Preview

Iodine Clock Reaction Essay

Good Essays
Open Document
Open Document
1146 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Iodine Clock Reaction Essay
CONCLUSION
The experimentally obtained data collected for the reaction between IO3- and HSO3- at various temperatures is clearly supported by the Arrhenius equation. Referring to Graph 1.7, the line of best fits clearly passes through most of the data points displaying a linear relationship between temperature and the rate of the reaction. The R-squared of the graph which is a statistical measure of how close the data are to the fitted regression line is 0.9818. This number is extremely low which indicates that the data points are very close to the theoretically derived calculations.
Looking at Graph 1.6, it can be said with confidence that the rate of the reaction is directly proportional to the approximate temperature. For e.g. At 15 °C,
…show more content…
Due to the lack of literature value for the effects of temperature on the rate of the Iodine Clock Reaction, there was no final percentage error. However, Looking at Graph 1.6, the line of best fits clearly shows the low precision throughout this experiment resulting in an increase of Random error.
This could be due to the many assumptions being made in this experiment. We are assuming that there was no cross contamination between Solution A, B and water. Though it is highly likely that someone used the same pipette or measuring cylinder to measure chemicals as all three solutions were clear and colourless as notes in the overall observations. This could affect the content of each of the beakers as it would change the concentrations and/or volume of the solutions which was to be kept constant (refer to Table 1.1) greatly affecting the data obtained.
It was also assumed that both Sol.A and Sol.B beakers were exactly at the same temperature when the reaction occurred. Even though the temperatures of both beakers were recorded, it was highly likely that the temperature increased or decreased between the time when they were taken out of the water baths and the time they were mixed together. Though this would not be a primary source if error, nonetheless, it can account for a very small part of the experimental

You May Also Find These Documents Helpful

  • Satisfactory Essays

    5. There is a possibility that there was some of the copper (II) chloride left in the beaker due…

    • 440 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 992 Words
    • 4 Pages

    In the first process of the lab, you measure the mass of water transferred from a buret to a beaker, to determine the experimental mass of the water, and the volume of the water collected. We measured the temperature of the water so we could calculate the density of the water, which enabled us to calculate the actual volume of water, by using the density and the measured volume of water. To determine the percent error, we had to subtract the actual volume of water by the experimental volume of water transferred from the buret to the beaker, and then divided it by the actual volume and multiplied it by 100. In the second process, you perform the same steps you did for the buret, but instead, you use a 5.00mL or 10.00mL pipet. You repeated each…

    • 992 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Methanol Boiling Point

    • 569 Words
    • 3 Pages

    The results gathered clearly state that our results which were 71oC and 90oC are quite close to the classes average set of results by about 2, but, when graphing the alkalise by the boiling and melting point they both follow the same slope, it continues to rise just like the results gathered in the example do.…

    • 569 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    beaker. Three trials were done and measurements were recorded. The purpose of the second experiment…

    • 671 Words
    • 5 Pages
    Satisfactory Essays
  • Good Essays

    Plain Water Experiment

    • 816 Words
    • 4 Pages

    experiment is in the isotonic solution. is clear in beaker B ( fresh water) and beaker A…

    • 816 Words
    • 4 Pages
    Good Essays
  • Better Essays

    We dispensed each fluid into the small test tubes by using the correct amounts on the given chart. The test tubes were tested for temperature by placing it in hot water baths at various temperatures. Test tubes 2 & 3 were placed in a beaker at room temperature, 22°C. The rest of the test tubes were placed in hot bathes with a waiting period of ten minute interval. We placed test tubes 4 & 5 in 50°C, 6 & 7 at 40°C, 10 & 11 in 60°C, 12 & 13 in 70°C, and 14 & 15 in 80°C. We placed a thermometer on the test tubes…

    • 1541 Words
    • 7 Pages
    Better Essays
  • Good Essays

    I think that as the temperature increases, the rate of reaction also increases, to a point when it dramatically decreases.…

