Nt1310 Unit 1 Case Study

Satisfactory Essays

Open Document

Open Document

View Writing Issues

237 Words

Grammar

Grammar

Plagiarism

Plagiarism

Writing

Writing

Score

Score

Nt1310 Unit 1 Case Study

1. Check the linearity of the Black Box by connecting the DC Power Supply to the input of the Black Box, and the Multimeter to the output of the Black Box, then change the input voltage regularly and notice the changing in the output voltage of the Black Box.
2. Connect the DC Function Generator and channel 1 of the Oscilloscope to the input of the Black Box, and channel 2 of the Oscilloscope to the output of the Black Box to establish a static test and determine the static gain.
3. Build the pervious connection again, but this time change the Function Generator Wave Mode from Sine Wave to Square wave to test the time domain.
4. Observe the step responses on the Oscilloscope when time changes.
5. Compare the experimental model data with the mathematical model data.
6. …show more content…
Create the same connection as a pervious; however, keep the wave of the Function Generator at Sine Wave. Select the Function Generator frequency and change it steadily to test the frequency domain.
7. Observe the outcome voltages and frequencies for channel 2 of the Oscilloscope.
8. Compare the experimental data with the mathematical data to check the frequency domain test
9. Import data into the Matlab for

Continue Reading

You May Also Find These Documents Helpful

Good Essays
Nt1310 Unit 1 Case Studies
- 502 Words
- 3 Pages
Nt1310 Unit 1 Case Studies

PCA 1. The first PCA was conducted to construct the four categories of citizenship norms by using only data collected in 2004 (Table A11). It included the variables Actasoc, Buypol, HelpUSA, Helpwrld, Milserve, Obeylaws, Othreasn, Paytaxes, Voteelec, and Watchgov. Missing cases were deleted listwise, leaving a total of 1,406 valid cases from a population aged 18 to 89 years and older. The PCA was conducted using ten variables with orthogonal (varimax) rotation. An inspection of the correlation matrix revealed that all variables had at least one correlation coefficient r > .3. The KMO measure was .78, with individual measures exceeding the minimum level .5, confirming sample size adequacy. Furthermore, Bartlett’s test of spherity was statistically significant (p < .05), indicating that the data was suitable for PCA.…
- 502 Words
- 3 Pages
Good Essays

Read More
Good Essays
Nt1310 Unit 1 Exercise 1 Case Study
- 596 Words
- 3 Pages
Nt1310 Unit 1 Exercise 1 Case Study

Ones we have known about nodes in the network and links between them, then to analyze this network some SNA Measures are used. These measures are mathematical aggregation functions which calculates various aspects related to each node and also some of them can calculate some of the aspects with respect to the whole network .…
- 596 Words
- 3 Pages
Good Essays

Read More
Good Essays
Nt1310 Final Project Report
- 1184 Words
- 5 Pages
Nt1310 Final Project Report

The goal of our final project was to build a car that has the following two functions: 1) follow a path made by a white line 2) respond to a sound from the environment by stopping or starting itself. The project was built on the chassis used in the previous labs, and utilized two Line Follower sensor and one microphone provided in the lab kit. Besides, an Arduino Redbeard was used as the microprocessor of the car. The car was expected to power itself and demonstrate considerable reliability while meandering along the white line.…
- 1184 Words
- 5 Pages
Good Essays

Read More
Satisfactory Essays
Nt1310 Unit 2.1 Case Analysis
- 215 Words
- 1 Page
Nt1310 Unit 2.1 Case Analysis

It is normal to have some problems after purchasing a new graphics driver, along with installing other drivers. There are many ways to “fix” this. Because it is not common for new drivers to cause more problems than they solve, and most users prefer to go back to their older version. It may not be his best option but at least this persons computer will function. A lot of these drivers need updating every now and then. You have to open the device manager and erase the driver all together. An easy way to check your stuff is to see if its plugged. Restart the system and let windows 7 detect and install the driver over again. It will cause windows to send more resources to the device and could solve your problem. As for…
- 215 Words
- 1 Page
Satisfactory Essays

Read More
Good Essays
Nt1330 Unit 5 Project Report
- 1858 Words
- 8 Pages
Nt1330 Unit 5 Project Report

