Preview

Development of a Low Cost Evaporative Cooler Unit to Suit an Industrial Environment

Powerful Essays
Open Document
Open Document
1348 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Development of a Low Cost Evaporative Cooler Unit to Suit an Industrial Environment
DEVELOPMENT OF LOW COST EVAPORATIVE COOLER UNIT TO SUIT INDUSTRIAL ENVIRONMENT

Project Advisor: Prof. R.A. Attalage

G.P.T.K. Abeysekara, K.H.H.G. Ketanwila, K.A.P. Vithana

E-mail: thanujakasun@gmail.com,ketanwila@gmail.com,koswatta@gmail.com

Department of Mechanical Engineering, University of Moratuwa, Moratuwa, Sri Lanka

Abstract

The purpose of this paper is to demonstrate the adaptability of evaporative cooling technology to Sri Lankan environment. Desiccant cooling technology is initiated to control the relative humidity level of the environment. A generic model of the evaporative cooler is constructed using direct evaporative cooling method and solid desiccant dehumidification method. The model was installed in the testing environment. The results show that the evaporative cooler is provided the sufficient level of thermal comfort to the people changing relative humidity slightly.

1. Introduction

This paper based on the research and development project conducted by the undergraduates as requirement of fulfilling the degree to develop a cooler unit to suit industrial environment. Evaporative cooling is ancient and common technique within the middle-east countries. This paper discusses the applicability of evaporative cooling technique to the hot humid environment in Sri Lanka.
On behalf of the industrial engineering context, human thermal comfort is key parameter of the efficiency and ergonomic aspects of man power. To maintain the optimum efficiency and industrial standards, maintaining a thermal comfort is essential requirement.
Because of high relative humidity level in Sri Lanka, direct evaporative cooling can’t be used to reach required thermal comfort level. Solid dehumidification with heat exchanger was added to the design to overcome the problem. This paper analyses the results of the new method and attempts to provide acceptable, cost-effective solution.
Dealing with small air capacities for evaporative cooling was



References: Watt, J. R. (1986). Evaporative Air Conditinoning Handbook. London: Chapman & Hall. Standard 55, BSR/ASHRAE. (2003, February). Thermal Environmental Conditions for Human Occupancy. Atlanta. ASHRAE. (2004). ASHRAE handbook of HVAC systems and equipments. Atlanta. Ryan, S. S. (2000, December). Desiccant Dehumidification Wheel Test Guide. Cole Boulevard, Colorado, United States. Scheuchi, R. (2009, March 10). Hoval Rotary Heat Exchanger for Heat Recovery in Ventilation Systems. United States.

You May Also Find These Documents Helpful

  • Satisfactory Essays

    7. Some homes are cooled with evaporative coolers (swamp coolers). How do they work (in…

    • 367 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Without Air Conditioning

    • 518 Words
    • 3 Pages

    Additionally, there are many health concerns that come with the heat including dehydration, heatstroke, and many others. Air conditioning lessens these illnesses…

    • 518 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Evaporative Cooler

    • 4971 Words
    • 20 Pages

    The phenomenon of evaporative cooling is a common process in nature, whose applications for cooling air are being used since the ancient years. In fact, it meets this objective with a low energy consumption, being compared to the primary energy consumption of other alternatives for cooling, as it is simply based in the phenomenon of reducing the air temperature by evaporating water on it. This process can be an interesting alternative to conventional systems in these applications where no very low temperatures are needed, like the case of air-conditioning during the summer. However, the risk of contamination by legionnaire’s disease, commonly related to evaporative cooling systems, has led in recent years to the substitution of these devices in the industry by less-efficient systems, like the case of cooling towers or evaporative condensers substituted by air-condensing refrigerating processes. Therefore, these systems based in the evaporative cooling are rarely used for cooling buildings. Toreduce this risk, evaporative cooling is produced from humid surfaces, in such a way that water evaporates due to the difference of vapor pressure between the surface and the air, and thus minimizing the generation of aerosols, responsible for the spread of legionnaire disease. Aerosols are nevertheless produced in conventional systems where water is sprayed or directly in contact with the stream of air; and the problem worsens if the water, which is re circulated, has been still in any moment or its…

    • 4971 Words
    • 20 Pages
    Powerful Essays
  • Powerful Essays

    Cooling Towers Design

    • 1546 Words
    • 7 Pages

    Cooling towers are a very important part of many chemical plants. They represent a relatively inexpensive and dependable means of removing low grade heat from cooling water.…

    • 1546 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Cooling

    • 2392 Words
    • 10 Pages

    cooling rate. In this brief study, we investigated three different cases, assuming there is no…

