design project
DESIGN PROJECT REPORT 1. Design of drill jig for a flange 2. Automatic tapping
Submitted to the
FACULTY OF ENGINEERING(M.I.T)
In partial fulfillment of the requirements for the award of the degree of BACHELOR OF ENGINEERING
IN
PRODUCTION TECHNOLOGY
BY
T. SENTHIL NATHAN (20082645) M. VINOTH KUMAR (20082660) C.ELAKKIYA (20082615)
DEPARTMENT OF PRODUCTION TECHNOLOGY,
MADRAS INSTITUTE OF TECHNOLOGY CAMPUS,
ANNA UNIVERSUTY, CHENNAI-600044
November 2011
BONAFIDE CERTIFICATE
Certify that this project report is the bonafide work of,
T.SENTHIL NATHAN (20082645)
M.VINOTH KUMAR (20082660)
C.ELAKKIYA (20082615)
This project has been completed and submitted to M.I.T, Anna University, Chennai in partial fulfillment of the requirements for the award of the degree of BACHELOR OF ENGINEERING in Production Engineering. Certified further that to the best of our knowledge, the work reported herein does not form part of any thesis or dissertation on the basis of which a degree o award was conferred on an earlier occasion on these or any other candidates.
SIGNATURE
SIGNATURE
PROF.A. JOTHILINGAM
Mr. C. NANDAKUMAR
HEAD OF THE DEPARTMENT
STAFF INCHARGE
Professor and Head of the Department
ASSISTANT PROFESSOR
Department of Production Technology
Department of Production Technology
Madras Institute of Technology
Anna University Chennai-44
Madras Institute of Technology
Anna University
Chennai-44
ACKNOWLEDGEMENT
It gives us immense pleasure to express our deep sense of gratitude to our beloved guide Asst. lecturer Mr.C.NANDAKUMAR,
Submitted to the
FACULTY OF ENGINEERING(M.I.T)
In partial fulfillment of the requirements for the award of the degree of BACHELOR OF ENGINEERING
IN
PRODUCTION TECHNOLOGY
BY
T. SENTHIL NATHAN (20082645) M. VINOTH KUMAR (20082660) C.ELAKKIYA (20082615)
DEPARTMENT OF PRODUCTION TECHNOLOGY,
MADRAS INSTITUTE OF TECHNOLOGY CAMPUS,
ANNA UNIVERSUTY, CHENNAI-600044
November 2011
BONAFIDE CERTIFICATE
Certify that this project report is the bonafide work of,
T.SENTHIL NATHAN (20082645)
M.VINOTH KUMAR (20082660)
C.ELAKKIYA (20082615)
This project has been completed and submitted to M.I.T, Anna University, Chennai in partial fulfillment of the requirements for the award of the degree of BACHELOR OF ENGINEERING in Production Engineering. Certified further that to the best of our knowledge, the work reported herein does not form part of any thesis or dissertation on the basis of which a degree o award was conferred on an earlier occasion on these or any other candidates.
SIGNATURE
SIGNATURE
PROF.A. JOTHILINGAM
Mr. C. NANDAKUMAR
HEAD OF THE DEPARTMENT
STAFF INCHARGE
Professor and Head of the Department
ASSISTANT PROFESSOR
Department of Production Technology
Department of Production Technology
Madras Institute of Technology
Anna University Chennai-44
Madras Institute of Technology
Anna University
Chennai-44
ACKNOWLEDGEMENT
It gives us immense pleasure to express our deep sense of gratitude to our beloved guide Asst. lecturer Mr.C.NANDAKUMAR,