Preview

CHEM 103 Exp 10 Standardization NaOH

Better Essays
Open Document
Open Document
749 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
CHEM 103 Exp 10 Standardization NaOH
EXPERIMENT 10
Volumetric Analysis I
Standardization of NaOH Solution
Outcomes
After completing this experiment, the student should be able to:
1.
2.
3.
4.

Demonstrate the concept of quantitative analysis.
Make solution and standardize it.
Explain the difference between primary and secondary standard solutions.
Quantitatively determine the concentration of a base.

Introduction
Titration is a common method of quantitative analysis used to determine the concentration of an unknown substance in a solution. The method is easy to use if the quantitative relationship between two reacting solutions is known. It is particularly well-suited to acid-base and oxidation-reduction reactions. In this course, we will analyze commercial products such as household vinegar and bleach.
In the case of acid-base titrations, these permit the determination of concentrations of unknown acids or bases with a high degree of accuracy. In order to analyze unknown acids or bases, we must have a “standard solution” to react with the unknowns. A standard solution is one in which the concentration is accurately known. We will first prepare a standard solution of
NaOH. One way to prepare a standard solution is to dissolve an accurately massed amount of the substance and dilute it to a measured volume. In this way, the concentration can be calculated exactly. However, it is usually impossible to obtain NaOH of sufficient purity to use it as a primary standard. Moreover, NaOH is highly hygroscopic, therefore absorbs water during the weighing process. An indirect method is more practical for obtaining a standard solution of NaOH. We will prepare a solution of NaOH of approximate molarity and standardize it against a primary standard of known purity. A primary standard is a substance that should:
* be of high purity
* remain unchanged in air during massing and remain stable during storage
* have a high molar mass to reduce massing errors
* react with the solution to be standardized in a direct,

You May Also Find These Documents Helpful

  • Good Essays

    Investigations of Buffers

    • 991 Words
    • 4 Pages

    Using pipettes we measured out the needed volume and transferred it to an Erlenmeyer flask, which we eventually used to combine the solution.…

    • 991 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    of a substance we need to know the mass (weight) of the substance and the volume (how much…

    • 323 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Titration Lab

    • 499 Words
    • 2 Pages

    3. Suppose a sodium hydroxide solution were to be standardized against pure solid primary standard grade KHP. If 0.4538 g of KHP requires 44.12 mL of the sodium hydroxide to reach a phenolphthalein endpoint, what is the molarity of the NaOH solution?…

    • 499 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Spinach Leaves

    • 626 Words
    • 3 Pages

    The sample should be dissolved in a suitable solvent to make around a 1% solution. The solute should be present at a concentration in the 0.2-2.0% range.…

    • 626 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Chem 1211K Lab Report

    • 1855 Words
    • 18 Pages

    A sodium hydroxide solution was prepared. Then 4.2 mL of concentrated 19.1 M NaOH was obtained and mixed with 800 mL dH2O in a 1L bottle.…

    • 1855 Words
    • 18 Pages
    Satisfactory Essays
  • Good Essays

    4. to test a variety of household products and classify them as acids or bases…

    • 851 Words
    • 11 Pages
    Good Essays
  • Good Essays

    Scheme of Analysis #5

    • 608 Words
    • 3 Pages

    -In a small test tube/vial, or spot plate and place 10-15 drops of solution to test…

    • 608 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Prepare the solution to be analyzed by placing it in a clean Erlenmeyer flask or beaker…

    • 692 Words
    • 3 Pages
    Good Essays
  • Better Essays

    protocal

    • 987 Words
    • 4 Pages

    There are many ways to measure the amount of a substance – if we have a relatively large amount, such as a spoonful of sugar, we can find its mass with a balance or find its volume by putting it in a measuring spoon. However, when we are trying to measure smaller quantities, or quantities that may be dissolved in a solution, we need to find another method for determining how much we have. For instance, it would be difficult to measure the amount of red food coloring we have in a bottle of Gatorade by weighing the bottle of Gatorade because it is mixed…

    • 987 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    Density can also be used as a tool for finding the concentration of solutions in some cases. The density is different in a substance when a substance is added to a pure liquid to when both the solute and solvent were separate all together.…

    • 463 Words
    • 4 Pages
    Satisfactory Essays
  • Powerful Essays

    The purpose of the experiment was to utilize the techniques of titrations to measure the concentration of an acid or base in solution, to calculate molar mass of an unknown acid or base, and to determine the equilibrium constant of a weak acid or weak base.…

    • 2054 Words
    • 9 Pages
    Powerful Essays
  • Powerful Essays

    Ionic Reaction Lab Report

    • 877 Words
    • 4 Pages

    - The concentration of substance is described as molarity and this can be expressed as –…

    • 877 Words
    • 4 Pages
    Powerful Essays
  • Better Essays

    6.03 Calorimetry Lab

    • 1068 Words
    • 5 Pages

    In the experiment, standardization of NaOH with HC1 solution is carried out. Solid NaOH is hygroscopic where significant amounts of water vapor can be absorbed. Also, as NaOH is a strong base, significant amounts of atmospheric carbon dioxide can be absorbed too. It is also clear that NaOH cannot serve as a primary standard and thus it needs standardization by a primary or secondary standard. NaOH solutions can be directly titrated versus standardized HCl using phenolphthalein or methyl red indicator. In this case, methyl red is used as an indicator. The colours change from red to completely purple pink indicate the standardization is achieved. If reasonable concentrations of the acid and base are used, very sharp end points can be achieved. The…

    • 1068 Words
    • 5 Pages
    Better Essays
  • Better Essays

    The purpose of this lab is to use volumetric analysis to determine the concentration of unknown substances. A sodium hydroxide solution is standardized to assist in finding the concentration of an acetic acid. An indicator must be used to pin point the equivalence point, the point in which 1 mole of a substance is equal to 1 mole of another. When that is found, we can determine the concentration.…

    • 1177 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Solutions in Chemistry

    • 521 Words
    • 3 Pages

    solution then has a certain concentration. There are a number of ways to measure the concentration of a solution. There is molarity, parts per million, grams per liter and…

    • 521 Words
    • 3 Pages
    Good Essays

Related Topics