Preview

Law of conservation of mass

Good Essays
Open Document
Open Document
773 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Law of conservation of mass
Law of Conservation of Mass Lab
Introduction-
Problem: To validate the law of conservation of mass and to examine what happens when one Alka- Seltzer tablet is combined with water.
Hypothesis: If the Alka-Seltzer tablet is combined with water, then Co2 will be produced because when mixing the two compounds, a chemical reaction will occur.
Materials:
-Alka-Seltzer tablet -Balance (Grams) -Balloon -Flask (125 mL) -Water -File -Forceps -Massing tray

Procedure:
1. Mass the Alka-Seltzer tablet then put the flask on the scale to record the mass, and zero the scale.
2. Add 50 mL of water to the flask and record the mass. Subtract the mass of the flask from the mass of the water in the flask to find the total mass of the water. Next mass the balloon. Add together the mass of the water and tablet
3. Break the Alka-Seltzer tablet over the massing tray, then using the forceps pick up both pieces of tablet. When dropping the tablet into the flask have your partner place the balloon over the opening of the flask at the same time.
4. Wait until fizzing/ bubbling subsides (aprox. 20 minutes) then mass the flask with balloon on top. From this subtract the mass of the flask and balloon from the total mass of the flask, water, tablet and balloon combined. By doing this, the number that is left should be approximately the same mass as when the experiment began.

Data Tables and Analysis:
Mass of Reactants Table
Material Mass (g)
Flask 93.20
Tablet 3.22
Balloon 2.98
50mL of water 47.59 3.22g (Tablet)
+ 47.59g (50mL of water)
50.81g (Mass of reactant)

Mass of Products Table
Material Mass (g)
Flask with Balloon and chemical reaction 146.62

146.62g (Flask with balloon and chemical reaction)
- 2.98g (Balloon) 93.20g (Flask)
50.44g (Mass of Product)

Conclusion: The purpose of this experiment was to validate the law of conservation of mass and to examine what will happen as a

You May Also Find These Documents Helpful

  • Satisfactory Essays

    2. Weigh an antacid table in a weighing boat and record the mass (+0.01 g). Transfer the tablet to a clean mortar and crush the tablet into a fine powder using the pestle.…

    • 255 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Self-Inflating Balloons

    • 528 Words
    • 3 Pages

    The question I am going to try and answer with an experiment is: How can we inflate a balloon by mixing an acid and a base?…

    • 528 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Firstly we calculated the mass of the beaker and then we put the assigned grams of sodium carbonate…

    • 612 Words
    • 3 Pages
    Good Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 356 Words
    • 2 Pages

    Add 50 milliliters of the solution you want to test to the beaker and record its mass. The mass of the solution is equal to the total mass minus the mass of the beaker.…

    • 356 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Alka Seltzer Lab

    • 624 Words
    • 3 Pages

    * Place two tablets inside the balloon. You may need to break the tablets into pieces to do…

    • 624 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Gainless Steel Lab

    • 685 Words
    • 3 Pages

    5. While the cylinder is heating, measure approximately 100 mL of water in a graduated cylinder. Record the mass of the water to one decimal place. Then pour the water into a plastic-foam cup.…

    • 685 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Shurp!

    • 914 Words
    • 5 Pages

    In this experiment we experimented with titration. We saw the effects of titration on an acid and then on a base. The acid we used was hydro chloric acid and the base was ammonia. The acid turned pinkish red when properly titrated and the base turned clear. We used phenolphthalein as the titrate which turns red in acidic solutions and clear in basic solutions. The control aspects of this lab were the hydrochloric acid and ammonia. The independent variable was the titrate the phenolphthalein. We measured how many drops of the phenolphthalein it took to titrate the acid or the base.…

    • 914 Words
    • 5 Pages
    Good Essays
  • Better Essays

    AP phyiscs lab

    • 893 Words
    • 4 Pages

    III. Procedure- The first thing one must do to identify which substance is which is to calculate the densities. To do this, one must take the mass and volume of each individual substance. Starting with mass, one can use the triple beam balance. Make sure the balanced is zeroed. Once that is true, place the object onto the balance a carefully find the mass of the object. Repeat and record the results found of each individual substance. To find the volume, one can use the water displacement method. One will fill up a graduated cylinder with water to a specific amount. 20 mL is sufficient. Once completed, one will drop one of the substances into the graduated cylinder and record how far the water level rises. If it starts at 20mL and rises to 22mL then the volume of the substance is 22mL minus 20mL, so 2mL. Repeat and record the results found of each individual substance.…

    • 893 Words
    • 4 Pages
    Better Essays
  • Good Essays

    6.05 Chemistry

    • 367 Words
    • 2 Pages

    5. Drop one Alka-Seltzer in the water and record how long it takes it to dissolve.…

    • 367 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    3. Then put one Alka-Seltzer Tablet in one cup and time it until it dissolves completely.…

    • 423 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Bags of Reactions Lab

    • 712 Words
    • 3 Pages

    1. Measure 25mL of water and put into a resealable bag. Flatten air out of the bag and seal it. Record the mass in Table 1.…

    • 712 Words
    • 3 Pages
    Powerful Essays
  • Good Essays

    Unknown Acid Titration

    • 1249 Words
    • 5 Pages

    2. Take the soft drink solution from a buret on the back lab table recording the initial and final volume from the soft drink buret. Add approximately 40 mL of the soft drink to your flask. Make sure you record the exact volume to the 100ths place. Do not add water to your…

    • 1249 Words
    • 5 Pages
    Good Essays
  • Better Essays

    Alka-Seltzer tablets (at least 12; if you plan to do additional variations to the project, you will want to get a larger box)…

    • 946 Words
    • 4 Pages
    Better Essays
  • Powerful Essays

    Density of Sprite

    • 1742 Words
    • 7 Pages

    In the first phase of the experiment, the 25 ml Pipette is used to measure the volume and mass of the solution. Another beaker was in grams. Pipette was used to measure 25ml of regular Sprite. The solution was drawn the beaker and its mass was measured on the electronic balance. Mass of the solution was then calculated by subtracting beaker's weight and beaker with solution's weight.…

    • 1742 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    How Much Co2 Lab

    • 1228 Words
    • 5 Pages

    25mL of the prepared HCl solution was added to a 125mL Erlenmeyer flask, along with a 0.5-1.0g piece of Alka-Seltzer tablet. After complete evolution of CO2, the neck of the flask and rubber stopper were completely dried. The tablet fragment…

    • 1228 Words
    • 5 Pages
    Good Essays

Related Topics