Preview

Alcohols and Phenols

Powerful Essays
Open Document
Open Document
1559 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Alcohols and Phenols
Properties of Alcohols and Phenols Experiment #3
Objectives: To observe the solubility of alcohols relative to their chemical structure, to perform chemical tests to distinguish primary, secondary and tertiary alcohols, and a color test for phenol. Introduction The general formula of an alcohol is ROH in which the R is an aliphatic hydrocarbon group. Alcohols may be looked upon as derivatives of water, HOH. One hydrogen of water is substituted by an alkyl group, R. Like water, alcohols show hydrogen bonding. As the chain of the R group increases the hydrocarbon character of the compound overshadows the polar character of the OH group. Consequently, the solubility and boiling point of an alcohol are affected by the length of the carbon chain and the shape of the molecule. The short chain alcohols are soluble in water, whereas the longer chain alcohols are insoluble in water. In general a molecule which is more compact (i.e., more branched) will be more soluble in water and will have a lower boiling point than the straight chain isomer. Phenols are aromatic alcohols, in which R is an aromatic ring. This experiment will demonstrate some of the properties of alcohols and phenols. Although alkyl alcohols have an -OH group, they do not ionize in water, whereas phenols ionize like acids (donating a proton to water). The -OH group of alkyl alcohols can be positioned on different carbon atoms of the carbon chain and are classified as primary (1°), secondary (2°), or tertiary (3°) alcohols depending on whether the -OH group is attached to a carbon with 1, 2 or 3 other carbon atoms attached to it. These different alcohols react differently with Lucas reagent and with Bordwell-Wellman reagent; hence these reagents can be used for identifying the class of alcohol. The relative acidity of phenols can be used to characterize this class of alcohols relative to the alkyl alcohols. This property will be exploited in the identification of phenol.

Materials Test tubes,

You May Also Find These Documents Helpful

  • Good Essays

    The central goal of this experiment is to depict the intermolecular forces of four different properties of solubility, evaporation, viscosity, and boiling point.…

    • 768 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    The purpose of this experiment was to demonstrate the application of Zaitzev’s rule, the Evelyn Effect and the occurrence of an E1 mechanism in an alcohol dehydration reaction. Specifically this experiment involved the dehydration of 2-methylcylcohexanol by heating this alcohol in the presence of phosphoric acid and then to based on the results of the gas chromatography of the product to determine whether the alcohol exhibited the Evelyn Effect. The reaction taking place for both the Cis and the Trans isomers for Methylcyclohexanol are as follows:…

    • 969 Words
    • 4 Pages
    Powerful Essays
  • Better Essays

    The purpose of this experiment was to synthesize the Grignard reagent, phenyl magnesium bromide, and then use the manufactured Grignard reagent to synthesize the alcohol, triphenylmethanol, by reacting with benzophenone and protonation by H3O+. The triphenylmethanol was purified by recrystallization. The melting point, Infrared Spectroscopy, 13C NMR, and 1H NMR were used to characterize and confirm the recrystallized substance was triphenylmethanol.…

    • 5143 Words
    • 21 Pages
    Better Essays
  • Good Essays

    Alcohols are classified as primary (1°), secondary (2°) or tertiary (3°), which refers to the carbon bearing the hydroxy group…

    • 1598 Words
    • 7 Pages
    Good Essays
  • Satisfactory Essays

    In this experiment two solutions were prepared for two kinetic runs. Solution #1 (50%ethanol 50% water) and Solution #2 (40% ethanol and 60% water) was added to another Erlenmeyer flask. Next, 0.10M of NaOH was filled up to the 0.00ml mark in two 50-ml burettes. Placing the flask containing solution 1 on the magnetic stirrer and clamp a burette containing 0.10M of NaOH above the flask. The two kinetic runs will be carried out one after another. A stir bar was placed into the flask containing solution #1 and 3-5 drops of phenolphthalein indicator solution to the reaction flask. To start the reaction, 4.91x10^-3 mol of alkyl halide to the stirring reaction mixture. The timer was started at the instant of this reaction. When enough HCl formed to neutralize the NaOH that was initially added, the pink color turned clear. The time was recorded.…

    • 936 Words
    • 4 Pages
    Satisfactory Essays
  • Powerful Essays

    The basic purpose of this experiment is to carry out the dehydration of an alcohol and isolate the reaction products by distillation. Gas Chromatography will be utilized to analyze the reaction mixture.…

    • 896 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    Oxidation was found for primary alcohol. When 6 drops of potassium dichromate and 1 drop of concentrated sulfuric acid were added to 1-pentanol, the color of 1-pentaol turned into dark green. In second experiment, precipitation was found when 6 drops of 2,4-dinitrophenylhydrazine were added to both 5 drops of benzaldehyde and 5 drops of acetophenone. Based on these data, it is possible to find alcohol by oxidation and aldehyde by observing precipitation…

