Preview

How Are Colors In Fireworks Produced?

Good Essays
Open Document
Open Document
992 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
How Are Colors In Fireworks Produced?
Daniel A. Parra
Mr. Reimer
Honors Chemistry, 5th
10/25/11
‘Cause Baby, You’re a Firework How are the colors in fireworks produced? When I first thought about where the colors from fireworks came from, I thought that they came from food coloring that was mixed with gun powder. Also, from previous knowledge that I had about how neon lights were formed, I imagined that the electrons got excited when they got some sort of voltage or energy, and I also knew that when they got relaxed they emitted energy known as photons or light. However, this does not explain the colors in a firework. I also did not know that it was possible to use something other than electricity to excite the electrons. To start my experiment, I and my group followed these steps. My group put on their goggles, carefully turned the Bunsen burner on, and we burned one of the wet popsicle sticks
…show more content…
These electrons inside of the shell model get excited because, like electricity in neon lights, fire is applied to the atom. This thermic energy found inside of the fire causes the electrons to go on to higher energy levels. The electrons after a while prefer to go back to their original energy level, and this energy that was once absorbed by the fire is now being released by this process. The energy comes out in the form of photons or light. The color just varies from chemical to chemical. Also, the wavelength determines the color that the fireworks have because the colors change in the electromagnetic spectrum. As observed by my data all of the salt’s wavelengths correspond to the specific color that they burned on the electromagnetic spectrum. For example, Copper Chloride burned green when placed on the fire. This corresponds to the color green on the electromagnetic spectrum, which is around 525nm wavelength. However, this energy was not produced by the chemical reaction; it was only transformed by

You May Also Find These Documents Helpful

  • Good Essays

    Week 4 iLab Report

    • 640 Words
    • 4 Pages

    8) Trial D: Remove the syringe and empty the beaker. Add a Thermometer to the beaker. Add 100 mL of Room Temperature water. Click on the beaker and then select a Bunsen Burner from the Equipment menu. Heat the beaker until the water temperature reaches 100° C. Then add another 100 mL of Room…

    • 640 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Stoichiometry Lab Report

    • 1941 Words
    • 8 Pages

    2. Heat each test tube gently over a Bunsen burner flame and record your observations in your notebook.…

    • 1941 Words
    • 8 Pages
    Good Essays
  • Good Essays

    In Part 1 of the lab the tongs were used to heat a strip of copper foil in the Bunsen burner. The copper was allowed time to cool and the spatula was used to scrape its surface. Also a strip of Magnesium was heated in the bunsen burner and when it combusted it was held over the ceramic plate.…

    • 857 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Lab 20: Flame Tests

    • 1252 Words
    • 6 Pages

    When atoms or ions in ground state are heated to a higher temperature, some electrons absorb enough energy to move them to higher energy levels. This is known as the excited state. However, the excited configuration is unstable, and the electrons must return back to their positions in the lower energy level. As they return, the energy that was previously absorbed is now emitted in the form of electromagnetic energy. This energy can be displayed in the form of visible light. The main purpose/objective of this lab was to observe the characteristic colors produced by certain metallic ions when they are vaporized in a flame. Another main objective of this lab was identifying the unknown metallic ions by means of flame tests. In this lab, this is what was supposed to be…

    • 1252 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    Next the starting temperature of the water has to be measured. After that the can of water has to be clamped around 5-10cm above the unlit alcohol burner. Then light the burner making sure that it is place immediately underneath the can. Throughout the experiment the water should be stirred using a metal stirrer so the water is evenly heated. When the water gets to around 15 degrees above the starting temperature of the water, put the cap back on the alcohol burner. Then weigh the alcohol burner again without the cap on to find out how much alcohol was used. After start the whole method again using different alcoholic…

    • 532 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Flame Test Lab

    • 259 Words
    • 2 Pages

    I. Purpose: To observe the colors produced when compounds are introduced into a flame and the electrons become excited. To estimate the wavelength of light produced, then calculate the frequency and energy of the light…

    • 259 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Caloric Food Content Lab

