Preview

Analysis of Soda Ash and Volumetric Analysis of a Carbonate-Bicarbonate Mixture

Powerful Essays
Open Document
Open Document
1789 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Analysis of Soda Ash and Volumetric Analysis of a Carbonate-Bicarbonate Mixture
Analysis of Soda Ash and Volumetric Analysis of a
Carbonate-Bicarbonate Mixture
Manalo, Ma. Cristina Joyce B.
Department of Chemical Engineering, Faculty of Engineering
University of Santo Tomas
Espana, Manila

A. Abstract

Crude sodium bicarbonate or commonly known as soda ash may contain amounts of impurities like chlorides and hydroxides. The total acid neutralizing capacity of a soda ash sample, its alkalinity value, was stated in terms of mass of sodium carbonate. In doing so, any sodium hydrogen carbonate present in the sample was converted to its equivalent neutralizing capacity in terms of sodium carbonate. A mass of the impure sample was dissolved and diluted in distilled water. 3 drops of indicator was mixed and the solution was titrated with the standard acid (HCl) to the endpoint.
Volumetric analysis is a quantitative analytical technique which employs a titration in comparing an unknown with a standard. A titration reaction may use two indicators, as in the analysis of carbonate-bicarbonate mixture. The two methods involved in this experiment were the classical method and the potentiometric method. In classical method, the endpoints of the two indicators (phenolphthalein and methyl orange) were determined using titration method. In the potentiometric method, the progress of the titration was monitored using a pH meter. B. Introduction

Sodium carbonate is an important industrial chemical. It is used in the manufacture of soap, glass, paper and as a source of alkalinity, that is, as a base. Glass, paper and as a source of alkalinity, that is, as a base. Soda ash, which is primarily sodium carbonate, contains unreacted sodium hydrogen carbonate and other impurities. The total acid neutralizing capacity of a soda ash sample, its alkalinity value, can be stated in terms of percent sodium carbonate. In doing so, any sodium hydrogen carbonate present in the sample is converted to its equivalent neutralizing capacity in terms of sodium



Bibliography: 1. Analysis of Soda Ash URL: www.genchem.com/pdf/SodaAshTech.pdf 2. Determination of the Carbonate Content of a Soda-Ash Sample URL: http://www.csudh.edu/oliver/che230/labmanual/carbnate.htm 3. Acid-base Titration using Method of Double Indicators URL: http://cd1.edb.hkedcity.net/cd/science/chemistry/s67chem/pdf/sDL_4_Double_indicators.pdf. 4. Volumetric Determination of Carbonate and Bicarbonate URL: http://www.chemistry.nmsu.edu/image2/VOLUMETRIC%20DETERMINATION%20OF%20CARBONATE%20AND%20BICARBONATE.pdf. 5. ENCYCLOǢDIA Britannica, What is Volumetric Analysis? URL: http://global.britannica.com/EBchecked/topic/632594/volumetric-analysis

You May Also Find These Documents Helpful

  • Better Essays

    Titration is a method, which is meant to find the concentration of either an acid or a base by adding a measured amount of it to a known volume and concentration of an acid or base1. Titration starts with a beaker or Erlenmeyer flask containing a very precise volume of the known concentration solution and a small amount of indicator, which is put underneath a burette containing the solution with unknown concentration1. Small drops of the titrant are then added to the known solution and indicator until the indicator changes which means the endpoint has been reached. Single drops of the titrant can sometimes make a permanent or temporary change in the indicator2.…

    • 2337 Words
    • 10 Pages
    Better Essays
  • Good Essays

    Nahco3 Hydrochloric Acid

    • 1247 Words
    • 5 Pages

    Firstly we weighed the solid sample of sodium hydrogen carbonate with an accurate balance; then dissolved in distilled water up to 250ml to make a…

    • 1247 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Stoichiometry Lab Report

    • 783 Words
    • 4 Pages

    Purpose: The purpose of this lab is to find the limiting reactant, also to find the percentage yield and percentage purity of the reaction that happens between Calcium Chloride and Sodium Carbonate. The other purpose was to know how the reaction can be balanced and created.…

    • 783 Words
    • 4 Pages
    Satisfactory Essays
  • Better Essays

    The student will perform the experiment in order to find the percent yield by using the theoretical value found using the balanced equation for sodium carbonate as well as sodium bicarbonate. The objective is to stabilize the substances by titrations and finding the percent yield when all the data is collected. The purpose of this procedure is so that the student will get better understanding of stoichiometry. The student will also be reacting sodium bicarbonate and sodium carbonate with hydrochloric acid to produce sodium chloride, water and carbon dioxide.…

    • 1238 Words
    • 4 Pages
    Better Essays
  • Good Essays

    Blah

    • 1432 Words
    • 6 Pages

    Learning Objectives to understand the titration curves for the following solutions • a weak acid: acetic acid, CH3COOH. • • • • • a strong acid: hydrochloric acid, HCl. an acidic commercial cleanser. a basic commercial cleanser. to use the titration curves to calculate the percent of the active ingredients in the commercial cleansers. to determine the Ka of a weak acid. Procedure Overview • • • • after calibration of the pH electrode and determination of the flow rate for the automatic titration, a NaOH solution is standardized against HCl. a pH titration curve for acetic acid is obtained and its pKa is determined. an unknown sample of Lysol is analyzed for its HCl content using the standardized NaOH. an unknown sample of Liquid Plumr is analyzed for its NaOH and NaOCl content using HCl of known molarity.…

    • 1432 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Ionic Reaction Results

