Preview

Friedel-Craft Acylation Lab Report

Satisfactory Essays
Open Document
Open Document
149 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Friedel-Craft Acylation Lab Report
This experiment is based on the Friedel-Craft acylation reaction. The reagents involve were Ferrocene reacting with acetic anhydride in an acid-catalyzed reaction. A column chromatography was performed in order to get a pure acetyl Ferrocene product. Aluminum chloride was use as the catalyst during the Friedel-Crafts acylation of the benzene ring. Ferrocene is categorized as a super aromatic compound due to its high pi-electron density, and has the ability to be acylated with phosphoric acid as a catalyst. The latter is considered to be a milder condition when compared. The acylium cation is generated with the use of the acid, which include the protonation of acetic anhydride and the loss of the acetic acid. This reaction proceed with the cyclopentadienyl

You May Also Find These Documents Helpful

  • Good Essays

    Introduction- The synthesis of Tetraphanylcyclopentadienone was a further example of the adol condensation reaction. Tetraphenylcyclopentadienone was the final product of the three step process shown in earlier experiments. The products that were produced in one experiment were used as the reactants in the next. In the beginning of the adol…

    • 608 Words
    • 3 Pages
    Good Essays
  • Good Essays

    CHEM 1252 Lab Report 5

    • 1825 Words
    • 21 Pages

    The purpose of this experiment was to determine the differential rate law for a chemical reaction based on the relationship between the concentration of reactants and the rate of reaction. Since spectrophotometers, like Spec-20s, provide information about concentration, these instruments were used to monitor the increase or decrease in concentration of a reactant in a solution over time. By plotting [phph2-] versus time and changing the concentration of OH- used, the order of the reaction with respect to each reactant and the overall order of the reaction can be determined.…

    • 1825 Words
    • 21 Pages
    Good Essays
  • Satisfactory Essays

    Chem 1211K Lab Report

    • 1855 Words
    • 18 Pages

    The identification of the melting point of the organic acid was done to find another characteristic of the acid and to test the purity of the recrystallized pure acid. A 2-4 mm layer of unknown sample was placed into a capillary tube sealed on one end. Then the capillary tube was inserted into the side a Bibby Sterlin device. The plateau was set to 200°C on the melting point apparatus. Once the plateau temperature was reached, the sample was watched carefully. When the sample first began to melt and when it was fully melted was recorded. These numbers were the range of the melting point. A slow melting point of the unknown organic acid and a standard sample was completed next. A new plateau was set about 10°C lower than the observed melting point of the unknown sample. This time once the plateau was reached, the heating was no more than 1°C per minute. This gave a much more accurate read of both melting points. If the standard did not melt in the range listed on the label of the bottle, that meant the machine was not working properly. The standard sample and the unknown organic acid melted in their appropriate ranges.…

    • 1855 Words
    • 18 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Chemistry 116 lab review

    • 289 Words
    • 2 Pages

    The first step is to calibrate the colorimeter with0.20 M Fe(NO3)3and set the absorbance at 470 nm since it is known to keep an acidic solution throughout the entirety of the experiment. It was important to do this right at the beginning of the lab since the zeroed value of the acid was the calibration number for all of the other solutions. A total of seven solutions with different dilutions were used throughout the lab to conduct the equilibrium constant. The first step was adding 5 mL of 0.200 M Fe(NO3)3to each of the 5 test tubes. Once this was done, 0.00200 M NCS was added to the test tubes, each receiving a different amount; test tube one received 1 mL NCS-and with each test tube the amount of NCS-would increase by 1 mL, test tube 5 received 5 mL of NCS. . The next step was adding HNO3 to each test tube in different volumes; Test tube one received 10 mL of HNO3 and with each test tube the amount of HNO3 decreased by 1 mL, test tube five had no HNO3 added to it. The addition of these solutions formed five test tubes of different dilutions, but of equal volume, 10 mL each. After all of the previous trials had been completed the final step was to take each test tube and pour it into a different cuvette and measure the absorbance for each. Once the initial concentration was calculated of Fe3+, NCS and FeNCS2+ in molarity. The absorbency values were recorded and used to calculate the formation constant, K f The reference table containing volumes used in each solution is provided below…

