Preview

Milk of Magnesia Titration

Good Essays
Open Document
Open Document
675 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Milk of Magnesia Titration
Sean Healy
Chemistry #1
Lab

Milk of magnesia titration

AimTo calculate the amount of Magnesium Hydroxide Mg(OH)2 in a 5ml teaspoon of Milk of Magnesia and compare this with the manufacturers stated valueHEALTH & SAFTEY lab coats, safety glasses, gloves Bags and coats were put to one side of the lab Caution was taken while handling chemicals the chemical were all placed on labelled A4 sheets
PLANNING & PREPERATION
The following equipment was gathered 250ml flask 1 litre flask Pipette Burette Retort stand Conical flask Beaker Wash bottle Dropper
Chemicals
Milk of Magnesia 0.2 Hydrochloric Acid (HCL) Phenolphthalein ( C2OH4O4 ) AIMS

The aim of this titration was to calculate the amount of Magnesium Hydroxide (Mg OH 2) in a 5ml teaspoon of milk of magnesia and compare the result with the manufactures stated value which is 415g per 5ml suspension

PROCEDURE

The equipment was rinsed out in water 25ml of milk of magnesia was diluted into; 250ml of water Hydrochloric acid ( HCL ) was made up in a flask to 0.2 molar solution 25ml of magnesium hydroxide was pippeted to a conical flask HCL was then carefully added to the burette being held in the stand 3 drops of phenolphthalein ( C 2 OH 4O4 ) (indicator) were added to the `magnesium hydroxide which turned the solution a pink colour HCL was slowly added to the magnesium hydroxide Mg(OH)2 and swirled by hand This was continued until it turned from pink in colour back to a colourless solution The amount of HCL was then recorded in a data table This titration was carried out four times, the first being use for a base line

Theory Hydrochloric Acid | + | Magnesium | | Magnesium Chloride | + | water |
2HCl (aq) + Mg(OH)2 (aq) ⇒ MgCl (aq) + 2H2O (l)

Neutralization Reaction Hydrochloric acid reacts with Mg(OH)2 the products reaction
Continue Reading
View Writing Issues

You May Also Find These Documents Helpful

  • Better Essays

    Get Charged Up Lab Report
    • 1848 Words
    • 6 Pages

    Get Charged Up Lab Report

    To accomplish this, three different methods were used. Titration was used to react NaOH with HCl to determine the amount of H+ left over after the reaction is complete. Crystallization was used to determine the amount of MgCl₂ made after the reaction is done. Both of these methods allowed us to calculate the amount of H+ reacting with the amount of Mg. The gas law method and the Ideal Gas Law was also used to determine the mole ratio of magnesium metal to hydrochloric acid by measuring the amount of hydrogen gas based on the pressure and temperature changes during the reaction. With the results from each procedure, graphs were constructed and the most accurate and precise method was discernible.…

    • 1848 Words
    • 6 Pages
    Better Essays
    Read More
  • Good Essays

    Investigating Stoichiometry with Carbonic Acid Salts
    • 420 Words
    • 2 Pages

    Investigating Stoichiometry with Carbonic Acid Salts

    In table 1.2, the mixture of HCl and unkown sample 2 were combined. It took 40mL of HCl to turn the solution yellow, after the heating and evaporation of the water, the glassware with the NaCl weighed 76.38g. When the glassware was weighed again after the NaCl was washed out, it was 76.24g. There was 0.14g of NaCl that had formed.…

    • 420 Words
    • 2 Pages
    Good Essays
    Read More
  • Good Essays

    6.03 Calorimetry Lab
    • 529 Words
    • 3 Pages

    6.03 Calorimetry Lab

    The solution containing the HCl, NaOH and water in the 100-mL was then disposed into the proper waste container. In the same 100-mL beaker, 40-mL of water was added then 5-mL of HCl was also added. The Vernier pH sensor was again placed and held in the solution and the LabQuest was properly programmed and turned on.…