    • 428 Words
    • 2 Pages

    Results indicate that all but one of the sodium carbonate/bicarbonate mixtures produced a precipitate, the exception was when NaHCO3 was combined with Co(NO3)2 or cobalt nitrate. Furthermore, most copper and iron nitrates, even with differing sodium compounds produced a precipitate. Exceptions were Cu(NO3)2 with sodium sulfate and sodium chloride. It was also noticed that nickel, barium, and iron nitrates (excluding those with few with no reaction) across the board had the same color precipitates no matter the sodium compound that it was mixed with.…

    • 428 Words
    • 2 Pages
    Good Essays
  • Better Essays

    * Weigh the calculated amount of Na2CO3 and put it in a small paper cup. Add 25 mL of distilled water and stir to make a sodium carbonate solution.…

    • 1012 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    The purpose of the current experiment was to determine the pH of various hydrochloric acid and acetic acid solutions, to determine the pH of various salt solutions, to prepare a buffer solution, and determine the effects of adding a strong acid and strong base to the buffer solution versus adding a strong acid and strong base to water. The measured pHs for the hydrochloric acid solutions were 1.6, 2.2, 2.9, and 3.8. The measured pHs for the acetic acid solutions were 2.9, 3.9, 4.2, and 4.4. The pHs measured for the salts were 4.3 for sodium chloride, 7.3 for sodium acetate, 8.9 for sodium bicarbonate, 10.8 for sodium carbonate, 7.9 for ammonium chloride, and 6.9 for ammonium acetate. The pH for the buffer solution and the strong acid was 3.9 and the pH for the buffer solution and the strong base was 11.6. The pH of water with the strong acid added was 3.44 and the pH of water with the strong base added was 13.4…

    • 1669 Words
    • 6 Pages
    Powerful Essays
  • Better Essays

    Titrations in the industry

    • 1143 Words
    • 5 Pages

    Titrations are a common laboratory method – and factorial method – of chemical analysis that is widely used to determine unknown concentrations of a reactant. Many methods have been developed and adapted to indicate the end point of a reaction, to make it more and more reliable using primarily visual indictors. The titration technique is a simple process and can be experimented using such basic standardised tools within science in a child’s science lab to more developed braches of chemistry within a working industry. The versatility of the titration method means that industries can use these various techniques to develop, learn and understand more about key chemical compounds. Titrations are required in almost all factors of life; wineries, dairy farms, food courts, cleaning material factories, juice makers, cosmetic industry, paint makers etc. as all these made by products rely on a pH that is calculated via a titration. Titrations are used and are dependant by us for safety purposes as it makes sure that the pH of a product being released is suitable for human use/consumption. All’s well for humans, titrations also ensure cleaning products, containing harmful chemicals have the right acidity to work.…

    • 1143 Words
    • 5 Pages
    Better Essays
  • Good Essays

    In this experiment, you will react a known amount of sodium carbonate solution with a known amount of…

    • 1310 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Study Guide Oncology

    • 475 Words
    • 2 Pages

    -Sodium bicarbonate: is used to maintain an alkaline urine (pH>7) to prevent uric acid crystallization.…

    • 475 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Week 1: Chemical Analysis

    • 2582 Words
    • 11 Pages

    Limestone is known to contain calcium carbonate as an impurity. A sample of limestone was analysed using back titration. A 1.0g sample of limestone was weighed and made into a 50.0mL solution in a conical ask. An excess of 0.395M hydrochloric acid, exactly 50.0mL, was added and allowed to fully react with the CaCO3 . After this reaction, the remaining HCl was titrated with a standard 0.0489M solution of Sodium Hydroxide. The titre was found to be 22.32mL. (Source: Heinemann…

    • 2582 Words
    • 11 Pages
    Powerful Essays
  • Better Essays

    For the firsts three sets of titration trials of baking soda powder was used. About 0.3 grams of baking soda powder were measured and mixed with 20mL of deionized water in a beaker. Three drops of the indicator bromothymol blue were put in the baking soda solution and mixed well. A burette and funnel were rinsed off using water and cleaned well. The burette and funnel were rinsed a second time using 5mL of the HCl solution that was prepared the previous week and disposed of in a clean beaker. The rest of the HCl solution was then put in the burette. The beaker containing the baking soda solution was placed under the burette. 1mL of the HCl solution was released at a time into the beaker with the baking soda until a change was observed. The results were recorded. The process was repeated three more times and the results were recorded. For the second sets of titration trails, fresh squeezed lemon juice was used. 5mL of lemon juice were used and three drops of the indicator phenolphthalein were put in the juice. The burette was then rinsed off with water and rinsed off a second time using NaOH and disposed of in a clean beaker. The rest of the NaOH solution was put in the burette and the beaker containing the lemon juice was placed under the burette. 1mL of the NaOH solution were released at a time into the beaker containing the lemon juice until changes were observed. The results were…

    • 1661 Words
    • 7 Pages
    Better Essays
  • Good Essays

    How Much Co2 Lab

    • 1228 Words
    • 5 Pages

    The goal of this lab was to determine the amount of grams of sodium bicarbonate (NaHCO3) required to produce enough CO2 gas to completely fill the lab and also how many Alka-Seltzer tablets that would equate to. This was done by collecting CO2 gas by inverting a buret and submerging it under water in order to calculate the volume of CO2 released from a fragment of Alka-Seltzer tablet. The main component of Alka-Seltzer is sodium bicarbonate, used to neutralize excess stomach acid during illness through the following reaction that generates CO2:…

    • 1228 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Subliming the mixture seemed to be the most practical solution due to the information given in lab by the instructor of the calcium carbonate and the naphthalene. Their properties of solubility with water or ethanol was either slightly soluble or insoluble, making extraction by solubility a definite no with using this experiment to separate the mixture.…

    • 753 Words
    • 4 Pages
    Good Essays