Preview

Non Wood Fibre Use

Good Essays
Open Document
Open Document
19784 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Non Wood Fibre Use
USE OF NONWOOD PLANT FIBERS FOR PULP AND PAPER INDUSTRY IN ASIA: POTENTIAL IN CHINA

By Mudit Chandra

Degree Paper Submitted to the Faculty of Virginia Polytechnic Institute and State University in Partial Fulfillment of the Requirements for the Degree of MASTER OF FORESTRY IN WOOD SCIENCE AND FOREST PRODUCTS

APPROVED:

A. L. Hammett, Chairman

J. D. Dolan

C. D. West

August, 1998 Blacksburg, Virginia

USE OF NONWOOD PLANT FIBERS FOR PULP AND PAPER INDUSTRY IN ASIA: POTENTIAL IN CHINA by Mudit Chandra Dr. A. L. Hammett, Chairman Department of Wood Science and Forest Products (ABSTRACT) The pulp and paper industry around the world has been growing rapidly. As a result there has been a huge demand for pulp and paper making raw material. Recent years have seen a spurt in use of nonwood fibers being used as a raw material for this purpose. Although some of the nonwood fibers used for papermaking are used because of their fine paper making qualities, majority of nonwood fibers is used to overcome the shortage of wood fibers. As a result their use is more widespread in countries with shortage of wood. The use of nonwood fibers in pulp and paper industry is fraught with problems. Right from supply of raw material to the properties of finished paper, majority of nonwood raw material has proven to be economically inferior to wood. But over the last few years, technological breakthrough in almost all the fields of papermaking have made nonwood more competitive with wood as a raw material for papermaking. Although till recently, use of nonwood fibers for pulp and paper making was concentrated in countries with limited wood supply, it is now showing an increasing trend even in countries with adequate wood supply due to environmental considerations. With time this trend can be expected to grow further and it can be safely said that the future of nonwood plant fibers as pulping and papermaking raw material looks bright.

ii

AKNOWLEDGMENTS
I would



Bibliography: Tribeni Tissues Limited, in India, is the only mill to use raw jute for pulp manufacture. It is blended with other pulps to produce specialty paper (Sabharwal, 1995); • •

You May Also Find These Documents Helpful

  • Powerful Essays

    Hemp paper is longer lasting than wood pulp, stronger, acid-free, and chlorine free. (Chlorine is estimated to cause up to 10% of all Cancers.)…

    • 419 Words
    • 2 Pages
    Powerful Essays
  • Powerful Essays

    Wgu Gke2 Task 2

    • 1230 Words
    • 5 Pages

    World Bank Group. (1998). Pollution Prevention and Abatement Handbook: Pulp and Paper Mills. Washington D.C.: Environment…

    • 1230 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Essay On Dresden Codex

    • 564 Words
    • 3 Pages

    This gave me a much more solid understanding for the process of papermaking. The paper itself is made from the fibers of a species of Ficus tree, called Amate in Yukatek, and coated with a fine layer of lime plaster. To make this paper, first bark from trees is collected, torn into small bits, and then soaked over a period of time to soften the bark for when it is turned into pulp. Once the pulp reaches the desired level it is rinsed with clean water and then kept in water until it is processed. The pulp is then arranged onto boards and beaten into a thin flat paper. The paper is then taken to dry, which could have taken anywhere from two hours to two days depending on the…

    • 564 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Paper vs Plastic

    • 1259 Words
    • 6 Pages

    Paper is derived from trees, which is a renewable resource. To create paper, the logging industry must first find and mark all the trees to be felled. The trees are then cut down and removed from the area, mostly by truck. “Trees must dry at least three years before they can be used” (“Paper vs. Plastic,” par. 5). The bark is stripped from the tree, cut into one inch squares, and cooked in extreme heat. The wood chips are then broken down into a pulp by soaking in a limestone and sulfurous acid bath for eight hours. “It takes approximately three tons of wood chips to make one ton of pulp” (“Paper vs.…

    • 1259 Words
    • 6 Pages
    Better Essays
  • Better Essays

    GCSE DT Revision Notes

    • 5142 Words
    • 35 Pages

     Fibres are small and compact, which gives the wood a greater mechanical strength and…

    • 5142 Words
    • 35 Pages
    Better Essays
  • Powerful Essays

    Operations Management

    • 3503 Words
    • 15 Pages

    How Paper is Made (1998). In Pulp and Fiber Products. Retrieved September 17, 2011, from…