    • 289 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Ap Chemistry Lab Report

    • 678 Words
    • 3 Pages

    A 125 mL flask was obtained. The square of aluminum was fashioned over the flask by laying the foil over the mouth and folding the sides down. A pin was then obtained and was used to poke a tiny hole in the center of the aluminum cap.…

    • 678 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    In all experiments trails, a circular blank with diameter 140 mm and 1.5 mm thickness of AA 6061-T4 was used. The tool set consists of a hemispherical punch with 60 mm diameter, bottom ring (Die) with fillet radius of 5 mm and top ring (blank holder with draw beads ) with fillet radius of 5mm. Figures. 1a and b show the formed cup and testing machine BUP 600 with the tool components setup respectively.…

    • 74 Words
    • 1 Page
    Satisfactory Essays
  • Powerful Essays

    As shown in the balanced chemical reaction in figure 1, Felbinac is synthesized from 4-bromophenyl acetic acid, phenylboronic acid, and 10% Pd/C.…

    • 1316 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    Diels-Alder Reaction Lab

    • 486 Words
    • 2 Pages

    This particular Diels-Alder reaction exploits an interesting phenomenon. Although aromatic compounds do not normally participate in Diels-Alder reactions, the central ring in anthracene is reactive as a diene. Since all three rings of anthracene can not simultaneously have benzenoid character (Figure 1), the electrons in the pi system of the central ring react more like those of a standard diene. The reaction of the central ring in anthracene allows for the formation of two, independent benzene rings, as seen in the mechanism outlined in Figure 2.…

    • 486 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Lab Report Part II

    • 1247 Words
    • 4 Pages

    Purpose: To be familiarized with the science and techniques used to identify different types of bacteria based on their DNA sequences.…

    • 1247 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    1. The dependent variable is the rate of the growth of the plant and then the independent variable would be the time of day that she waters the plant.…

    • 471 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    LAB 3 Report

    • 737 Words
    • 5 Pages

    A. Create a solubility curve for NH4Cl by plotting g NH4Cl/100 mL H20 on the y-axis, and crystallization temperature on the x-axis. Make sure to label each axis. On the same graph as the solubility curve for NH4Cl, add the solubility curve for NaCl using the data provided in Data Table 3.…

    • 737 Words
    • 5 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Chem Lab 2 Report

    • 942 Words
    • 9 Pages

    Purpose: In this experiment I will determine the mass, density, volume, lengths and temperatures of different objects and liquids to help me better understand the importance of Chemistry and how Chemistry plays a big role in our everyday lives.…

    • 942 Words
    • 9 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab Report #1 Che 101

    • 752 Words
    • 4 Pages

    While performing the lab experiments in the first unit, my observation included finding the appropriate tools in the kit in order to carry out the tasks. These experiments really showed me how to differentiate the types of tools we are using and understand the differences and reason for the differences in each. Touch was a big activated sense in these experiments, the heat from boiling the water and the cold ice from the temperature labs allowed for the connection between the results and the way the temperature felt.…

    • 752 Words
    • 4 Pages
    Satisfactory Essays
  • Better Essays

    There are twelve key principles of green chemistry that are used to evaluate how green a reaction may be. A green reaction prevents waste before it is created with little to no toxicity. Green experiments should be designed to maximize the starting materials into the final products while minimizing toxicity. Raw materials should be renewable and products should break down and not persist in the environment while reducing derivatives. All experiments should be performed in real time with use of catalysts while minimizing potential chemical accidents.…

    • 1312 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    Chem Lab Report

    • 1164 Words
    • 5 Pages

    .2400 grams of the unknown compound. This is done in duplicate and purple-tinted precipitates are placed in Gooch crucibles. The precipitates are suction dried using ethyl alcohol then acetone to…

    • 1164 Words
    • 5 Pages
    Powerful Essays