Preview

Determination Of The Following Equation For The First Order Reaction

Good Essays
Open Document
Open Document
443 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Determination Of The Following Equation For The First Order Reaction
The graph for run 1, which plotted ln(Abs at 595nm) versus time, a first order reaction, with an R^2 value of 0.99621 was the most linear. Therefore, crystal violet is a first order reaction. The observed rate constant from run 2, as shown in figure 4, was significantly lower then the observed rate constant from run 1, shown in figure 1. Therefore, the R^2 for the first order reaction for run 2, 0.946418, represented in figure 4, which is also extremely low, was not taken into consideration for calculations and observations due to the lack of linearity.

On the other hand, the order in respect to 〖[OH〗^-] would have been found by using the observed rate constants, which are the negated slope values for the plots ln(abs at 595nm) versus time. As stated, since the data recorded from run 2 is not reliable, the observed rate constant was not used for calculations. Therefore, the accepted value of ‘one’ was assumed, making the order with respect to OH^- one. With the order of both crystal violet and hydroxide found to be first order, with an overall reaction order of two, the rate law for the reaction of crystal violet with hydroxide is found to be equation 9, Rate=k[C〖V]〗^1
…show more content…
The true rate constant for the overall reaction, k, does not depend on hydroxide’s concentration and will remain constant regardless of the concentration. On the contrary, the rate constant is dependent on temperature; therefore, the temperature must be kept the same throughout the experiment. The observed rate constant and true rate constant had units of s^(-1) and M^(-1) s^(-1), respectively. The units for both the observed rate constant and true rate constant were found with the use of equation 8 and 9. (With the knowledge obtained that crystal violet is a first order reaction and the accepted value of “one” for y, making hydroxide a first order reaction, as

You May Also Find These Documents Helpful

  • Powerful Essays

    The objective of this laboratory experiment is to observe and record the effect of reactant concentration, reactant surface area and reactant temperature on the overall rate of reaction.…

    • 2334 Words
    • 8 Pages
    Powerful Essays
  • Good Essays

    CHEM 1252 Lab Report 5

    • 1825 Words
    • 21 Pages

    The purpose of this experiment was to determine the differential rate law for a chemical reaction based on the relationship between the concentration of reactants and the rate of reaction. Since spectrophotometers, like Spec-20s, provide information about concentration, these instruments were used to monitor the increase or decrease in concentration of a reactant in a solution over time. By plotting [phph2-] versus time and changing the concentration of OH- used, the order of the reaction with respect to each reactant and the overall order of the reaction can be determined.…

    • 1825 Words
    • 21 Pages
    Good Essays
  • Satisfactory Essays

    In this experiment two solutions were prepared for two kinetic runs. Solution #1 (50%ethanol 50% water) and Solution #2 (40% ethanol and 60% water) was added to another Erlenmeyer flask. Next, 0.10M of NaOH was filled up to the 0.00ml mark in two 50-ml burettes. Placing the flask containing solution 1 on the magnetic stirrer and clamp a burette containing 0.10M of NaOH above the flask. The two kinetic runs will be carried out one after another. A stir bar was placed into the flask containing solution #1 and 3-5 drops of phenolphthalein indicator solution to the reaction flask. To start the reaction, 4.91x10^-3 mol of alkyl halide to the stirring reaction mixture. The timer was started at the instant of this reaction. When enough HCl formed to neutralize the NaOH that was initially added, the pink color turned clear. The time was recorded.…

    • 936 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    An investigation to show how the rate of reaction between hydrochloric acid and sodium thiosulphate is affected by the concentration of the acid…

    • 1036 Words
    • 5 Pages
    Good Essays
  • Powerful Essays

    Crystal Violet Formal Lab

    • 2472 Words
    • 10 Pages

    Abstract: This experiment helps determine the rate of reaction of crystal violet while it reacts with sodium hydroxide with respect to crystal violet. The amount of sodium hydroxide is varied in this experiment while crystal violet is kept at a constant. The transmittance of crystal violet is observed and recorded using a colorimeter and the data obtained is used to plot graphs which are manipulated using LoggerPro software to produce the desired outcome; rate of reaction of crystal violet. Upon completion of the experiment it was seen that the rate of reaction of crystal violet turned out to be 1 which meant the reaction was first order with respect to crystal violet. This was deduced upon plotting the graph of ln Absorbance versus time of crystal violet and by drawing the line of best fit, which showed that the slope graph was 1 which is the rate of reaction. This whole experiment was based upon the equation: Rate= k [CV+] [OH-], where k stands for the rate constant.…

    • 2472 Words
    • 10 Pages
    Powerful Essays
  • Good Essays

    Chemical Kinetics, described as the study of rate of chemical processes, varies on many factors to determine the time needed for a reaction to complete. The rate of reaction of a chemical reaction is important, as reactions are of little use if the time period needed for the reaction to occur is too lengthy. Many factors influence the rate of a chemical reaction, such as temperature, concentration and surface area. The order of the reaction is based on the concentration of the reactants, and is what this lab focuses on.…

