Preview

Heat of Neutralization

Good Essays
Open Document
Open Document
532 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Heat of Neutralization
Heat of Neutralization:
Lab Report

In part A of this lab I determined the heat capacity of a calorimeter made out of two Styrofoam cups nesting together with a cardboard top containing a hole in the middle. First I placed 50 mL of water in the calorimeter, waited five minutes for the water to reach equilibrium, and used the computer’s temperature instrument to record the final temperature of the system. Next I heated 50 mL of water in a 250 mL beaker until the water reached 43.1 C (approximately 15 to 20 C above room temperature). I then immediately used the temperature instrument to measure the temperature of the heated water, and quickly poured the water into the calorimeter. I then inserted the temperature instrument and measured the temperature of the calorimeter for the next three minutes. I was then able to calculate the heat capacity of my calorimeter by using the data that was collected. In part B of the lab I determined the heat of neutralization for hydrochloric acid and sodium hydroxide. I did this by first putting 50.0 mL of 1.0 M NaOH into the dry calorimeter and placing the lid on the calorimeter, but I did not measure the temperature of the base yet. I then obtained 50.0 mL of 1.0 M HCl in a dry beaker. I then placed the beaker next to the calorimeter and allowed the systems to sit for three minutes to balance out the temperatures. I then used the temperature instrument to measure the temperatures of both the acid and the base to ensure that the temperatures were within 0.5 C of each other. Next I completely poured all of the HCl into the calorimeter, inserted the temperature instrument into the calorimeter, and measured the temperature of the system for the next three minutes. I could then use the data collected to determine the heat of neutralization for the reaction. The scientific principles addressed by the lab were using a calorimeter to measure the enthalpy change (or heat of reaction) of a system, and determining how much heat was

You May Also Find These Documents Helpful

  • Better Essays

    The experiment yielded an exothermic reaction. The calculated enthalpy was far less than the theoretical. The cause of this is a lower heat transfer than the theoretical transfer. This can be caused by heat loss from the calorimeter outwards or not letting the reaction to fully take place.…

    • 633 Words
    • 3 Pages
    Better Essays
  • Good Essays

    From the results recorded it was identified that activity A and C had exothermic reactions, whilst activity B had an endothermic reaction. Each of the activities had initially begun with 23.4/8/9oC, however, within one minute of adding the 2nd reactants, the results began showing, as seen from the graph. Activity A and C had risen in temperature, with A gaining 4oC and in total of 2 minutes having the temperature of 27.9oC along with C increasing by 2.2oC and within 2 minutes of the experiment having the temperature of 26oC. Activity B however was the anomaly in the test, as the temperature went lower, by 1.9oC as within 2 minutes, the Ammonium Chloride and water had the temperature of 21oC. Furthermore the line graph shows Activity A and C rising to its highest peak, although it eventually reduces. Activity A for example, was rising until it reached 27.9oC and it continuously decreased, until the 10 minute mark had reached having the final temperature similar to the initial temperature. A similar thing occurred to Activity C however, as its highest peak was 26oC (2 minutes in the test), and the final temperature having a 0.1oC difference from the initial temperature.…

    • 500 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Lab 40 Calorimetry

    • 490 Words
    • 2 Pages

    Calorimetry is the measurement of the quantity of heat exchanged during chemical reactions or physical changes. For example, if the energy from an exothermic chemical reaction is absorbed in a container of water, the change in temperature of the water provides a measure of the amount of heat added.…

    • 490 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Chetos

    • 971 Words
    • 4 Pages

    The amount of heat needed to increase the temperature of an object exactly 1°C is the heat capacity of that object. The specific heat capacity of a substance is then the amount of heat it takes to raise the temperature of 1g of the substance1°C. Caliometry is the precise measurement of the heat flow into or out of a system for chemical and physical processes. Heat flow is measured in two common units, the calorie and the Joule. 1 calorie= 1 kilocalorie = 1000 calories. A calorimeter is the device used to measure the absorption or release of heat. In this lab, the water in aluminum can “calorimeter” gains the heat lost during the combustion of a Cheeto.…

    • 971 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    chem report

    • 601 Words
    • 3 Pages

    In this experiment we were wanting to find the specific heat of an unknown metal and determining what metal it was by using the formula q=c X m X change of temperature. We did two trials to compare the two and see what we come up with.…