    • 529 Words
    • 3 Pages
    Good Essays
    Read More
  • Better Essays

    Sandeep Voleti-Period 4/5 Honors Chemistry Titration Lab Write Up
    • 2337 Words
    • 10 Pages

    Sandeep Voleti-Period 4/5 Honors Chemistry Titration Lab Write Up

    Titration is a method, which is meant to find the concentration of either an acid or a base by adding a measured amount of it to a known volume and concentration of an acid or base1. Titration starts with a beaker or Erlenmeyer flask containing a very precise volume of the known concentration solution and a small amount of indicator, which is put underneath a burette containing the solution with unknown concentration1. Small drops of the titrant are then added to the known solution and indicator until the indicator changes which means the endpoint has been reached. Single drops of the titrant can sometimes make a permanent or temporary change in the indicator2.…

    • 2337 Words
    • 10 Pages
    Better Essays
    Read More
  • Good Essays

    6.03 Titration Lab
    • 573 Words
    • 3 Pages

    6.03 Titration Lab

    The pH indicator, phenolphthalein, turned a light shade of pink when it was in a solution with a pH of 7. Neutralization reactions occur when an acid is mixed with a base. The product of this reaction is a salt and water. These reactions are double displacement reactions, because the cation of the base mixes with the anion from the acid, forming a base, and the hydrogen from the acid mixes with the anion from the base, forming water. In this reaction, the sodium ion from the sodium hydroxide attracts to the acetate ion from the acetic acid, and the extra hydride ion bonds with the negative hydroxide ion to form water. The water produced by the reaction had a pH of seven, and so when the whole solution was light pink, we knew the reaction had fully…

    • 573 Words
    • 3 Pages
    Good Essays
    Read More
  • Better Essays

    6.03 Calorimetry Lab
    • 1068 Words
    • 5 Pages

    6.03 Calorimetry Lab

    Besides, the conical flask should be stirred all along the titration to ensure the two solutions can be mixed evenly. Furthermore, repeat the experiment for getting the average readings to ensure the accuracy of the experiment. Lastly, keep the eyes in level with the liquid surface while reading the burette to prevent parallax…

    • 1068 Words
    • 5 Pages
    Better Essays
    Read More
  • Satisfactory Essays

    LAB 20C
    • 561 Words
    • 3 Pages

    LAB 20C

    2. To titrate an acetic acid solution with 0.50M sodium hydroxide, and determine the molarity and percentage composition of the vinegar.…

    • 561 Words
    • 3 Pages
    Satisfactory Essays
    Read More
  • Good Essays

    Empirical Formula For Magnesium Oxide Essay
    • 408 Words
    • 2 Pages

    Empirical Formula For Magnesium Oxide Essay

    The results did not match the actual empirical formula for magnesium oxide. Our empirical formula of magnesium oxide was Mg4O3 instead of MgO which is the actual empirical formula. In performing the calculations, there was a 32% error.…

    • 408 Words
    • 2 Pages
    Good Essays
    Read More
  • Good Essays

    Shurp!
    • 914 Words
    • 5 Pages

    Shurp!

    In this experiment we experimented with titration. We saw the effects of titration on an acid and then on a base. The acid we used was hydro chloric acid and the base was ammonia. The acid turned pinkish red when properly titrated and the base turned clear. We used phenolphthalein as the titrate which turns red in acidic solutions and clear in basic solutions. The control aspects of this lab were the hydrochloric acid and ammonia. The independent variable was the titrate the phenolphthalein. We measured how many drops of the phenolphthalein it took to titrate the acid or the base.…

    • 914 Words
    • 5 Pages
    Good Essays
    Read More
  • Powerful Essays

    Chem 2c Post Lab
    • 1576 Words
    • 7 Pages

    Chem 2c Post Lab

    For each trial, enter the precise volume in mL of sodium thiosulfate solution used in the titration of your…

    • 1576 Words
    • 7 Pages
    Powerful Essays
    Read More
  • Good Essays

    Percentage Composition by Mass of Magnesium Oxide
    • 488 Words
    • 2 Pages

    Percentage Composition by Mass of Magnesium Oxide

    Objective: To measure and calculate the ratio of magnesium to oxygen in magnesium oxide. To compare the lab ratio to the percent composition calculation based on the formula.…

