Preview

Communication Engineering

Powerful Essays
Open Document
Open Document
1404 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Communication Engineering
Reliability Evaluation of Communication Network Considering Capacity and Delay of Transmission
Sheikh Mominul Islam
Abstract
This paper introduces a reliability index Capacity and Delay Related Reliability (CDRR) for communication networks. An algorithm is proposed for evaluating the CDRR. This algorithm needs the binary system states generated by the minimal paths, message flow capacity and time delay of these states. A criterion for computing the delay time of the binary system states is also proposed. In the paper, attempt has been made to justify that the index, CDRR will be an appropriate reliability index for evaluating the performance of communication networks.
Keywords—Connectivity Performance-index CDRR Communication-network Flow-capacity Time-delay

I. INTRODUCTION
Communication network is an example of flow networks where the flow is the message transported through the network consisting of nodes acting as switching stations and edges as communication links. Disruption of the communication network depends upon the link failure as well as the non-fulfillment of constraints of performance by the system. There are several performance indexes of flow networks already defined [1-5]. Most of these consider the effect of link capacity only in evaluating the performance index. This index has been described in literature as Capacity Related Reliability (CRR). In performance evaluation of communication networks transportation of links has also been considered [6-9].
But the operating environment of communication networks is such that the performance of the network is affected by the constraints of both capacity and transportation time. There is a need of integrating both these in reliability index. Here one such reliability is being proposed viz. Capacity and Delay Related Reliability (CDRR). For evaluating this index an algorithm has been proposed. Capacity and Delay Related Reliability is evaluated for bridge network.
II. NOTATIONS & ACRONYMS



References: [1] S. H. Lee, "Reliability evaluation of a flow network," IEEE Trans. Rel., vol. 29, pp. 24–26, Apr. 1980. [2] K [6] L. R. Ford and D.R.Fulkerson, Flows in Networks, 1962 Princeton University Press 1962 [7] K [8] R. Schanzer, "Comment on: reliability modeling and performance of variable link-capacity networks," IEEE Trans. Rel., vol. 44, pp. 620–621, Dec. 1995. [9] K

You May Also Find These Documents Helpful

  • Better Essays

    The review of the current network used at Kudler Fine Foods was able to determine that the network topology that is being used is the bus topology. The bus network is set-up in such a way that all the network components are connected via CAT5 to the bus or communication line. This configuration is true at sites in the corporation for their workstations, servers, and standalone UPS. A 56k modem is the device that is used by all of the networks communicating to the internet. Although the bus network is very reasonable when it comes to cost, the downfall is that when the backbone goes down, the entire network can encounter an outage that is very difficult to troubleshoot. Another disadvantage this network is the occurrence of signal collision. This happens when two systems are sending signals at the same time to one another, collides with each other and causes to drop both signals. To solve this problem, CSMA/CD (Carrier Sense Multiple Access with Collision Detection) technology will be set-up in the network, which will put the network into a listen mode before sending, to prevent collisions from taking place.…

    • 1908 Words
    • 6 Pages
    Better Essays
  • Good Essays

    Net410 week 2 tamplet

    • 959 Words
    • 4 Pages

    The following description of a network will be used for a series of network design problems that have been incorporated into the NETW410 weekly labs.…

    • 959 Words
    • 4 Pages
    Good Essays
  • Good Essays

    It230 Wk1 Checkpoint

    • 576 Words
    • 3 Pages

    References: Hallberg, B.A. (2010). Networking: A beginner’s guide (5th ed.). New York, NY: McGraw-Hill. https://portal.phoenix.edu/classroom/coursematerials/it_230/20130715/OSIRIS:45023271…

    • 576 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Nicholls, D. (2005). System Reliability Toolkit: A Practical Guide for Understanding and Implementing a Reliability Program. RIAC.…

    • 1550 Words
    • 7 Pages
    Better Essays
  • Best Essays

    554 Infrastructure

    • 3120 Words
    • 13 Pages

    Iniewski, K., McCrosky, C., & Minoli, D. (2008). Network infrastructure and architecture: Designing high-availability networks. Hoboken, NJ: Wiley-Interscience.…

    • 3120 Words
    • 13 Pages
    Best Essays
  • Good Essays

    (Network Protection, 2010). These metrics cover a broad range of key factors to the survivability, reliability and availability of the network. Factors such as the percentage of time a network and its services are up are important factors to not only the reliability of the network, but also the availability. Availability is affected by two aspects, these aspects being Mean time between failures (MTBF) and Mean time to repair (MTTR). As shown by the graphic below, availability is affected by MTBF distinctively.…

    • 811 Words
    • 4 Pages
    Good Essays
  • Good Essays

    The criterion of reliability is the consistency or stability, but it may also imply dependability. The different types of reliability are: Alternate-form reliability, Item-to-item reliability, and Test-retest reliability.…

    • 867 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    As The Organization

    • 338 Words
    • 2 Pages

    Ensuring the right equipment is being used, and there is redundancy built into the network infrastructure will help increase the availability, and uptime of services.…

    • 338 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Network Case Flows

    • 689 Words
    • 3 Pages

    Example 1 introduces the scenario of Joe the plumber, and his piping network. Joe states that his system of connections can deliver a flow of 3 gpm from point s to point t through his series of connections. By studying his system on a capacitated s,t graph the flow tolerances can be mapped from point to point. Point s supplies 4 gpm to point a, point a then splits into two edges to points b and d which can flow 3 and 2 gpm respectively. Throughout the network there are differing capacities among the connections however, combined the edges always equal a flow of ≥3. This implies that the network will be able to deliver the necessary flow demands to t.…

    • 689 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    The Nightingale Project

    • 641 Words
    • 3 Pages

    3. How sensitive is this network? I believe that this network is not too sensitive, there is definitely room to shorten the total program length. The critical path is not too reliant on numerous other activities being completed so it is quite a practical network also.…

    • 641 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    3. How sensitive is this network? I believe that this network is not too sensitive, there is definitely room to shorten the total program length. The critical path is not too reliant on numerous other activities being completed so it is quite a practical network also.…

    • 264 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    1) In this paper,it explain the boundaries or the extends and difficulties the cross layer networks are having,like how the information sharing is done between the different layers and the problems which we sometime face when the connection between the layers is established, when there is temporary loss of connection. Moreover the paper describes how the performance and reliability can be achieved in the network by reducing the error rate,the reduced latency.…

    • 1413 Words
    • 6 Pages
    Good Essays
  • Better Essays

    Technical Paper

    • 2498 Words
    • 10 Pages

    Duato, J., & Pinkston, T. M. (2006, July 14). Interconnection Networks. Retrieved December 15, 2013, from MIT.edu: http://web.mit.edu/6.173/www/currentsemester/readings/R07-interconnection-networks-hennessy-patterson.pdf…

    • 2498 Words
    • 10 Pages
    Better Essays
  • Good Essays

    Bernoulli's Theorem

    • 737 Words
    • 3 Pages

    tank. The estimation of losses in these networks can be done with the help of this…

    • 737 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Abstract: Fairness is not a human right only, but also significant for the communication traffic, specifically related to the need for the high reliability and fair of the resource allocation that applies to traffic that is both massive and handled automatically by resources, called as massive Resource Type Communications. Furthermore, the Resource Type Communications generates traffic that has two gradation properties, which the first is the gradation of the traffic’s Quality Of Service requirements as a function of the traffic’s type and the second is the gradation or a variation of the traffic as a function of the time, consequently, there are the need…

    • 1505 Words
    • 7 Pages
    Better Essays

Related Topics