Module 6 Cisco Commands 
Module 6 Cisco Commands
Jose A Diaz
Rasmussen Collage
Authors Note
This paper is being submitted on November 16, 2014, for Timothy Hill N201/CET2522C Section 01 Cisco Network Routing and Switching
Module 6 Cisco Commands
Requirement
Cisco Command
Interface subcommand that defines the serial data-link protocol.
Encapsulation hdlc ppp frame-relay
Administratively disables (shutdown) or enables no shutdown) the interface in whose mode the command is issued. switch(config-if)# no shutdown
Serial interface subcommand that, when used on an interface with a DCE cable, sets the clock speed in bps.
Clock rate speed
Interface subcommand that sets the router’s opinion of the link speed, in kilobits per second, but has no effect on the actual speed.
Bandwidth speed-kbps
Interface subcommand that can set a text description of the interface.
Description text
Interface subcommand that enables only PAP, only CHAP, or both (order dependent).
PPP authentication pap chap pap chap
Global command that sets the password that this router expects to use when authenticating the router with the listed hostname.
Username name password secret
Lists statistics and details of interface configuration, including the encapsulation type.
Show interfaces
Lists a single line per interface (or if the interface is included, just one line of output total) that lists the interface status and description.
Show interface “” description
Lists one line of output per interface, with IP address and interface status.
Show IP interface brief
Jose A Diaz
Rasmussen Collage
Authors Note
This paper is being submitted on November 16, 2014, for Timothy Hill N201/CET2522C Section 01 Cisco Network Routing and Switching
Module 6 Cisco Commands
Requirement
Cisco Command
Interface subcommand that defines the serial data-link protocol.
Encapsulation hdlc ppp frame-relay
Administratively disables (shutdown) or enables no shutdown) the interface in whose mode the command is issued. switch(config-if)# no shutdown
Serial interface subcommand that, when used on an interface with a DCE cable, sets the clock speed in bps.
Clock rate speed
Interface subcommand that sets the router’s opinion of the link speed, in kilobits per second, but has no effect on the actual speed.
Bandwidth speed-kbps
Interface subcommand that can set a text description of the interface.
Description text
Interface subcommand that enables only PAP, only CHAP, or both (order dependent).
PPP authentication pap chap pap chap
Global command that sets the password that this router expects to use when authenticating the router with the listed hostname.
Username name password secret
Lists statistics and details of interface configuration, including the encapsulation type.
Show interfaces
Lists a single line per interface (or if the interface is included, just one line of output total) that lists the interface status and description.
Show interface “” description
Lists one line of output per interface, with IP address and interface status.
Show IP interface brief