    • 1747 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Unfortunately time didn’t allow us to complete both parts of the experiment on our own and so we relied on the results of others in class. In terms of error, it gives plenty of opportunity for inconsistencies in the data. The inconsistencies could exist due to equipment, or understanding of the lab…

    • 274 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    The rates at which reactions occur depend on the composition and the temperature of the reaction mixture. Usually the rate of reaction is found to be proportional to the concentrations of the reactants raised to a power.1 There are many reactions that have a rate law in the form of:…

    • 1174 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Abstract: From the shown calculations & graphical analysis, the experimentally determined rate law is rate = K[I-].969 [H2O2].991 and the experimentally determined activation energy is 59.50 kJ/mole.…

    • 706 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Science Rates of Reaction

    • 1060 Words
    • 5 Pages

    Because this experiment is only conducted to see how the concentration of a reactant affects the rate of reaction, other variables must be kept the same for it to be a fair test: the same person is going to watch the reaction; a thermometer can record the room temperature to make sure that it’s consistent throughout the experiment; the other variables will stay consistent without interferences; none of the reacting solutions will be stirred.…

    • 1060 Words
    • 5 Pages
    Good Essays
  • Good Essays

    The Iodine Clock Reaction

    • 824 Words
    • 4 Pages

    2 S2O32−(aq) + I2(aq) → S4O62−(aq) + 2 I−(aq) This reaction is much faster than the previous, so the conversion of I2 back to I− is essentially instantaneous. In a typical experiment, known concentrations of S2O82- and I− are mixed with a small amount of S2O32- and starch. As reaction the first proceeds, S2O82- and I− react to produce I2, but nothing appears to be happening because the second reaction is consuming the I2 as quickly as it is formed. The important moment is when the S2O32- runs out, for then the I2 is no longer consumed (see the second reaction), and the dark blue starch−I2 complex forms. The stoichiometry of the second reaction indicates that one I2 molecule must have been generated for every 2 ions of S2O32 − initially present in the solution. [I2 ] generated(from first reaction) = [I2 ] consumed(in second reaction) = {1/2[S2O32-] initially present} Note that the change in concentration of I2 (before the blue complex forms) is fixed by amount of S2O32- included in the initial reaction mixture. 1 [ S O2 − ] d [ I2 ] 2 2 3 rate = = dt t Where t = time for blue color to appear. In this experiment you will: A. Determine Rate Law and Rate Constant {k is constant at constant temperature} B. Vary temperature and estimate EA {Using the Arrhenius Equation} A. Determining the rate constant (k) and the rate law for the iodine-clock reaction:…

    • 824 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Iodine-Clock Reaction

    • 2660 Words
    • 11 Pages

    The data obtained was graphed in a linear regression form, using the Arrhenius equation: lnk=-EaR-1T+lnA, reaction rate: rate = k[A]x[B]y and other principles held in chemistry. The graph from the results determined that there is a relation between rate and the previously mentioned factors. The results validated the notion that temperature, concentration and catalysts can manipulate chemical kinetics.…

    • 2660 Words
    • 11 Pages
    Powerful Essays
  • Powerful Essays

    Rennin Enzyme Experiment

    • 1543 Words
    • 7 Pages

    Some milk was also lost when the rennin was added to it and the test tube was shaken. This may have affected the reaction rate of the enzymes. It was very difficult to calculate the exact temperature at which the enzyme and substrate were mixed because their temperatures dropped or rose rapidly when they were removed from the hot or cold baths. This further affected the accuracy of the experiment as temperatures tested were not exact. Repeated trials of the same temperature all had similar results which made the averages precise. There were no outliers so averages were not too high or too low. If an outlier occurred during experimentation because of known reasons the trial was tested again.…

    • 1543 Words
    • 7 Pages
    Powerful Essays
  • Satisfactory Essays

    Charles' Law Lab Report

    • 301 Words
    • 2 Pages

    Potential sources of error in this lab were: experiment was conducted once rather than three times, water in the sink was not cold enough, water in the beaker was not hot enough, lack of a working Bunsen burner…

    • 301 Words
    • 2 Pages
    Satisfactory Essays