    • 488 Words
    • 2 Pages
    Good Essays
    Read More
  • Good Essays

    Magnesium Lab
    • 797 Words
    • 4 Pages

    Magnesium Lab

    Procedure: 1. Cut the strip of magnesium into 10 mm pieces with the scissors/knife and then hold them in the beaker. 2. Measure out 5 mL of HCl (.5 molarity) with the dropper into the graduated cylinder. 3. Pour HCl (.5) from the graduated cylinder into the test tube. 4. Put a piece of magnesium into the test tube filled with HCl. 5. Start stopwatch when the magnesium is placed into the test tube filled with HCl (.5) and stop it when the magnesium has dissolved (flick the bottom of the test tube periodically to make sure that the magnesium mixes properly with the HCl). 6. Record your data and then dump out the HCl and wash your materials. 7. Repeat steps 2-6 with .5 molarity until you have completed 5 trials with it. 8. Get a new test tube. 9. Repeat steps 2-6 with 1 molarity. 10. Repeat steps 2-6 with 1 molarity until you completed 5 trials with it. 11. Get a new test tube. 12.…

    • 797 Words
    • 4 Pages
    Good Essays
    Read More
  • Good Essays

    Unknown Acid Titration
    • 1249 Words
    • 5 Pages

    Unknown Acid Titration

    The concentration of one solution was determined by its reaction with a standard solution. The molar mass of unknown acids were also calculated. While learning to titrate, I learned several other skills in the process. I learned how to prepare a standard solution of sodium hydroxide, how to standardize a sodium hydroxide solution by using potassium hydrogen phthalate (KHP), how to find the molar masses of unknown organic acids when given whether the acid is monoprotic, diprotic, or triprotic, and how to calculate the molarity of a soft drink. At the same time, other skills were practiced. Skills such as calculating molarity, molar mass and percent error were exercised.…

    • 1249 Words
    • 5 Pages
    Good Essays
    Read More
  • Good Essays

    Chemical Reaction Lab
    • 663 Words
    • 3 Pages

    Chemical Reaction Lab

    To a 150-mL, 0.1 gram of sodium hydrogen (solid) was measured and added. Drop wise, 1 mL of 1.0 M HCl was slowly added. The characteristics of the reaction were recorded.…

    • 663 Words
    • 3 Pages
    Good Essays
    Read More
  • Good Essays

    Chemical Synthesis
    • 490 Words
    • 2 Pages

    Chemical Synthesis

    In the first reaction, magnesium was burned to produce magnesium oxide. The reaction produced a bright light, which is evidence of a chemical change. The second reaction occurred as a result of solid magnesium reacting with hydrochloric acid. The reaction produced heat and bubbles, both indications of a chemical change. A wood splint was used to determine that the gas produced was hydrogen gas, hence the other product is magnesium dichloride. In the third reaction, ammonium carbonate was heated to decompose into two gases, due to the absence of anything solid or liquid following the reaction. A wood splint was used to determine that carbon dioxide was present, since the lit splint was extinguished when put in the test tube. Therefore, the other product is ammonium oxide. The fourth reaction occurred between calcium carbonate and hydrochloric acid. When mixed, the two reactants produced a clear aqueous solution, calcium chloride, water, and a gas. The gas was concluded to be carbon dioxide, since the wood splint was extinguished after it was exposed to the gas in the test tube. In the fifth reaction, the two reactants, copper(II) chloride and zinc produced a permanent color change in the solid substance in the aqueous solution. The remaining solid appeared to be black reddish and concluded to be copper, where the aqueous solution is zinc chloride. The six reaction resulted in the formation of a precipitate in an aqueous solution. Copper(II) chloride reacted with sodium phosphate to produce a fluffy blue solid, copper(II)…

    • 490 Words
    • 2 Pages
    Good Essays
    Read More

Related Topics