    • 3503 Words
    • 15 Pages
    Powerful Essays
  • Satisfactory Essays

    Homework 1

    • 312 Words
    • 2 Pages

    The strength of paper (y) used in the manufacture of cardboard boxes is related to the percent of hardwood concentration (x) in the original pulp. Under uncontrolled conditions, a pilot plan manufacturers 16 samples, each from a different batch of pulp, and measured the tensile strength. The data are shown below.…

    • 312 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Sustainability Assignment

    • 1541 Words
    • 7 Pages

    The procurement of trees can occur either when rights are sold to cut down trees on land that is set to be urbanized or when commercial tree farms are sowed, grown, cut, resowed on the same land. Both means take energy, but the former takes a more natural, less energy intensive path, while the latter takes more energy input from the use of fossil fuels to power the machines to plant, sow and maintain the tree farms. Once the trees are felled, requiring energy input, it is converted to pulp. The transformation of tree chips into pulp and then paper is an energy intensive endeavor, taking fossil fuel inputs to form and shape the paper into a specific product. Some paper products take more processing in order to obtain the final product. Paper that needs to be white, undergoes a bleaching process, taking an input of chemicals and more fossil fuels, which may lead to the contamination of water resources. Once the final paper product is produced, it needs to be moved to market, which again is fossil fuel intensive. The use of diesel, oil and gasoline is not only used to transport the paper product but also used by the consumer of to move the paper product to its final destination. Lastly, once the paper product is no longer needed it is either put into in a landfill or it begins a recycling phase, which uses fossil fuels to move the waste paper and then transform it back into a pulp.…

    • 1541 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Chand, N, Tiwary, RK & Rohatgi, PK (1988) 'Bibliography Resource structure properties of natural cellulosic fibres — an annotated bibliography ', Journal of Materials Science, vol. 23, no. 2, pp. 381-7.…

    • 8279 Words
    • 34 Pages
    Powerful Essays
  • Good Essays

    Manufacturing paper and paper products requires the use of earthy beginnings. However, the fact that pure paper fiber is made in North America assures us that the multitude of green forests, covering a total of 133 million acres, are maintained by a chain of caring and eco-friendly organizations.…

    • 717 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Paper or Plastic

    • 1000 Words
    • 4 Pages

    Paper comes from trees. It starts from logging, where trees are marked and cut down. In the logging process roads are made and large machines are used to load and transport the cut down trees. From a forest the trees are moved to a mill where they wait to dry. Once dried they are stripped of bark and cut into woodchips. Then the trees are cooked under heat and pressure, and soaked in limestone and sulphurous acid. This makes the chipped wood into a pulp. The pulp is washed and bleached and then color is added. Once the colored water is mixed with the pulp, the mixture is poured into a grid of bronze wires. The pulp is filtered out and rolled into paper and is then sent to another factory for folding, cutting, and printing to make grocery bags.…

    • 1000 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    cross laminated timber

    • 3401 Words
    • 32 Pages

    1. Introduction! use!spruce!lumber!(FPInnovations!2011).! !…

    • 3401 Words
    • 32 Pages
    Powerful Essays
  • Satisfactory Essays

    The report firstly introduced Cellulose pulp basic information included Cellulose pulp definition classification application industry chain structure industry overview; international market analysis, China domestic market analysis, Macroeconomic environment and economic situation analysis, Cellulose pulp industry policy and plan, Cellulose pulp product specification, manufacturing process, cost structure etc.…

    • 816 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Holidaygomework

    • 948 Words
    • 4 Pages

    Cellulose is nature’s own giant molecule. It is the fibrous material that every plant from seaweed to the sequoia makes by baking glucose molecules in long chains; the chains are bound together in the fibers that give plants their shape and strength. Wood has now become the main source of cellulose. Since it contains only 40% to 50% cellulose, the…

    • 948 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Jute is a versatile, natural fiber that has been used for thousands of years to make things such as rope, twine, hessian bags, rugs, and much more. While it is still being used extensively around the world, it is not as popular as it could have been. Given the increasing focus on environmental issues these days, jute good products can be put into the lime light, as they are environment friendly. Taking in view the prospects, this is the high time to promote the export of the jute-diversified products using limited resources.…

    • 8028 Words
    • 33 Pages
    Powerful Essays

Related Topics