Preview

Elvis Experiments Lab Report

Powerful Essays
Open Document
Open Document
1126 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Elvis Experiments Lab Report
The Elvis Experiment
Introduction: In this experiment we will determine how the difference in length and diameter of a blood vessel have an effect on the resistance of blood flow and how the viscosity of blood will also effect the resistance of blood flow in a blood vessel.
Observation: My mom is a big Elvis fan and she always wondered how his health affected his death. Knowing that he had high cholesterol and high blood pressure I decided to do an experiment on what factors may have had an effect on his high cholesterol and high blood pressure.
Hypothesis: I know that the longer the length of the tube, the smaller the diameter of the tube, and the thicker the viscosity of a substance the greater the resistance, therefore it will take longer for the substance to pass through it. Controlled Factors:
Independent: length, diameter, viscosity
Dependent: Amount of time for the fluid to pass
Experimental Design: Procedure A: Length
Using a short 40 cm tube attach it to a ring stand with a clamp.
Arrange and position the tube making sure that it is horizontal.
Put an empty beaker at the end of the tube to catch the substance that flows through the tube.
Fill a 100 ml graduated cylinder with water, adding a drop of food coloring to it. (Food coloring will make it easier to see the fluid as it flows through the tube)
Using a funnel, pour the 100 ml of water
…show more content…
|7.85 secs |1.44 secs |

Average: 8.24 secs (3 mm) 1.29 secs (7 mm) Viscosity
|35 ml water |35 ml syrup |
|1.56 secs |49.00 secs |
|2.06 secs |36.09 secs |
|2.44 secs |37.03 secs |

Average: 2.02 secs (35 ml water) 40.71 secs (35 ml

You May Also Find These Documents Helpful

  • Good Essays

    Experiment 13B

    • 972 Words
    • 4 Pages

    A reflux condenser was assembled using a 25-mL round-bottom flask, hot plate, and aluminum block. It was equipped with a drying tube filled with calcium chloride to control vapors. Approximately 2.5 mL of isopentyl alcohol was massed and placed in the round-bottom flask that contained a stir bar. Using the same graduated cylinder, about 3.5 mL of glacial acetic acid was added to the flask. A calibrated Pasteur pipet was used to add 0.5 mL of concentrated sulfuric acid to the flask and the flask was mixed immediately. The flask was connected to the apparatus and covered with aluminum foil to help retain heat. Using rubber tubing, water was circulated into the lower attachment and out the top attachment and the mixture was brought to a boil. After heating under reflux for 60-75 minutes, the flask was removed from the heating source and left to cool down to room temperature. The reaction mixture from the flask was transferred to a culture tube and 5-mL of water was added. Upon addition of water, careful shaking, and occasional venting, the phases separated and the lower aqueous layer was removed and discarded. Using the same procedure as explained above with water, 2.5 mL of aqueous sodium bicarbonate was added and the lower aqueous layer was again removed and discarded. The same procedure was repeated one last time with 2.5 mL of saturated aqueous sodium chloride and the lower aqueous layer was removed and discarded, leaving behind the crude ester. The crude ester was transferred to…

    • 972 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Set out the two clear plastic cups that came with the "Cool Blue Light Experiment Kit" (item # 3053439) from Edmund Scientific at scientificsonline.com…

    • 452 Words
    • 2 Pages
    Good Essays
  • Better Essays

    Gas Stoich Honors

    • 910 Words
    • 4 Pages

    8. Holding your finger over the hole in the rubber stopper, invert the tube into the 400-mL beaker of water. Clamp the gas collection tube in place on the ring stand so that the stoppered end of the tube is under the water but not touching the bottom of the beaker.…

    • 910 Words
    • 4 Pages
    Better Essays
  • Good Essays

    Collect some of the solid into a glass capillary tube and tap away any excess solid. The reason for this is to make sure that the solid is placed firmly inside and that it won’t just fall out when it is placed inside the Thiele tube. Make sure the solid is secure at the bottom of the capillary tube so it doesn’t just fall out once you tip it upside down inside the Thiele tube.…

    • 1079 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Alum Ap Chemistry Lab

    • 480 Words
    • 2 Pages

    4. Immerse the bottom of the capillary tube and thermometer in a beaker of water.…

    • 480 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab 6 Diffusion

    • 325 Words
    • 2 Pages

    5. The thicker or thinner the medium is affects the rate of diffusion because the thinner the medium the quicker the dye diffuses. The thicker it is the longer it takes for the dye to diffuse. This affects nutrient transport because it can be delayed or expedited based on how thick the fluid is.…

    • 325 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Excercise 5 Activity 1

    • 553 Words
    • 2 Pages

    Exercise 5: Cardiovascular Dynamics: Activity 1: Studying the Effect of Blood Vessel Radius on Blood Flow Rate Lab Report…

    • 553 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    physio 9 lab and exam

    • 600 Words
    • 3 Pages

    Exercise 5: Cardiovascular Dynamics: Activity 1: Studying the Effect of Blood Vessel Radius on Blood Flow Rate Lab Report…

    • 600 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Add 300 mL of water to a 400- to 500- ml. add a few drops of solution till it turns an amber-yellow color.…

    • 657 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Before we conduct the experiment, we must first understand what viscosity is. “Viscosity is the quantity that describes a fluid's resistance to flow”.1 It is essentially fluid friction and transforms kinetic energy of motion into heat energy, just as friction (“the force between surfaces in contact that resists their relative tangential motion”) does between two solid bodies. All fluids express some amount of viscosity. An ideal fluid has no internal friction between the molecules, meaning that it is not viscous. The reciprocal of viscosity is fluidity (“the physical property of a substance that enables it to flow.”)2 Thus, fluids that are high in viscosity tend to flow slower while fluids that are low in viscosity tend to flow faster. Different liquids have different forces: the larger the intermolecular force, the more viscous it is and vice versa.…

    • 1599 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Liquids and Solids

    • 384 Words
    • 2 Pages

    rubber banded it with the thermometer. I logged the last bubble that came out of the capillary tubes.…

    • 384 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Aim: To discover whether honey will flow at a quicker pace when temperature is increased.…

    • 428 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Elvis Research Paper

    • 184 Words
    • 1 Page

    Elvis faced major health issues when when he was alive such as 1.Overly scary drug useage, 2.He was was obese at the time of his death, 3.He had raised risks of getting a heart disease the army, 6.He divorced his wife, priscilla, 7.After his divorce he fell into a deep divorce, 8.He…

    • 184 Words
    • 1 Page
    Satisfactory Essays
  • Better Essays

    Lab 1 Pendulum

    • 1893 Words
    • 8 Pages

    Fill one wide-neck pipet bulb completely with water, invert and quickly place it on top of the test tube 's gas delivery tube as shown in the picture at right.…

    • 1893 Words
    • 8 Pages
    Better Essays
  • Powerful Essays

    Length affects resistant, this is the variable which we are changing. As water in a hose pipe, the longer the pipe the longer the water takes to reach its destination. This can be applied in the variables of resistance. The electrons 'bounce ' off the atoms - this causes the electrons to head elsewhere rather than the desired direction. In a long tube there are more atoms, this slows the electrons down as they 'bounce ' off into another direction. In a short tube, there are less atoms which means there are less to deflect the electron any more speeding the speed up. In theory, the length should be proportional to the resistance. This is the variable which we will be changing in the experiment.…

    • 1394 Words
    • 6 Pages
    Powerful Essays