Preview

Lab Experiment: Determination of Erythrosine Concentration Using UV-Visible Spectrophotometer

Better Essays
Open Document
Open Document
1116 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Lab Experiment: Determination of Erythrosine Concentration Using UV-Visible Spectrophotometer
PRACTICAL 7
TITLE : DETERMINATION OF ERYTHROSINE CONCENTRATION USING UV- VISIBLE SPECTROPHOTOMETER

INTRODUCTION
In chemistry, spectrophotometry is the quantitative measurement of the reflection or transmission properties of a material as a function of wavelength. It is more specific than the general term electromagnetic spectroscopy in that spectrophotometry deals with visible light, near-ultraviolet, and near-infrared, but does not cover time-resolved spectroscopic techniques.
Spectrophotometry involves the use of a spectrophotometer. A spectrophotometer is a photometer that can measure intensity as a function of the light source wavelength. Important features of spectrophotometers are spectral bandwidth and linear range of absorption or reflectance measurement.
A spectrophotometer is commonly used for the measurement of transmittance or reflectance of solutions, transparent or opaque solids, such as polished glass, or gases. However they can also be designed to measure the diffusivity on any of the listed light ranges that usually cover around 200nm - 2500nm using different controls and calibrations. Within these ranges of light, calibrations are needed on the machine using standards that vary in type depending on the wavelength of the photometric determination.
An example of an experiment in which spectrophotometry is used is the determination of the equilibrium constant of a solution. A certain chemical reaction within a solution may occur in a forward and reverse direction where reactants form products and products break down into reactants. At some point, this chemical reaction will reach a point of balance called an equilibrium point. In order to determine the respective concentrations of reactants and products at this point, the light transmittance of the solution can be tested using spectrophotometry. The amount of light that passes through the solution is indicative of the concentration of certain chemicals that do not allow light to pass



References: 1. 2010-2011. Food Chemicals Codex, Seventh Edition. United Book Press, Inc. Baltimore. MD. Page 329 2. Dr. A.J.Nair. 2007. Principle of Biotechnology. Laxmi Publication (P) Ltd. New Delhi. Page 265-266 3. http://en.wikipedia.org/wiki/Spectrophotometry 4. http://www.e-journals.in/PDF/V1N2/424-430.pdf

You May Also Find These Documents Helpful

  • Good Essays

    Using a spectrophotometer, the absorbance, A, of a solution measured directly. FeSCN2+ is placed into the spectrophotometer and their absorbances at 447nm are measured.…

    • 849 Words
    • 4 Pages
    Good Essays
  • Best Essays

    Spectroscopy is the study of light. A spectrophotometer is a machine used to determine the absorbance of light at any given wavelength. It does this by using a source of white light through a prism, which gives multiple wavelengths that can be individually focused (Ayyagari and Nigam, 2007). Substances are put into cuvettes that are glass or quartz containers that light can easily travel through. The light that is being focused travels through the substance gets absorbed by the substance and is reflected back and read by galvanometer which had the ability to detect electric currents (Verma, R). The absorbance reading is then given, absorbance is usually between 0.0 – 2.0, any higher than 2.0 may mean not enough light is getting through to the galvanometer (Bhowmik and Bose, 2011). When using the spectrophotometer it is necessary to use a control or blank to zero or tare the machine in between every new wavelength or concentration, this control is water (Ayyagari and Nigam, 2007). The correlation between the numbers acquired through spectroscopy can be seen using the Beer- Lambert Law. The Beer- Lambert law states that the amount of light absorbed at a certain wavelength is proportional to the concentration of the absorbing substance (Fankhauser, 2007).…

    • 2210 Words
    • 9 Pages
    Best Essays
  • Good Essays

    Spectrometer. The amount of light that penetrates the solution and strikes the photocell is used…

    • 476 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Of Exp #5: In this experiment we will learn about the spectroscope and how it works. To learn the concept of quantitative measurements, to construct a spectroscope and, to use it for taking quantitative measurements.…

    • 1694 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Absorbance is defined as a measure of the capacity of a substance to absorb light of a specified wavelength. Concentration is defined as the amount of solute per unit volume of solution. Beer’s law is defined as a method that relates the absorption of light to the properties of the material through which one substance like light is traveling. Calibration Curve is defined as a general method for determining the concentration of a substance in an unknown sample by comparing the unknown to a set of standard samples of known concentration.…

    • 556 Words
    • 4 Pages
    Good Essays
  • Better Essays

    protocal

    • 987 Words
    • 4 Pages

    1. To understand how spectrophotometry can be used to determine the concentration of a light-absorbing substance.…

    • 987 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    3.2.07 Lab Questions

    • 268 Words
    • 2 Pages

    A spectroscope is a scientific instrument that is used to measure the intensity of the light at different wavelengths by calculating the amount of light energy that is being absorbed by the electrons at different wavelengths.…

    • 268 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    This lab will teach me how to use a spectrophotometer. The use of the spectrophotometer is to measure the concentration of solute. The solute being measured must be colored and is determined based on the adsorption of light photons on a wavelength. The spectrophotometer uses a beam of light that strikes the diffraction grating that basically forms of prism of light. Then only a specific wavelength of light shines through the spectrophotometer and interacts with the solute. The light that continues past the solute hits the phototube. The spectrophotometer then digitally shows the amount of units that have been absorbed or transmitted. Transmittance is the amount of light that gets through the sample. This is shown as a percent of all the possible light that could’ve gotten through. Absorbance is the opposite of transmittance and the reciprocal of it. This shows how much light got trapped in the solute. In this lab we will use a few different solutions in the spectrophotometer to get a basic feel on how it works. We will record the absorbance as well as do calculations using mean and standard deviation. We will then graph our results and compare them with the class values of the three unknown Methylene blue samples. At the end of the lab the actual concentrations of each unknown will be shared. We will then compare how accurate and precise our results are with the actual.This lab will teach me how to use a spectrophotometer. The use of the spectrophotometer is to measure the concentration of solute. The solute being measured must be colored and is determined based on the adsorption of light photons on a wavelength. The spectrophotometer uses a beam of light that strikes the diffraction grating that basically forms of prism of light. Then only a specific wavelength of light shines through the spectrophotometer and interacts with the solute. The light that continues past the solute hits the phototube. The spectrophotometer…