    • 601 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Labquest Synthesis

    • 354 Words
    • 2 Pages

    In part A, solutions needed in the experiment were prepared, and the LabQuest was set up. By adding 100mL 6M HCl to 200mL deionized water, 300mL of 2M HCl solution was prepared. Then 150mL 2M NaOH solution was prepared by adding 100mL 3M NaOH to 50mL deionized water. Finally, the LabQuest was connected to the temperature probe, and set up to collect data every 15 seconds, the duration was set to be 180 seconds.…

    • 354 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Cold Pack Essay

    • 377 Words
    • 2 Pages

    In this experiment, a device that measures heat, a calorimeter, will be used. For this experiment, a calorimeter will be made with two nested Styrofoam cups, cardboard to cover the top as a lid, a thermometer, as well as about 25mL of water and about 7g of NH4¬NO3. The temperature of the solution will be closely monitored with the thermometer.…

    • 377 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Specific Heat Lab

    • 688 Words
    • 3 Pages

    A calorimeter is an instrument used to measure the change in heat in a reaction. Inside a calorimeter it is filled with water. To find the specific heat of a substance you place the substance inside the water, then measure the change in the temperature of the water and the change in temperature of the substance. The final temperature and amount of heat transferred will always be equal (q of water= q of substance). Then, using basic algebra, you can figure out the specific heat of the…

    • 688 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The purpose of this lab is to observe how heat is released or absorbed with different chemicals.…

    • 777 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    pride and prejudice

    • 713 Words
    • 3 Pages

    Add the sodium hydroxide solution to the acid solution in the calorimeter and immediately replace the lid of the calorimeter. Stir the mixture and record the highest temperature reached.…

    • 713 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Caloric Content of Food

    • 650 Words
    • 3 Pages

    The purpose of the experiment was to take foods and to find out the energy content of the foods that we are experimenting with. By hands on burning or the food and taking the date that we find and putting it into equations to find what is needed.…

    • 650 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Calorimetry Lab

    • 1355 Words
    • 6 Pages

    In parts A and B in, the calorimeter, although a good insulator, absorbs some heat when the system is above room temperature. Is the reported value for the specific heat of the metal too high or too low? Explain. Is the reported DeltaHn value for the acid- base reaction too high or too low? Explain.…

    • 1355 Words
    • 6 Pages
    Powerful Essays
  • Better Essays

    Purpose: The purpose of the experiment is to determine the calorimeter constant for the calorimeter holding a specific solution based on the data of heat lost and heat gained. The purpose is to also be able to determine the enthalpy of neutralization for the reaction of a strong acid (phosphoric acid) and a strong base (sodium hydroxide). Experimental: Materials: The materials needed for this lab included; 2 large beakers, a Calorimeter Styrofoam cup, computer, stirring rod, 2 thermometers, Logger Program, and Probes volumetric pipet. Sodium hydroxide (NaOH) (corrosive and toxic), and phosphoric acid (H3PO4) (corrosive and toxic) were used. Procedure:…

    • 1577 Words
    • 7 Pages
    Better Essays
  • Better Essays

    While waiting on the water to boil, retrieve a piece of unknown metal to be identified and record its ID letter and its mass. Once the mass of the unknown metal is recorded, put the metal into the boiling water. While waiting on the water and the metal to achieve the same thermal equilibrium, get a coffee cup and measure its mass. Then pour about 50mL of water into a coffee cup, measure the mass of the water and the coffee cup and then determine the mass of the water alone (mass of water and coffee cup – mass of coffee cup). Record the temperature of the boiling water on the hot plate with the metal and then record the temperature of the water in the coffee cup before adding the metal. Use the string attached to the metal to transfer the metal from the hot water bath to the calorimeter. Using a piece of cardboard to cover the top of the calorimeter, record the temperature of the water in the calorimeter. Repeat the experimental procedure three more…

    • 1030 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Exothermic Reaction

    • 625 Words
    • 3 Pages

    One styrofoam cup was cut in half, and the other was cut about ⅓ from the bottom. Then the shorter cut of the two was placed open side facing above and the taller cup was placed on top of the shorter cup to prevent any heat loss to the air. Then the shorter cup was secured on a base with tape and a hole was drilled with a stir stick on the top of the taller cup to allow the stir stick and a thermometer reach the chemical reaction. With the calorimeter set up and ready, the experiment was ready to be conducted. The calorimeter was placed on a metric scale and tared.…

    • 625 Words
    • 3 Pages
    Good Essays