    • 558 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Solubility Lab

    • 653 Words
    • 3 Pages

    Part B. Solubility of Different Alcohols. Use your observations to complete the following table, rating each system as soluble, insoluble, or partially soluble. Alcohol Methyl alcohol Water Hexane…

    • 653 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Experimental: Sodium metal was patted dry to remove any oil and was cat into small pieces. A dry 100cm3 round bottom flask was placed on a cork ring, on a balance and tarred sodium metal (0.6g) was placed into the flask. The flask was then attached to the dry reflux condenser and industrial methylated spirits (IMS, 15cm3) was added. Once all of the sodium has dissolved the solution was cooled to room temperature and the para-acetamidophenol (3.5g) was added. Ethyl iodine (3.0cm3) was slowly introduced to the mixture through the top of the condenser and the resulting in the mixture was boiled at reflux temperature for 20 minutes and was placed in a rotary evaporator to remove any excess solvent. Distilled water (40cm3) was added to the mixture and the flask was placed in ice until crystals were formed. The crude product was filtered using vacuum filtration the filtrates were washed with very little cold water and were left dry as much as possible.…

    • 652 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Alcohols, Halogenoalkanes

    • 1510 Words
    • 7 Pages

    7. Which of the halogenoalkanes in the previous question will react fastest with aqueous silver nitrate? Give a reason for your answer.…

    • 1510 Words
    • 7 Pages
    Good Essays
  • Good Essays

    The Molar Heat of Combustion of a substance is the heat liberated when 1 mole of the substance undergoes complete combustion with oxygen at standard atmospheric pressure, with the final products being carbon dioxide gas and liquid water. (Ref. “Conquering Chemistry, Roland Smith, 2005”)…

    • 2051 Words
    • 9 Pages
    Good Essays
  • Powerful Essays

    Competitive Nucleophiles

    • 628 Words
    • 3 Pages

    The purpose of this experiment was to compare the nucleophilicities of chloride and bromide ions toward the n-butyl and t-pentyl alcohols. We were able to analyze this by using refractometry to measure the amounts of alkyl chloride and alkyl bromide in each reaction.…

    • 628 Words
    • 3 Pages
    Powerful Essays
  • Good Essays

    In an E1 reaction, where E stands for elimination and 1 stands for unimolecular. The breaking of the C-LV bond is completed before any reaction occurs between the base to lose a hydrogen and form the carbon-carbon double bond [1]. When the more substituted alkene is the dominant product, the reaction follows Zaitsev's rule. Zaitsev's rule states that the major product of a β-elimination reaction is the most stable alkene [1].Acid-Catalyzed Dehydration is the elimination of a molecule of water from adjacent carbon atoms. An alcohol can be converted to an alkene by dehydration, which is often brought on by heating the alcohol with either 85% phosphoric acid or concentrated sulfuric acid [1]. The objective of this experiment is to dehydrate 3-methyl-3-pentanol to obtain the product mixture of isomeric alkenes 3-methyl-2pentene and 2-ethyl-1-butene. Then use the gas chromatography to separate the product mixture and analyze the composition [2].…

    • 1090 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Ochem Lab

    • 394 Words
    • 2 Pages

    In this experiment, the secondary alcohol is selected over the primary alcohol. In many cases the primary alcohol can be oxidized all the way to a carboxylic acid. In order to achieve selectivity, sodium hypochlorite is used. It is reacted with acetic acid to form HOCl.…

    • 394 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Alcohol and Ir Spectrum

    • 1927 Words
    • 8 Pages

    Abstract: In this experiment the conversion of alcohols to alkyl halides are investigated through reflux and simple distillation. These are common procedures used to separate substances. After the reflux and distillation is complete 13C NMR and IR spectrum is used to identify the product or products for each reaction: 1a, 1b, and 2. Every individual in the group was assigned either 1a (1-propanol) or 1b (2-pentanol), and 2 (1,4-dimethyl-3-pentanol). The purpose of this experiment was to understand and become familiar with the reaction mechanisms and be able to observe and compare the product or products for each of the reactions using 13C NMR and IR. The reaction of 1-propanol (1a) with NaBr/H2SO4 was 1-bromopropane, the reaction of 2-pentanol (1b) with NaBr/H2SO4 was 2-bromopentane and the reaction of 2,4-dimethyl-3-pentanol with HCl/ZnCl2 was 2,4-dimethyl-3-chloropentane.…

    • 1927 Words
    • 8 Pages
    Better Essays

Related Topics