    • 704 Words
    • 3 Pages

    First, use a digital scale to determine the empty weight of the 100ml beaker. The, you are going to fill the beaker half way with water (approximately 50ml) and weigh it again. Take the water and beaker weight minus the empty beaker weight is the net weight of water used for the experiment, and record it. Take a piece of aluminum foil and place on the table top to catch any spills, and it also can be used to reflect heat upward. Set the burner stand over the aluminum foil and place the beaker of water on top of the burner stand. Measure and record the initial temperature of water. Marshmallow: Determine the mass of the marshmallow and an empty fork. Take the marshmallow on the fork and light it using a candle. Once the marshmallow is lit and burning, hold it under the beaker of water while stirring the water with the thermometer. When the marshmallow is completely burnt, weigh the fork with the marshmallow remnants and record. Subtract the weight of the empty for to obtain the weight of the unburned marshmallow residue. Record the temperature of the water, which is the final temperature. Peanut or Walnut: It may take a while to keep them lit, so you made to move them around in the flame to get them burning. When it is well lit and burning, immediately hold the peanut under the beaker of water and occasionally stir the water with the thermometer. When the walnut is peanut or walnut is almost completely burned and the flame has been extinguished, record the final temperature of the water and determine the weight of the nut residue and record. Repeat this step using the other sample.…

    • 704 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    chem 2

    • 378 Words
    • 4 Pages

    1. Explain, in your own words, why different elements produce different colors of light when heated. Different elements produce different colors of light when heated because they are able to get to a different energy state, and then they lose energy from heat and the flame changes color.…

    • 378 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Identification of Metalic

    • 269 Words
    • 2 Pages

    Procedure: Place a little bit of each element into the well plate. Then you soak a tip of a cotton swab in each solution. Then you place the cotton swab over the Bunsen burner until the flame changes color.…

    • 269 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1. Explain, in your own words, why different elements produce different colors of light when heated.…

    • 319 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Flame Test

    • 865 Words
    • 4 Pages

    For the coloured light to be emitted, the electrons have to get enough energy to jump higher away from the nucleus and then fall back closer to it. When chemicals are heated, the flame provides energy for the electrons.…

    • 865 Words
    • 4 Pages
    Good Essays
  • Good Essays

    science of fireworks

    • 559 Words
    • 3 Pages

    Inside each firework are small packets filled with chemicals, mainly metal salts and metal oxides, which react to produce an array of colors. When heated, the atoms of each element in the mix absorb energy causing its electrons to rearrange from their lowest energy state to a higher excited state. As the electrons plummet back down to their lower energy state the excess energy gets emitted as light.…

    • 559 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Gummy Bear Lab Report

    • 935 Words
    • 4 Pages

    The heat from the Bunsen burner is used to increase the rate of reaction. The glowing splint will re-light once there is a presence of oxygen, meaning that the decomposition reaction of KClO3 has begun. Because this reaction is extremely exothermic, the heat given off of the reaction causes the sugar in the Gummy Bear to explode into a marshmallow-like substance.…

    • 935 Words
    • 4 Pages
    Powerful Essays
  • Satisfactory Essays

    Now we know how electrons react when light is shining on the atoms. These electrons absorb a specific frequency of light and become “excited”, and emit a specific frequency of light, which we see as a color. And this frequency is directly related to the color in the clothes.…

    • 441 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Glow Sticks

    • 1520 Words
    • 7 Pages

    Since glow sticks have been invented, consumers have wondered how scientists are able to create these magical sticks of light. They work without producing heat. They don’t need a battery or a bulb, Magic? This “cool” light is called luminescence. Unlike incandescence, which is light from heat energy, luminescence can be emitted at normal or lower temperatures. There are several types of luminescence, bioluminescence, is what happens in fireflies: as the “bio” prefix indicates, it’s caused by a chemical reaction in living things, cathodoluminescence, is caused by electron beams. And Chemiluminescence. Chemilumiescence is the magic behind the glow stick.…

    • 1520 Words
    • 7 Pages
    Good Essays