Preview

Acid And Bases Lab Report

Satisfactory Essays
Open Document
Open Document
330 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Acid And Bases Lab Report
Results: For the solutions acid and bases lab the results my group received are as followed. Procedure 5.1 were we had to measure the ph of the following substances
Vinegar 4
Apple Juice 4
Black coffee 5
Baking Soda + Sprite 8
0.01mM HCl 4
0.1mM HCl 3
Distilled water 4.5
Tap Water 5

Procedure 5.2
-Test the ability of buffers

Before Buffer After Buffer
Water 4 Water 4
0.1M phosphate buffer 6.5 0.1M Phosphate buffer 6.9
0.1M NaCl 4 0.1M NaCl 4.8

Procedure 5.3
-Test effectiveness of antacids
Alka seltzer 115
Antacids 90 (AVRG)
Tums 80 (AVRG)

Discussion: for procedure 5.1 all that was required was to use the ph strips and test all the liquids. there was various ways errors could occur in just this

You May Also Find These Documents Helpful

  • Good Essays

    Ap Chemistry Lab Report

    • 678 Words
    • 3 Pages

    A 125 mL flask was obtained. The square of aluminum was fashioned over the flask by laying the foil over the mouth and folding the sides down. A pin was then obtained and was used to poke a tiny hole in the center of the aluminum cap.…

    • 678 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Exercise 10: Acid-Base Balance: Activity 2: Rebreathing Lab Report Pre-lab Quiz Results You scored 100% by answering 4 out of 4 questions correctly. 1. In cases of acidosis, the pH of the blood is You correctly answered: c. less than 7.35. 2. Carbon dioxide and water form You correctly answered: a. carbonic acid (a weak acid). 3. Which of the following is true of respiratory acidosis? You correctly answered: c. The amount of carbon dioxide in the blood is greater than normal. 4. Rebreathing You correctly answered: b. is exemplified by breathing into a paper bag.…

    • 387 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Potential Causes: COPD plus DKA or renal failure, any combination of things that cause each one…

    • 457 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    ka lab report

    • 692 Words
    • 3 Pages

    We will be using the LoggerPro and LabPro in order to help us determine our data. The purpose of this experiment is to follow the changes of pH during the titration of an acid and a base in order to determine the of the weak acid, . is a constant for a given acid at a given temperature. In this experiment we determined the Ka using two different methods: 1) the measurement of the pH of a solution containing a known concentration of a weak acid, and 2) measurement of the pH at the half-neutralization point in the titration of a weak acid and a strong base.…

    • 692 Words
    • 3 Pages
    Good Essays
  • Better Essays

    chem lab report

    • 1425 Words
    • 7 Pages

    2. To determine the densities of water, an unknown liquid, a rubber stopper, and an unknown rectangular solid.…

    • 1425 Words
    • 7 Pages
    Better Essays
  • Satisfactory Essays

    Acid & Base Lab

    • 607 Words
    • 3 Pages

    In the Acid and Base Lab, we had to test the pH value of two unknown substances to determine if they were acids or bases. First, we had to test the Unknowns with litmus paper. Litmus is a dye made from a lichen-algae/fungus mixture. For the Unknown I, the litmus paper turned red which meant that it was an acid. For the Unknown II, the litmus paper turned blue which meant that it was a base. Next, we had to test the Unknowns with pH indicator paper. We then had to match the pH paper to the pH color chart. The pH value was 1 for the Unknown I. The pH value was 11 for the Unknown II. Then, we had to add phenolphthalein solution to the Unknowns. When we added it to the Unknown I, it turned cloudy and looked kind of milky. It didn't turn pink because it was an acid. When we added it to the Unknown II, it turned bright pink. This indicated that it was a base. Next, we had to add a piece of magnesium ribbon to the Unknowns. When we added it to the Unknown I, a hydrogen gas and salt was produced. It was an exothermic reaction because heat was given off. When we added it to the Unknown II, nothing happened. Then, we had to add baking soda to the Unknowns. Unknown I fizzed up to the top of the test tube and then went back down. Salt and water were produced. Unknown II turned light pink. There was no reaction because it was a base.…

    • 607 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    lab report chemistry

    • 607 Words
    • 5 Pages

    When holding test tube inverted over heptane flame, condensation formed against top walls of the test tube. When the burning splint was added the walls of the test tube became less foggy from the condensation formed from the heptane flame.…

    • 607 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Lab 5 Acid Base Chemistry 2

    • 1240 Words
    • 17 Pages

    No credit will be given for this lab report if the Data section is not completely filled out and if the required photographs are not received. At least one photograph must show the student’s face.…

    • 1240 Words
    • 17 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Lab 1 on Ph Levels

    • 521 Words
    • 3 Pages

    Section 1: You will be testing 4 known solutions for pH levels using a standard wide-range indicator. Based off of the results obtained in the lab room, fill in the following table:…

    • 521 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Investigations of Buffers

    • 991 Words
    • 4 Pages

    The purpose of this experiment was to get an understanding as to how to properly prepare chemical buffers. Also part of this experiment was to gauge the effectiveness of the buffers by measuring their pH levels in various titration solutions, using a pH meter.…

    • 991 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Buffer Lab

    • 405 Words
    • 2 Pages

    4. (Q2/Q3) compare to the changes in tap water with both the acid and base because its like putting 30 drops in water the first time when you actually put in just 5 drops. The pH changes drastically.…

    • 405 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    The purpose of the current experiment was to determine the pH of various hydrochloric acid and acetic acid solutions, to determine the pH of various salt solutions, to prepare a buffer solution, and determine the effects of adding a strong acid and strong base to the buffer solution versus adding a strong acid and strong base to water. The measured pHs for the hydrochloric acid solutions were 1.6, 2.2, 2.9, and 3.8. The measured pHs for the acetic acid solutions were 2.9, 3.9, 4.2, and 4.4. The pHs measured for the salts were 4.3 for sodium chloride, 7.3 for sodium acetate, 8.9 for sodium bicarbonate, 10.8 for sodium carbonate, 7.9 for ammonium chloride, and 6.9 for ammonium acetate. The pH for the buffer solution and the strong acid was 3.9 and the pH for the buffer solution and the strong base was 11.6. The pH of water with the strong acid added was 3.44 and the pH of water with the strong base added was 13.4…

    • 1669 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    lab and ph

    • 543 Words
    • 3 Pages

    For my results of pH Lab, I was not able to record the final data for the unknown solutions so I just decided to jot down random numbers. Those were the results according to the standards table I organized in my Lab Notebook.…

    • 543 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1. Identify the acid/base and their conjugate base/acid, and which definition you use to determine(Bronsted,…

    • 526 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    Chem Lab Report

    • 1164 Words
    • 5 Pages

    .2400 grams of the unknown compound. This is done in duplicate and purple-tinted precipitates are placed in Gooch crucibles. The precipitates are suction dried using ethyl alcohol then acetone to…

    • 1164 Words
    • 5 Pages
    Powerful Essays