    • 1420 Words
    • 6 Pages
    Satisfactory Essays
  • Satisfactory Essays

    red dye number 40

    • 1196 Words
    • 5 Pages

    Introduction: White light is composed of many different wavelengths of light combined together. A spectrophotometer is an instrument that shines a single wavelength of light of a known intensity into a solution and then measures the intensity of the light exiting the solution. If a solution contains any compound that absorbs light, the intensity of light exiting the solution will be less than what entered the solution. On the other hand, if none of the compounds in the solution absorb at that wavelength of light, then the intensity of the light exiting the solution will be the same as that entering.…

    • 1196 Words
    • 5 Pages
    Satisfactory Essays
  • Good Essays

    beer's law

    • 1078 Words
    • 5 Pages

    A spectrometer is essential to attain the data from absorbance studies, you will not collect the data…

    • 1078 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    5. A spectroscope is an instrument used to measure properties of light over a specific portion of the electromagnetic spectrum, typically used in spectroscopic analysis to identify materials. The variable measured is most often the light's intensity but could also, for instance, be…

    • 429 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    A solution is composed of a solute dissolved into a solvent. The most common solvent is water. Determining the components and concentrations of solutes in a solution is carried out through a variety of techniques known as spectroscopy. Spectroscopy is the analysis of spectra, typically light or mass spectra, where the spectrum of a source is used to determine the composition of a substance. There are many different spectroscopic methods including circular dichroism, mass spectrometry, Raman, spectroscopy, nuclear magnetic resonance (NMR) spectroscopy, and ultraviolet-visible spectroscopy. A UV-Vis spectrophotometer measures absorbance, which is related to the transmittance of light through a solution. Absorbance is the measure of light intensity that is absorbed by a sample. A=log Io/I is the calculation. Beer’s law mathematically expresses the relationship between absorbance and sample concentration. Absorbance and concentration are directly are proportional. A Beer’s law plot is a graph showing the linear relationship between absorbance and concentration that can be fit to a straight line from which the concentration of an unknown sample can be calculated. A colorimeter is a type of…

    • 1297 Words
    • 8 Pages
    Powerful Essays
  • Better Essays

    Environmental protection has been a growing concern for many people in the recent years. With talks of global warming, deforestation, and rising ocean acidity in the news it is safe to assume that protecting our environment is a task everyone will need to be a part of. One example of environmental harm caused by humans is the leaking of phosphates into water supplies through the use of garden fertilizers. When there is too much phosphate in the water it causes process of eutrophication. Eutrophication is where the level of algae and marine life plant matter bloom to disastrous levels[3]. With the extreme amounts of algae in the water the oxygen supply of the water is diminished and marine life is destroyed[3]. While very small amounts of phosphates are necessary for the growth of roots in plant life the levels of phosphate added to water from fertilizers are dangerous for the ecosystem[2]. In order to calculate the concentration of phosphate in water the molar absorptivity must be found first. For this experiment using a stock phosphate solution is ideal as the concentration (in ppm) of phosphate can be controlled. First, six samples of varying phosphate concentration (0.5, 1.0, 2.0, 3.0, 4.0, 5.0 ppm) will be made by diluting 20 ppm stock phosphate solution with deionized water. This can be achieved by using the dilution equation: M1V1=M2V2. Due to phosphate being uncolored an ammonium molybdate will be used to react with phosphate in the water to form a phosphomolybdate complex. This complex will change color when reacted with a Sn(II)Cl2 solution turning it a dark blue color. When the complex has changed color it can be placed into 1 cm…

    • 1216 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    chemistry

    • 2781 Words
    • 9 Pages

    UV Spectrophotometer has 4 main components which is the UV light source, the sample, detector and the processor/recorder. Spectrophotometry is a technique that uses the absorbance of light by an analyte (the substance to be analyzed) at a certain wavelength to determine the analyte concentration. Useful wavelengths for spectrophotometry range from 185 to 3,000 nm. Spectroscopy is one of the most powerful analytical techniques in modern science. Spectroscopy works by correlating the concentration of a species in solution to the amount of light it absorbs. It included the observations of absorption or emission of electromagnetic radiation resulting from transitions of atoms or molecules from one energy level to other level. The spectrophotometer measures how much light is absorbed at a given wavelength. When an atom or molecule absorbs energy, electrons are promoted from their ground state to an excited state. When a molecule at a ground state absorbs energy, it called transition to a higher energy state.The higher energy state can be said as excited state. In a molecule, the atoms can rotate and vibrate with respect to each other. These vibrations and rotations also have discrete energy levels, which can be considered as being packed on top of each electronic level.…

    • 2781 Words
    • 9 Pages
    Powerful Essays
  • Better Essays

    Journal Article Critique

    • 1695 Words
    • 7 Pages

    * Spectrophotometry: A method used to identify or calculate certain molecules in a solution depending on its reaction to different levels of light.…

    • 1695 Words
    • 7 Pages
    Better Essays

Related Topics