soda has a pH of 2.5 to 3.0, or around…

    • 1438 Words
    • 6 Pages
    Better Essays
  • Best Essays

    Soft drinks that commonly found in our daily life contain caffeine and sodium benzoate. The caffeine act as a stimulant and the sodium benzoate acts as a preservative of soft drink by inhibits grow of bacteria. In this experiment, hydrochloric acid is added to all solution to protonate the sodium benzoate to produce benzoic acid. Since the caffeine has no appreciable basicity, so it is neutral at pH 2. In this experiment, a spectrophotometric analysis of caffeine and the benzoic acid in soft drink is conducted to determine concentration of the caffeine and the benzoic acid mountain dew. The UV/Vis spectrometer is used and the ultraviolet absorbance is chosen to conduct the spectrophotometric analysis in this experiment.…

    • 2163 Words
    • 9 Pages
    Best Essays
  • Good Essays

    Corrosiveness of Soda

    • 696 Words
    • 3 Pages

    As much as we are more concerned of sugar content and the empty calories that soft drinks have, we must also consider the acidity of it. The corrosiveness of soda is ten times that of fruit juices, as they have this certain ingredient, called phosphoric acid. The phosphoric acids in sodas are used as an acidifying agent to give the sodas their tangy flavor. A latest research in the Academy of…

    • 696 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Titration Lab

    • 1012 Words
    • 5 Pages

    A titration is a technique used to find the solution of known concentration in the concentration of another unknown solution. Typically, the known solution is added from a known quantity of unknown solution until the reaction is complete. Titrations are also often used to determine the pH of a solution. This is important because without knowing how acid or basic a solution is people could hurt themselves and others but mixing chemicals together that are lethal. The objective of the is lab is to develop familiarity with the concepts and techniques of titration and to determine the concentration of an acidic acid solution. It was necessary to add Phenolphthalein because it acts as an indicator, that is a weak acid, so it is easier…

    • 1012 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Goggles must worn including Lab coats and gloves can be worn if need be or when it’s appropriate. KOH is corrosive. If KOH solution splashes into your eyes or comes contact with skin, use the eyewash or flush the affected area with water.…

    • 578 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Titration Lab

    • 499 Words
    • 2 Pages

    1. Using your textbook or a handbook, look up the formula and structure of potassium hydrogen phthalate (KHP) used to standardize the solution of NaOH in this experiment. Calculate the Molar Mass of KHP.…

    • 499 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Sicher, J., Fine, T., & Maxwell, J.C. (Eds.). (2006). All-Channel Carbonated Soft Drink Performance in 2005 [Special Issue]. The Beverage Digest, 48 (7). Retrieved 3 December 2006 from: http://www.beverage-digest.com/pdf/top-10_2006.pdf…

    • 2392 Words
    • 10 Pages
    Powerful Essays