· S/W Environment: Minimum one Web Browser should be installed before PC installation, Use IE 5.5 or higher, Go to Tools > Internet Options > Security tab and click on Custom Level button and make sure that under the Scripting section the Active Scripting is set to “Enable”.…
- 1858 Words
- 8 Pages
Good Essays

Read More
Satisfactory Essays
Nt1330 Unit 2 Research Paper
- 514 Words
- 3 Pages
Nt1330 Unit 2 Research Paper

It is an exception code which is suggestive of Windows registry corruption. 0x80070002 errors can start happening if the Windows registry has corrupted entries. Windows OS and Windows programs will fail to work unless you find a 0x80070002 fix.…
- 514 Words
- 3 Pages
Satisfactory Essays

Read More
Satisfactory Essays
Ac Hipot Verification Procedure.
- 403 Words
- 2 Pages
Ac Hipot Verification Procedure.

2. To verify that a ground is detected, skip all other tests but hipot, and place a wire between the test clip and the chassis ground of the device. The test should fail for a ground. A high leakage reject is also acceptible in this exercise.…
- 403 Words
- 2 Pages
Satisfactory Essays

Read More
Better Essays
Circuit Analysis of Linear Network and One Nonlinear Element
- 2406 Words
- 10 Pages
Circuit Analysis of Linear Network and One Nonlinear Element

The purpose of this laboratory experiment is to learn simple techniques for analyzing a circuit with a nonlinear element. It gives details as to what methods to uses when using nonlinear elements. This experiment will give us a way to get the characteristics of the circuit through simulation and actual lab measurements.…
- 2406 Words
- 10 Pages
Better Essays

Read More
Satisfactory Essays
Assignment Solution 01
- 1695 Words
- 7 Pages
Assignment Solution 01

2. A DSB-SC modulated signal can be generated by multiplying the message signal with a periodic pulse generator and passing the resultant signal through a band-pass filter. = 2 cos 200 + cos 600 ( )= 1 2 + 2…
- 1695 Words
- 7 Pages
Satisfactory Essays

Read More
Good Essays
Digital Communications
- 624 Words
- 3 Pages
Digital Communications

In the experiment, we study the Modicom 1 Demonstration. The purpose of this is to understand the functions of each block using input analog signal.…
- 624 Words
- 3 Pages
Good Essays

Read More
Good Essays
Analogue Lab Report
- 2208 Words
- 9 Pages
Analogue Lab Report

1) The circuit was connected as shown in Figure A. Two separate adjustable supplies (VGG and VDD) were used for the experiment. The grounds for both supplies were connected to the circuit ground.…
- 2208 Words
- 9 Pages
Good Essays

Read More
Better Essays
Report on Hydrogen Superhighway
- 1612 Words
- 7 Pages
Report on Hydrogen Superhighway

method, wideband excitation such as frequency chirp is used. Frequency response is obtained as the DFT of the…
- 1612 Words
- 7 Pages
Better Essays

Read More
Better Essays
Passive Filter
- 1527 Words
- 7 Pages
Passive Filter

5. The traces on Channel 1 and Channel 2 of the oscilloscope are tuned to give more accurate readings.…
- 1527 Words
- 7 Pages
Better Essays

Read More
Good Essays
Simulation of Dynamic Responses of First Order and Second Order Systems (in LabView)
- 1062 Words
- 5 Pages
Simulation of Dynamic Responses of First Order and Second Order Systems (in LabView)

In order to simulate the dynamic response of a first order system, we first created a blank VI on LabVIEW, and added a numeric control for the time constant input and a graph indicator for the result display. Then a “Simulated Signal” express VI was used in the block diagram with a square wave as signal type, 1 Hz frequency, 1000 Hz sample frequency, 500 data points, and was set to convert the…
- 1062 Words
- 5 Pages
Good Essays

Read More
Satisfactory Essays
Digital Signal Processing
- 5785 Words
- 24 Pages
Digital Signal Processing

GENERATION OF BASIC SIGNALS USING MATLAB AIM: Generation of Sine Wave & Illustration of the Sampling Process in the Time Domain EQUIPMENT REQUIRED: P – IV Computer Windows Xp SP2 MATLAB 7.0 THEORY:…
- 5785 Words
- 24 Pages
Satisfactory Essays

Read More

Related Topics