    • 2392 Words
    • 10 Pages
    Powerful Essays
  • Powerful Essays

    Fatigue Life of Piston

    • 6709 Words
    • 27 Pages

    1. Introduction: Demand of heat energy increased greatly in different fields of engineering during the last decade. Cooling and heating demand has already been increasing due to the evolving comfort expectations and technological development around the world. Climate change has brought additional challenges for cooling and heating systems designers. Efficient and economical technology that can be used to store large amounts of heat or cold in a definite volume is the subject of research for a long time. Thermal storage plays an important role in building energy conservation, which is greatly assisted by the incorporation of latent heat storage in building products. Devices which store heat during peak power operation and release the same during reduced power operation. Phase change material is one of the thermal…

    • 6709 Words
    • 27 Pages
    Powerful Essays
  • Powerful Essays

    Energy conservative building design has triggered greater interests in developing flexible and sophisticated air conditioning systems capable of achieving enhanced energy-savings potential without sacrificing the desired thermal comfort and indoor air quality (IAQ). This research work greatly aimed at achieving enhanced energy conservation, good thermal comfort and better IAQ for space conditioning with the application of combined variable refrigerant volume (VRV) and variable air volume (VAV) air conditioning (A/C) systems. Experimental investigation on the proposed combined air conditioning system with the application of intelligent fuzzy logic controller was performed for summer and winter climatic conditions to substantiate the energy-savings capability. The proposed system experimentally analyzed under fixed ventilation, demand controlled ventilation (DCV) and combined DCV and economizer cycle (EC) ventilation techniques effectively conserved 44% and 63% of per day average energy-savings in summer and winter design conditions respectively, while compared to the conventional constant air volume (CAV) A/C system. The results of the present investigation have proved that the proposed combined air conditioning system operated under the different ventilation strategies…

    • 9985 Words
    • 40 Pages
    Powerful Essays
  • Powerful Essays

    The Goal of this study/simulation is to find out the relation between the Building Glass type and the total amount of the cooling load needed to keep the building temperature within the comfort zone range. The Simulation focuses on the following three questions:…

    • 1763 Words
    • 8 Pages
    Powerful Essays
  • Powerful Essays

    Energy

    • 1610 Words
    • 7 Pages

    The optimization of heating, ventilation and air conditioning system in term of energy efficiency is part of this assignment as how wisely to manage and use the energy recourses in our daily life and how the technology can help us in minimize the energy use in building sector particularly in HVAC field,…

    • 1610 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Essay About Terrapuri

    • 1056 Words
    • 5 Pages

    Although it is old, I had the benefits of the villa’s refurbished splendeour and unique traditional batik (with Nibong patterns) décor. For a hot and humid weather, air-conditioning was a heaven-sent. My husband said he prefer the old ‘kampung’way and said that adequate ventilation of the house system will allow cooling and reduction of humidity. I agreed but with the temperature of more than 40°C, I doubt that cooling will take place. I respect his wish and switched off the air-con and opened up windows and doors. After few minutes, my husband started to sweat a lot. He finally gave-in to the idea of switching on the air-conditioning. He switched on the ceiling fan in…

    • 1056 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Sweating Case Study

    • 986 Words
    • 4 Pages

    The sweating guarded hotplate is also named “Skin Model”. It consists of a porous aluminium plate that is able to maintain at 37C to replicate the human skin temperature. Besides, the passing of the water vapour at a controlled humidity through the porous plate mimic sweating. It simulates the behaviour of the human skin in this way. The equipment mimics the sweating mechanisms at the surface of human skin. Hence, the performance of breathable fabric or membrane systems can be studies under theoretically more realistic conditions than conventional water vapour permeability tests. The temperatures of the measuring unit and thermal guard ring are controlled 35°C to mimic the temperature of the skin, and the test specimen is laid over the measuring unit and thermal guard ring to overlap the thermal…

    • 986 Words
    • 4 Pages
    Good Essays
  • Good Essays

    A chiller is a machine that removes heat from a liquid via a vapor-compression or absorption refrigeration cycle. This liquid can then be circulated through a heat exchanger to cool air or equipment as required. As a necessary byproduct, refrigeration creates waste heat that must be exhausted to ambient or, for greater efficiency, recovered for heating purposes. Concerns in design and selection of chillers include performance, efficiency, maintenance, and product life cycle environmental impact.…

    • 576 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    7. What are the major methods for cooling produce? What are their advantages and disadvantages?…

    • 884 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    Klnkj

    • 3925 Words
    • 16 Pages

    One of the most prolific and important improvements in our quality of life during the last century has been the development of air conditioning. This technology evolved over the twentieth century from the early applications in the textile and printing industries - applications that are still in use in some form today. As well as being the precursor to modern domestic thermal comfort systems, industrial and commercial air conditioning has continued to evolve in its own right.…

    • 3925 Words
    • 16 Pages
    Powerful Essays
  • Good Essays

    Humidification

    • 4961 Words
    • 20 Pages

    References: SANTIAGO, D.E.O. (2012). Cooling Towers [Lecture Notes]. Department of Chemical Engineering, CEAT, UPLB, College, Laguna.…

    • 4961 Words
    • 20 Pages
    Good Essays