    • 1906 Words
    • 6 Pages
    Good Essays
  • Good Essays

    In the solutions A, B and C, the concentration of hydrogen peroxide used was the same. Therefore, these solutions are a suitable series for an examination of the dependence of the rate of reaction on the concentration of the iodide ion. Similarly, solutions C, D, and E have the same concentration of iodide ion. Therefore, those solutions can be used to examine the dependence of the rate of reaction on the concentration of hydrogen…

    • 1013 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Chem Lab Report

    • 393 Words
    • 2 Pages

    This kinetics lab studies the reaction rate of a particular dye and NaOCl, also known as bleach. The rate equation for this particular reaction is Rate=k[Dye]y. The concentration of the dye was known, the rate of the reaction was experimentally…

    • 393 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Kinetic Reaction Lab

    • 719 Words
    • 3 Pages

    One application of the study of kinetics can be applied to the determination of the rate of a chemical reaction involving a certain selection of chemicals (FD&C Blue #1 and sodium hypochlorite). The purpose of the proceeding experiment is to make such a determination, as well as determining the rate law for the reaction by establishing the rate constant and concentrations and reactions orders of the chemicals.…

    • 719 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The purpose of laboratory assignment 3 was to measure the rate at which a chemical reaction takes place. For the purpose of this lab we measured the rate a balanced oxidation/reduction reaction between iodine, hydrogen, and bromate ion occurs. The above reaction occurs slowly so we used a coupled iodine clock reaction to measure the rate of the oxidation/reduction reaction because it occurs much faster but is still dependent upon the other reaction. To accomplish this, two mixtures were prepared in separate Erlenmeyer flasks. In the 250 ml flask .010M potassium iodide, .0010M Sodium thiosulfate and distilled water was prepared. A 125 ml flask was also prepared with a mixture of .040M potassium bromate, hydro chloric acid and…

    • 253 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Chm 116 Lab

    • 830 Words
    • 4 Pages

    Chemical kinetics, which can also be explained as reaction kinetics, studies the rates of chemical processes and reactions. A lot of this has to do with the speed at which a chemical reaction occurs for instance the rate at which reactants and products appear and disappear. In this case chemical kinetics goes further in depth to understand what conditions affect the rate of a given reaction. This is important because it allows scientists to determine what type of reaction can occur, and how they can alter the outcome under varying conditions. Gasoline and diesel for example have two very different reaction rates when exposed to a spike in temperature. If you were to light gas on fire it would instantaneously explode igniting fumes in the air as well, however diesel has a much higher ignition temperature allowing it to slowly burn if lit. These two types of fuel are an example of the differences in reaction rate. To determine the rate at which these reactions occur we use the rate law: r=kAxBy. In this equation we are looking to solve for the rate of the reaction “r”, the k value which represents our rate constant is simply the value which quantifies the speed. As for the [A] and [B] values they are the concentration of the species A and B which respectively are raised to the “x” and “y” power. The “x” and “y” values are the respective stoichiometric coefficients that must be determined experimentally. The primary goal essentially for this experiment is to determine the k value or rate constant along with the x and y stoichiometric coefficients given the concentrations of Crystal Violet and Hydroxide. This can be obtained using a spectrophotometer to determine rate of absorbance then graph the rate find a line of best fit, determine our rate constant, then finally solve for our x and y in the rate law equation. Beer’s law also known as Beer-Lambert law relates the absorption of light to the properties of the material through which the…

    • 830 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Catalase Temperature Lab

    • 740 Words
    • 3 Pages

    When the water was at 10℃ the average rate of reaction was 1.75 mm/s. When the water was at 25℃ the average rate of reaction was 2.98 mm/s. When the water as at 37℃ the average rate of reaction was 3.45 mm/s. Finally, when the water was at 45℃ the average rate of reaction was 4.07 mm/s. Therefore, our data did support our hypothesis because we hypothesized that when the water rose in temperature the reaction rate would speed up, and so it…

    • 740 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Reactants Lab

    • 1408 Words
    • 6 Pages

    This experiment was done to determine the effects of the nature of the reactants, concentration, temperature, surface area and catalyst on the rate of chemical reactions. The nature of the reactants implies a difference if the reactants are aqueous or organic, acidic or basic or if they occur in the same phase or not. Acid-base reactions, formation of salts, and exchange of ions are fast reactions while reactions in which large molecules are formed or broken apart are usually slow. Generally, the rate of reaction is directly proportional to the concentration of the reactants, as well as to the temperature. Greater surface areas and addition of catalysts also increase the rate of chemical reactions.…

    • 1408 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    College essay

    • 3254 Words
    • 14 Pages

    An aqueous solution containing 0.050 M of ion and 0.072 M of is prepared, and the progress of the reaction followed by measuring []. The data obtained is given in the table below.…

    • 3254 Words
    • 14 Pages
    Good Essays
  • Good Essays

    lab report for monomeils

    • 453 Words
    • 2 Pages

    Goal(s): To study the effect of concentration on the rate of a reaction, and to find the order of the reaction in each reactant and write a rate equation.…

    • 453 Words
    • 2 Pages
    Good Essays